The American Association for Thoracic Surgery (AATS) 2022 Expert Consensus Document: The use of mechanical circulatory support in lung transplantation

ObjectiveThe use of mechanical circulatory support (MCS) in lung transplantation has been steadily increasing over the prior decade, with evolving strategies for incorporating support in the preoperative, intraoperative, and postoperative settings. There is significant practice variability in the use of these techniques, however, and relatively limited data to help establish institutional protocols. The objective of the AATS Clinical Practice Standards Committee (CPSC) expert panel was to review the existing literature and establish recommendations about the use of MCS before, during, and after lung transplantation.MethodsThe AATS CPSC assembled an expert panel of 16 lung transplantation physicians who developed a consensus document of recommendations. The panel was broken into subgroups focused on preoperative, intraoperative, and postoperative support, and each subgroup performed a focused literature review. These subgroups formulated recommendation statements for each subtopic, which were evaluated by the entire group. The statements were then developed via discussion among the panel and refined until consensus was achieved on each statement.ResultsThe expert panel achieved consensus on 36 recommendations for how and when to use MCS in lung transplantation. These recommendations included the use of veno-venous extracorporeal membrane oxygenation (ECMO) as a bridging strategy in the preoperative setting, a preference for central veno-arterial ECMO over traditional cardiopulmonary bypass during the transplantation procedure, and the benefit of supporting selected patients with MCS postoperatively.ConclusionsAchieving optimal results in lung transplantation requires the use of a wide range of strategies. MCS provides an important mechanism for helping these critically ill patients through the peritransplantation period. Despite the complex nature of the decision making process in the treatment of these patients, the expert panel was able to achieve consensus on 36 recommendations. These recommendations should provide guidance for professionals involved in the care of end-stage lung disease patients considered for transplantation.     

Use of the Rocket Technique after Failure of the Direct Aspiration First-Pass Technique in Acute Stroke Thrombectomy

The technical feasibility of the rocket technique was evaluated for patients treated for stroke where the direct aspiration first-pass technique (ADAPT) failed to reach the occlusion site. This single-center retrospective study included data on consecutive patients with a large vessel occlusion of the anterior circulation who underwent mechanical thrombectomy. Of 138 patients, 100 met the inclusion criteria. In 84 patients, a large 0.072-inch inner lumen aspiration catheter was able to reach the occlusion site when deployed with a coaxial microcatheter. In 16 patients, this technique failed, and the microcatheter was replaced with a compliant balloon inflated at the extremity of the aspiration catheter (rocket technique). In 15 of these 16 patients, the rocket technique brought the catheter into contact with the thrombus. In conclusion, when deployment of the ADAPT with a coaxial microcatheter fails to reach the clot site, the rocket technique can safely advance the aspiration catheter to the clot.     

短时程脊髓电刺激治疗爆发痛合并触诱发痛的急性期带状疱疹的临床研究

目的探讨短时程脊髓电刺激(temporary spinal cord stimulation, tSCS)治疗爆发痛合并触诱发痛的急性期带状疱疹的临床疗效。方法回顾性地分析同济大学附属第十人民医院疼痛科2020年1月—2020年12月收治的52例接受tSCS治疗的爆发痛合并触诱发痛的急性期带状疱疹患者的临床资料，评估在治疗前、治疗后3d、7d、14d、3个月、6个月的总体疼痛情况(numerical rating scale, NRS)评分、(simple McGill scores, McGill)评分、爆发痛情况(发生率、NRS评分、次数以及持续时间)、触诱发痛情况(发生率、分级)、术后不良反应等；评估在治疗前、治疗后7d、3个月、6个月的睡眠时长、睡眠中醒来次数、疼痛障碍指数(pain disorder index, PDI)、功能状态评分(Karnofsky score, KPS)、抑郁症筛查量表(patient health questionnaire depression module scale, PHQ-9)和焦虑症筛查量表(generalized anxiety disorder-7 scale, GAD-7)等。结果与治疗前相比，治疗后3d、7d、14d、3个月、6个月的总体疼痛NRS评分、总体疼痛MCGILL评分、静息痛NRS评分明显降低(均P<0.001)；与治疗前相比，治疗后3d、7d、14d、3个月、6个月的的爆发痛NRS评分明显降低(均P<0.05)，治疗后14d、3个月、6个月时的爆发痛次数以及持续时间都明显降低(均P<0.05)；与治疗前比较，患者治疗后7d、14d、3个月、6个月时的触诱发痛的分级都明显降低，差异均有统计学意义(均P<0.05)；与治疗前相比，治疗后14d、3个月、6个月的PDI评分明显降低(P<0.05)；与治疗前相比，治疗后14d、3个月、6个月的PHQ-9评分和GAD-7评分都明显减少(P<0.05)，与术前的药物使用情况相比，治疗后各镇痛药使用人数普遍呈下降趋势；术中及整个随访期间未观察到严重不良事件。结论短时程脊髓电刺激对爆发痛合并触诱发痛的急性期带状疱疹具有较好的临床疗效。     

