Influence of Welding Speeds on the Morphology,Mechanical Properties,and Microstructure of 2205 DSS Welded Joint by K-TIG Welding |
| |
| Authors: | Shuwan Cui Shuwen Pang Dangqing Pang Zhiqing Zhang |
| |
| Affiliation: | 1.School of Mechanical and Transportation Engineering, Guangxi University of Science and Technology, Liuzhou 545006, China; (S.P.); (Z.Z.);2.Guangxi Zhuang Autonomous Region Tobacco Company Liuzhou Tobacco Company, Liuzhou 545006, China; |
| |
| Abstract: | In this paper, 8.0 mm thickness 2205 duplex stainless steel (DSS) workpieces were welded with a keyhole tungsten inert gas (K-TIG) welding system under different welding speeds. After welding, the morphologies of the welds under different welding speed conditions were compared and analyzed. The microstructure, two-phase ratio of austenite/ferrite, and grain boundary characteristics of the welded joints were studied, and the microhardness and tensile properties of the welded joints were tested. The results show that the welding speed has a significant effect on the weld morphology, the two-phase ratio, grain boundary misorientation angle (GBMA), and mechanical properties of the welded joint. When the welding speed increased from 280 mm/min to 340 mm/min, the austenite content and the two-phase ratio in the weld metal zone (WMZ) decreased. However, the ferrite content in the WMZ increased. The proportion of the Σ3 coincident site lattice grain boundary (CSLGB) decreased as the welding speed increased, which has no significant effect on the tensile strength of welded joints. The microhardness of the WMZ and the tensile strength of the welded joint gradually increased when the welding speed was 280–340 mm/min. The 2205 DSS K-TIG welded joints have good plasticity. |
| |
| Keywords: | K-TIG welding weld morphology grain boundary characteristics microhardness tensile strength |
|
|
