Contact stresses with an unresurfaced patella in total knee arthroplasty: the effect of femoral component design

Compressive contact stresses between the patella and the anterior femur were measured with a digital electronic sensor before and after total knee arthroplasty (TKA) in 10 cadaver knee specimens. Contact stresses were measured first in normal knees, then after TKA with the Insall-Burstein Total Condylar, Miller Galante II, Ortholoc II, Porous Coated Anatomic, and Profix knee prostheses implanted without resurfacing the patella. The Insall-Burstein, Miller-Galante II, and Ortholoc II prostheses had significantly higher contact stresses than the normal knee throughout the flexion arc. The Porous Coated Anatomic, which has a smooth patellar groove, maintained contact area as in the normal knee and did not have significantly higher contact stresses at flexion angles <90 degrees. At flexion angles > or =105 degrees, patellofemoral contact occurred in two small areas as the patella encountered the intercondylar notch in all components except the Profix. The Profix maintained full contact and low compressive stresses throughout the full flexion arc because of its posteriorly extended patellar groove. Design features of the patellofemoral portion of TKA components are important factors that affect contact stresses in the patellofemoral joint. These features likely will affect the clinical results of TKA with an unresurfaced patella.