Mechanical Hemolysis Complicating Transcatheter Interventions for Valvular Heart Disease: JACC State-of-the-Art Review

Mechanical intravascular hemolysis is frequently observed following procedures on heart valves and uncommonly observed in native valvular disease. In most cases, its severity is mild. Nevertheless, it can be clinically significant and even life threatening, requiring multiple blood transfusions and renal replacement therapy. This paper reviews the current knowledge on mechanical intravascular hemolysis in valvular disease, before and after correction, focusing on pathophysiology, approach to diagnosis, and impact of other hematological conditions on the resultant anemia. The importance of a multidisciplinary management is underscored. Laboratory data are provided about subclinical hemolysis that is commonly observed following the implantation of surgical and transcatheter valve prostheses and devices. Finally, clinical scenarios are reviewed and current medical and surgical treatments are discussed, including alternative options for inoperable patients.     

Selective Laser Melting of Al-Based Matrix Composites with Al2O3 Reinforcement: Features and Advantages

Aluminum matrix composites (AMC) are of great interest and importance as high-performance materials with enhanced mechanical properties. Al₂O₃ is a commonly used reinforcement in AMCs fabricated by means of various technological methods, including casting and sintering. Selective laser melting (SLM) is a suitable modern method of the fabrication of net-shape fully dense parts from AMC with alumina. The main results, achievements, and difficulties of SLM applied to AMCs with alumina are discussed in this review and compared with conventional methods. It was shown that the initial powder preparation, namely the particle size distribution, sphericity, and thorough mixing, affected the final microstructure and properties of SLMed materials drastically. The distribution of reinforcing particles tends to consolidate the near-melting pool-edges process because of pushing by the liquid–solid interface during the solidification process that is a common problem of various fabrication methods. The achievement of an homogeneous distribution was shown to be possible through both the thorough mixing of the initial powders and the precise optimization of SLM parameters. The strength of the AMCs fabricated by the SLM method was relatively low compared with materials produced by conventional methods, while for superior relative densities of more than 99%, hardness and tribological properties were obtained, making SLM a promising method for the Al-based matrix composites with Al₂O₃.     

The impact of foot shock-induced stress on pain-related behavior associated with burn injury

Acute pain is prevalent following burn injury and can often transition to chronic pain. Prolonged acute pain is an important risk factor for chronic pain and there is little preclinical research to address this problem. Using a mouse model of second-degree burn, we investigated whether pre-existing stress influences pain(sensitivity) after a burn injury. We introduced a contribution of stress in two different ways: (1) the use of foot-shock as a pre-injury stressor or (2) the use of A/J mice to represent higher pre-existing stress compared to C57Bl/6 mice. C57Bl/6 and A/J mice were exposed to repeated mild foot shock to induce stress for 10 continuous days and mice underwent either burn injury or sham burn injury of the plantar surface of the right hind paw. Assessments of mechanical and thermal sensitivities of the injured and uninjured paw were conducted during the shock protocol and at intervals up to 82-day post-burn injury. In both strains of mice that underwent burn injury, thermal hypersensitivity and mechanical allodynia appeared rapidly in the ipsilateral paw. Mice that were stressed took much longer to recover their hind paw mechanical thresholds to baseline compared to non-stressed mice in both burn and non-burn groups. Analysis of the two mouse strains revealed that the recovery of mechanical thresholds in A/J mice which display higher levels of baseline anxiety was shorter than C57Bl/6 mice. No differences were observed regarding thermal sensitivities between strains. Our results support the view that stress exposure prior to burn injury affects mechanical and thermal thresholds and may be relevant to as a risk factor for the transition from acute to chronic pain. Finally, genetic differences may play a key role in modality-specific recovery following burn injury.     

