胃减容术3种机械通气对患者氧合情况的比较

目的：探讨病态肥胖患者行腹腔镜胃减容术时，3种机械通气参数对患者氧合情况的影响。方法：选择行腹腔镜胃减容术的病态肥胖24例，按手术时间顺序分为3组，每组8例。A组：潮气量12ml／kg，呼吸频率10次／min；B组：潮气量20ml／kg，呼吸频率10次／min；C组：潮气量12ml／kg，呼吸频率20次／min。分别于气腹前（T1）、气腹后（T2）抽取动脉血测量pH、PO2、PCO2、Plat（平台压）、Peak（峰压）、AaDO2（肺泡-动脉氧分压差）。结果：气腹后B组Plat（33．2±1．8）cmH2O、Peak（36．3±1．6）cmH2O显著高于A组Plat（29．5±3．9）cmH2O（q=3．053，P〈0．05）、Peak（33．0±2．9）cmH2O（q：2．823，P〈0．05）和C组Plat（28．0±4，1）cmH2O（q：4．290，P〈0．05）、Peak（31．8±2．8）cmH2O（q：4．704，P〈0．05）。其他观察指标无统计学差异。结论：病态肥胖患者在腹腔镜下施行胃减容术时，加大潮气量20ml／kg或加快呼吸频率20次／min不能改善患者的氧合情况。     

坐位腰椎旋转手法时腰椎单元内在应力和位移的实时监测

目的:用三维有限元法,分析施行坐位腰椎旋转手法时退变腰椎单元的内在应力及位移分布的特点,以探讨手法的作用机制、安全性及其合理性。方法:使用正常L4,5腰椎CT片,以Mimics软件系统逐层重建,建立L4,5三维有限元模型。根据手法原理,将坐位腰椎旋转手法进行分解,把各项力学参数代入三维有限元模型进行计算分析。观察手法作用时腰椎间盘的位移和内在应力的变化。结果:最大的应力集中点分布于环椎体峡部、椎弓根、上位椎体小关节面的下端。椎间盘的应力集中分布于环前外侧部,右后外侧部应力大于左后外侧部。最大位移出现在上位椎体的上关节。左侧小关节面相对位移较大,左侧椎间孔变大;右侧椎小关节面间移位小,右侧椎间孔变小,椎间盘右后外侧部向后突出。结论:模拟坐位腰椎旋转手法时,向健侧旋转优于向患侧旋转。     

一种新型的声门外通气设备——喉导管

喉导管是一种新型的声门外通气设备.在气道的建立和维持上和喉罩相比有相似的优缺点.喉导管和喉罩总的插管成功率相近,一次插管成功率喉导管要远远高于喉罩.喉导管的气道封闭性更好.喉导管可用于四肢、泌尿、妇科和躯干体表手术以及困难气道的插管.在喉部空间狭小患者和颈髓损伤患者气道的建立上比喉罩更有优势,亦可用于心肺复苏时紧急气道的建立.     

Airway troubles related to the double-lumen endobronchial tube in thoracic surgery

Purpose Several case reports indicate critical respiratory complications in relation to the double-lumen endobronchial tube (DLT). A prospective survey for the airway problems in using the DLT is presented. Methods One hundred adult patients undergoing thoracotomy for lung cancer were investigated. Tube malposition and airway obstruction were searched using a fiber-optic scope. The endobronchial cuff was positioned just below the trachcal carina while the trachea was intubated with a DLT (Rüsch). The distances of displacement, from the tracheal carina to the bronchial cuff, were measured during anesthesia using an epidural catheter, which had marks every 5 mm. The distances for correcting the tube position were measured at both the bronchial cuff and the level of the teethPaO₂,PaCO₂ andSPO₂ were also measured. Results Malposition (displacement over 5 mm from the correct position) was found in 42 patients, and 40 of them were in a withdrawal direction, occurring at the postural change and during one-lung ventilation, especially during manipulation of the lung hilum. Correcting distances at the level of the teeth were 15.3–3-times longer than those at the bronchial cuff. Airway deformities and gradual withdrawal of the bronchial cuff were found in association with surgical manipulation. Obstruction occurred at the tips of the tracheal tube in four patients and the bronchial tube in six patients, and at the tip of both in two patients. Hypoxemia (PaO₂<60 mmHg) occurred in four patients and hypercapnea (PaCO₂>60 mm Hg) in two patients. Conclusion Most of the DLT obstructions were associated with withdrawal malposition. Great attention to DLT displacement and airway deformity is advised.     

Bicarbon valve - European multicenter clinical evaluation

Objective: Fifteen collaborating centers in eight countries present their pooled experience with the new Bicarbon™ bileaflet valve. Methods: Between 4/90 and 4/96, 1351 patients, 806 males and 545 females, aged 10 to 83, mean 58.4±12.4, underwent valve implantation. Operations: AVR, 726; MVR, 475; DVR, 150. Additional procedures: CABG, 211; TV repair, 64; other, 152. Results: Mortality: 67 early (seven valve related) and 56 late (40 valve related). Valve thrombosis: six obstructive, three non-obstructive; embolism: nine major cerebral, 37 other. Major bleeding: 29. Hemolysis: two clinically significant. Non-structural dysfunction: 24 paravalvular leaks, one leaflet interference. No structural failure! Endocarditis: 24. Reoperation 48: 22 non-structural dysfunctions, 14 endocarditis, seven thrombosis and embolism, five other. Estimated 5-year freedom from valve-related deaths is 97.2% for AVR and 92.4% for MVR; 4-year freedom from valve related deaths for DVR is 90.5%. Mean calculated NYHA improvement is 1.24. Conclusions: The Bicarbon mechanical prosthesis is well designed, durable, has good hemodynamic features and an acceptably low incidence of complications.     

