Pharmacodynamic comparison of two formulations of Acarbose 100-mg tablets

What is known and Objective: Acarbose, an α‐glycosidase inhibitor, is used to treat diabetic patients. Pharmacokinetic evaluation of acarbose is difficult because <2% is absorbed systemically. The current investigation evaluated the bioequivalence of two formulations of acarbose through pharmacodynamic comparison. Methods: This investigation consisted of a pilot study and a main study. The pilot study had an open, single‐dose, single‐sequence design. Subjects received placebo and then two tablets of reference formulation (Glucobay^® 100 mg tablet; Bayer Healthcare) on two consecutive days with sucrose. The main study was an open, randomized, two‐period, two‐sequence crossover study. Subjects randomly received placebo and two tablets of either test formulation (generic acarbose 100‐mg tablet) or reference formulation with sucrose on two consecutive days in the first period. In the second period, placebo and alternative formulation were administered. Serial blood samples for pharmacodynamic assessment were taken after each administration. The maximum serum glucose concentration (G_max) and the area under the serum glucose concentration–time profile (AUC_gluc) were determined and compared. Results and Discussion: Five subjects completed the pilot study. The AUC_gluc from dosing until 1 h post‐dose (AUC_{gluc,1 h}) was significantly different between the placebo and acarbose. A total of 33 subjects completed the main study. The mean differences in G_max (ΔG_max) and AUC_{gluc,1 h} (ΔAUC_{gluc,1 h}) for the reference formulation compared with placebo were 22·0 ± 18·3 mg/dL and 928·2 ± 756·0 mg min/dL, respectively. The corresponding values for the test formulation were 23·3 ± 21·2 mg/dL and 923·0 ± 991·4 0 mg min/dL, respectively. The geometric mean ratios (GMRs) of the test formulation to the reference formulation for ΔG_max and ΔAUC_{gluc,1 h} were 1·06 and 1·00, respectively, and the 90% confidence intervals (CIs) corresponding values were 0·79–1·39 and 0·64–1·36, respectively. What is new and Conclusion: The 90% CIs of GMRs for the pharmacodynamic parameters chosen for bioequivalence evaluation of two formulations of acarbose did not meet the commonly accepted regulatory criteria for bioequivalence (0·80–1·25).