Esofagogastrostomía triangular mecánica: aspectos técnicos y resultados iniciales

IntroductionEsophageal cancer represents the eighth neoplasm worldwide. The therapeutic approach is interdisciplinary, with surgery being the most effective option. Several techniques have been proposed to perform esophagogastrostomy after esophagectomy, among them mechanical triangular esophagogastrostomy, with a little experience published in the Western literature on the latter. The objective of this study is to describe the technical aspects and initial results of triangular esophagogastrostomy anastomosis.MethodsA retrospective review of the patients who underwent esophagectomy according to the McKeown technique was performed, those in which triangular esophagogastrostomy anastomosis was implemented, between October 2017 and March 2020 in our hospital.ResultsA total of 14 patients were included, with a mean age of 63 years. The mean operative time was 436 minutes (360-581), being diagnosed of anastomotic leak 3 of the 14 patients (21.4%), as well as 3 patients presented anastomotic stenosis. The median stay was 20 days, without any death in the series.ConclusionsMultiple publications suggest the superiority in terms of anastomotic leak and anastomotic stenosis of the mechanical triangular anastomosis, which was also observed in our series, in which despite the small sample, a rapid improvement was observed in the indicators after the first cases. Therefore, this type of anastomosis may be a safe option for performing esophagogastric anastomosis after esophagectomy, being necessary more definitive conclusive studies.     

High-flow via a tracheostomy tube and speaking valve during weaning from mechanical ventilation and tracheostomy

Background

Weaning from mechanical ventilation and tracheostomy after prolonged intensive care consume enormous resources with optimal management not currently well described. Restoration of respiratory flow via the upper airway is essential and early cuff-deflation using a one-way valve (OWV) is recommended. However, extended OWV use may cause dry airways and thickened secretions which challenge the weaning process. High-flow therapy via the tracheostomy tube (HFT-T) humidifies inspired air and may be connected via an in-line OWV (HFT-T-OWV) alleviating these problems. We aim to provide clinical and experimental data on the safety of HFT-T-OWV along with a practical guide to facilitate clinical use during weaning from mechanical ventilation and tracheostomy.

Methods

Data on adverse events of HFT-T-OWV were retrieved from a quality register for patients treated at an intensive care rehabilitation center between 2019 and 2022. Benchtop experiments were performed to measure maximum pressures and pressure support generated by HFT-T-OWV at 25–60 L/min flow using two different HFT-T adapters (interfaces). In simulated airway obstruction using a standard OWV (not in-line) maximum pressures were measured with oxygen delivered via the side port at 1–3 L/min.

Results

Of 128 tracheostomized patients who underwent weaning attempts, 124 were treated with HFT-T-OWV. The therapy was well tolerated, and no adverse events related to the practice were detected. The main reason for not using HFT-T-OWV was partial upper airway obstruction using a OWV. Benchtop experiments demonstrated HFT-T-OWV maximum pressures <4 cmH₂O and pressure support 0–0.6 cmH₂O. In contrast, 1–3 L/min supplemental oxygen via a standard OWV caused pressures between 84 and 148 cmH₂O during simulated airway obstruction.

Conclusions

Current study clinical data and benchtop experiments indicate that HFT-T-OWV was well tolerated and appeared safe. Pressure support was low, but humidification may enable extended use of a OWV without dry airway mucosa and thickened secretions. Results suggest the treatment could offer advantages to standard OWV use, with or without supplementary oxygen, as well as to HFT-T without a OWV, for weaning from mechanical ventilation and tracheostomy. However, for definitive treatment recommendations, randomized clinical trials are needed.