The effect of temperature and ionic solutes on the fluoride release and recharge of glass-ionomer cements

ObjectiveTo determine the effect of storage temperature and the presence of sodium chloride in solution on the fluoride uptake and release of glass-ionomer cements.MethodsSeveral commercial brands were used, and stored at either room temperature (21–23 °C) or 37 °C, in KF solution at a concentration of 1000 ppm F^? with and without 0.9% NaCl present. Fluoride levels in the storage solutions after 24 h were measured using a fluoride-ion selective electrode. Specimens were then stored in water, and fluoride release after 24 h was determined. Studies were also carried out to determine chloride levels when specimens were stored in 0.9% NaCl, with or without 1000 ppm fluoride, again using an ion selective electrode.ResultsAll glass-ionomer specimens took up fluoride, and most of the fluoride was retained over the next 24 h when the specimens were stored in water. There was a slight variation in the amount of fluoride taken up with storage temperature and with the presence of sodium chloride. All specimens also took up chloride, with greater uptake at higher temperatures, but little or no effect when KF was also present in solution.SignificanceThe substantial retention of fluoride after 24 h in deionised water confirms previous findings and suggests that an insoluble species, possibly SrF₂, forms in situ. Chloride uptake has not been reported previously, and its significance requires further investigation. Fluoride and chloride uptake were apparently independent of each other, which suggests that the ions are taken up at different sites in the cement. This may relate to differences in the respective sizes and hydration states of F^? and Cl^? ions.