橡胶活性官能团对增韧环氧树脂动态力学性能的影响

用动态扭摆法测试聚丙烯酸丁酯橡胶增韧环氧树脂的动态力学行为,研究在环氧树脂低固化度和高固化度时,橡胶活性官能团种类(环氧基官能团与羧基官能团)和数量(官能度)对其影响。研究体系中橡胶玻璃化转变温度(Tg)的移动大小,与橡胶和基体树脂健合程度之间的关系。     

Endoscopic sphincterotomy for common bile duct stones: Impact of recent technical advances

Technical improvements, such as mechanical lithotripsy, stenting or nasobiliary drainage, and wire-guided cannulation, have reduced the risk of complications in endoscopic sphincterotomy. To determine the extent of this reduction in risk, we assessed the medical records of 1352 patients with common bile duct stones in whom the procedure was conducted. Complications examined were: acute cholangitis and pancreatitis. Stone clearance was achieved in 1256 patients (92.8%), with an overall morbidity rate of 7.7% and a mortality rate of 0.15%. One hundred and forty-two patients had stones with a diameter greater than 20mm; 97 of these patients did not undergo lithotripsy. Cholangitis occurred in 10 of these 97 patients (10.3%), whereas, in the 45 patients who underwent lithotripsy, there were no cases of cholangitis (P=0.02). Stone removal was not immediately accomplished or attempted in 396 patients. In 82 of these patients in whom a stent or a nasobiliary drain was placed in the common bile duct, the incidence of cholangitis was 1.2%, significantly less (P=0.045) than the incidence of 6.4% in the other 314 patients given no stenting or nasobiliary drain. To overcome difficult cannulation, precut sphincterotomy was conducted in 134 patients and wireguided sphincterotomy, a recently introduced procedure, was conducted in 55 patients. When the precutting technique was used, the incidence of acute pancreatitis was significantly higher (8/134; 6.0%) than that in the patients in whom the standard procedure was conducted, i.e., neither the precut technique nor wire-guided ES was used (23/1218; 1.9%) (P=0.008). There were no cases of pancreatitis in the 55 patients in whom wire-guided sphincterotomy was performed, although the difference was not statistically significant because of the small number of patients (P=0.06). Based on these findings, we conclude that improved technologies have led to a significant reduction of complications in endoscopic sphincterotomy.     

The Extensometer—use in spontaneously ventilating awake volunteers

The extensometer is a new device with potential in the field of respiratory pattern analysis. This paper describes the physical principles upon which the extensometer depends and also assesses its performance as a noninvasive respiratory monitor in respect of its ability to measure tidal volume and to determine obstructive breathing patterns in awake volunteers in the supine position over a limited time period. Further developments of the device are outlined and the current status of torso transducers in anaesthesia and intensive care are discussed.     

Personal history,training, and worksite as predictors of back pain of nurses

Back pain among nurses is a common problem. Prior studies of this problem have been based on cross-sectional or retrospective data. This 18-month prospective study involving nurses newly graduated from nursing school investigated personal, worksite, and training factors associated with future risk of back pain. Each nurse underwent a preliminary interview and periodic follow-ups to identify those with back injuries. Contingency tables and logistic regression analyses demonstrated that prior significant back pain episodes (evidenced by previous job changes because of back pain, frequent medication use, etc.) were associated with increased future risk. Training at nursing school or on the job did not have a protective effect. This pilot study therefore suggests factors useful in placement and counseling of new nurses and indicates the need for further implementation of mechanical lift assist device use. © 1994 Wiley-Liss, Inc.     

Improved anchorage in osteoporotic vertebrae with new implant designs.

The goal of our study was to evaluate two newly developed implant designs and their behavior in terms of subsidence in lumbar vertebral bodies under cyclic loading. The new implants were evaluated in two different configurations (two small prototypes vs. one large prototype with similar load-bearing area) in comparison to a conventional screw-based implant (MACS TL). A pool of 13 spines with a total of 65 vertebrae was used to establish five testing groups of similar bone mineral density (BMD) distribution with eight lumbar vertebrae each. In additional to BMD assessment via dual-energy X-ray absorptiometry, cancellous BMD and structural parameters were determined using a new generation in vivo 3D-pQCT. The specimens were loaded sinusoidally in force control at 1 Hz for 1000 cycles at three load levels (100, 200, and 400 N). A survival analysis using the number of cycles until failure (Cox regression with covariates) was applied to reveal differences between implant groups. All new prototype configurations except the large cylinder survived significantly longer than the control group. The number of cycles until failure was significantly correlated with the structural parameter Tb.Sp. and similarly with the cancellous BMD for three of five implants. In both large prototypes the cycle number until failure significantly correlated with the preoperative distance to the upper endplates. Although the direct relationship between bone structure or density and mechanical breakage behavior cannot be conclusively proven, all the prototypes adapted for poor bone structure performed better than the comparable conventional implant.