The preparation and characterization of fine dusts carried out in the Clinica del Lavoro di Milano in support of experimental studies

This paper aims to illustrate the conditions selected at the Clinica del Lavoro of the University of Milan to prepare and analyze a large number of fine dust samples produced over a period of about 50 years, that were initially used for studies within the Clinic performed in its own facilities, and since 1956 were sent to other Italian and overseas laboratories (Luxembourg, UK, Germany, Norway, Sweden, South Korea, USA). The total quantity of material distributed (with maximum size 7-10 microns) was about 2 kg and consisted of the following mineral and artificial compounds: quartz, HF-treated quartz, tridymite, HF-treated tridymite, cristobalite, chromite, anthracite, quartz sand for foundry moulds, sand from the Lybian desert, vitreous silica, pumice, cement, as well small quantities of metallic oxides, organic resins, chrysotile, crocidolite, fibres (vitreous, cotton and polyamidic). About half of the entire quantity of dusts produced consisted of partially HF-treated tridymite. Initially, research on the etiology of silicosis used quartz dust samples, simply sieved or ventilated (consisting of classes finer than 0.04 mm, containing a 15-20% respirable fraction). From 1956 to 1960 the dusts were produced by manual grinding in an agate mortar, below about 10 microns, starting from quartz from Quincinetto (near Ivrea, Province of Turin), containing about 99.5% quartz: particle size and composition were checked using an optical-petrographic technique, with identification of the free and total silica content. Subsequently, the dusts used for biological research were obtained by grinding coarse material with a cast iron pestle and planetary mills, agate and corundum jars. The grinding products were sized by means of centrifugal classification, using the selector developed by N. Zurlo, ensuring control of dust size both optically and by means of wet levigators and hydraulic classifiers (in cooperation with the Institute of Mines of Turin Polytechnic School). After 1990 pestles and rotating drum mills with autogenic grinding load were used for grinding: the size of the treated samples was reduced to 0.05 mm and an extremely fine fraction was extracted, smaller than 7-10 microns, which was used for pneumoconioses research. The characterization of the dust produced was in any case achieved by means of preliminary examination under the optical microscope (polarized light, sometimes supplemented with phase contrast), followed by quantitative analysis using chemical/petrographic, chemical diffraction or, more commonly, petrographic/diffraction techniques. Microscopic examination, if necessary supplemented with photo-micrography, was also used for particle size control, for numerical counting and subsequent reference to weight proportion. For all operational procedures the essential data on instruments and methods are reported. During studies on production, separation of fine dusts and their characterization, partly performed with support from the European Community (EEC/European Coal and Steel Commission), the following topics in particular were addressed: connections between particle size and free silica content in the measurable dust size fraction of the grinding products and in airborne dusts; characteristics of the dusts and risk indices in Italian iron and pyrite mines; possibility of abatement of the ultrafine classes of airborne dusts in pneumatically filled stopes by the addition of salts; comparison of the latest dust selectors used within the European Community; influence of the grinding methods on the results of fibrous and soft mineral measurement using X-ray diffraction analysis.