Heteroepitaxy of Cerium Oxide Thin Films on Cu(111)

An important part of fundamental research in catalysis is based on theoretical and modeling foundations which are closely connected with studies of single-crystalline catalyst surfaces. These so-called model catalysts are often prepared in the form of epitaxial thin films, and characterized using advanced material characterization techniques. This concept provides the fundamental understanding and the knowledge base needed to tailor the design of new heterogeneous catalysts with improved catalytic properties. The present contribution is devoted to development of a model catalyst system of CeO₂ (ceria) on the Cu(111) substrate. We propose ways to experimentally characterize and control important parameters of the model catalyst—the coverage of the ceria layer, the influence of the Cu substrate, and the density of surface defects on ceria, particularly the density of step edges and the density and the ordering of the oxygen vacancies. The large spectrum of controlled parameters makes ceria on Cu(111) an interesting alternative to a more common model system ceria on Ru(0001) that has served numerous catalysis studies, mainly as a support for metal clusters.     

芳香族聚酯的相转移催化合成及其介晶态行为的研究——Ⅰ.聚酯的合成及介晶态行为

本文用相转移催化方法合成了四种新颖的芳香族聚酯。对所得聚合物进行了红外光谱、热重分析、偏光显微镜、示差扫描量热仪和解偏振光强等测试,以研究它们的结构和性能。它们的热分解温度都在330℃以上。其中的聚对,对′-1,4,7-三氧杂庚撐基二苯甲酸对苯二酚酯和聚对苯二甲酸对,对′-1,8-二氧杂辛撐基二苯酚酯,呈现向列型相转变,它们的清晰点分别为237℃和327℃。其它两种含双酚A或酚酞基团的聚酯则不存在液晶行为。对实验结果进行了讨论。     

裂解汽油在ZSM-5沸石上的芳构化

采用连续流动反应装置,考察了裂解汽油在HZSM-5与金属元素改性的HZSM-5上的芳构化反应,发现锌改性后提高了液体产物中芳烃的收率。为了克服裂解汽油中含硫含焦杂质的影响,提出了获取芳烃的有效工艺:蒸馏除焦-加氢预脱硫-氢气氛下芳构化反应-冷凝产物。用氨吸附的程序升温脱附法,将催化剂的酸性质与其催化芳构化作用进行关联,认为Zn改性后的HZSM-5催化剂具有较温和的酸中心,可能是其芳构化高活性与高选择性的原因。     

B90催化剂上丁烯氧化脱氢的反应动力学─一一种简便的建立化学动力学方程的方法

采用简便的建立化学反应动力学方程的方法，研究了Ｂ９０催化剂上丁烯氧化脱氢制丁二烯反应的动力学，即先在一较低温度下，用微分法拟合得到化学反应动力学方程中的浓度项，然后改变反应温度，求算不同温度下的反应速率常数。采用这个简便方法，只需较少的实验，即可求得该反应体系中的丁烯转化速率方程式。     

Ⅴ-Ti催化剂低氧催化氧化邻二甲苯制苯酐——Ⅱ.TiO_2晶体结构及助剂作用的影响

研究了V-Ti体系中TiO_2晶体结构与催化活性的联系,本系统中,当焙烧温度超过650℃,由于TiO_2由锐钛矿型转变为金红石型,使催化活性降低。助剂作用的ESCA、XRD、LRS研究表明,与通常V-Ti系催化剂不同,本催化剂由于助剂的作用,使V=O键减弱而利于活化;且随K助剂含量增加,V_2O_(4.33)晶胞的001面取向优化加强,更宜于催化活性的充分显示。     

Propylene Polymerization Behavior of Fluorinated Bis(phenoxy‐imine) Ti Complexes with an MgCl2‐Based Compound (MgCl2‐Supported Ti‐Based Catalysts)

Summary: Fluorinated bis(phenoxy‐imine)Ti complexes 1 – 3 combined with MgCl₂/i‐Bu_nAl(OR)_3−n (MgCl₂‐supported catalysts) were able to polymerize propylene in a living fashion at room temperature to provide slightly to highly syndiotactic poly(propylenes) (PPs) with extremely narrow distributions of molecular weight. These represent the first examples of MAO‐ and borate‐free group 4 metal‐based living catalysts. The supported complexes 2 and 3 formed PPs with higher syndiotacticity and T_m's than the corresponding homogeneous MAO‐activation systems (e.g., 3 : rr 97%, T_m 155 °C; MAO activation: rr 93%, T_m 152 °C). The measured T_m of 155 °C represents the highest known T_m for syndiotactic PPs synthesized at room temperature.

Polymerization of propylene to poly(propylene) with supported Ti‐based catalysts.     

Propene Polymerisation with rac‐[Me2Si(2‐Me‐4‐(α‐naphthyl)‐1‐Ind)2]ZrCl2 as a Highly Active Catalyst: Influence of Monomer Concentration,Polymerisation Temperature and a Heterogenising Support

Propene was polymerised at high temperatures (up to 90 °C) using rac‐[Me₂Si(2‐Me‐4‐(α‐naphthyl)‐1‐Ind)₂]ZrCl₂/MAO as the catalytic system. The increasing deactivation reaction rate of the catalyst for polymerisations above 60 °C was less for a silica supported catalyst compared with the homogeneous one. The isotacticity of polypropene decreases from 99 to 96%. Also the morphology changes with different temperatures.

Increasing of the thermal stability for the rac‐[Me₂Si(2‐Me‐4‐(α‐naphthyl)‐1‐Ind)₂]ZrCl₂/MAO/SiO₂ with respect of the rac‐[Me₂Si(2‐Me‐4‐(α‐naphthyl)‐1‐Ind)₂]ZrCl₂/MAO system.     

A301氨合成催化剂本征动力学

对低温,低压,高活性的A301氨合成催化剂的本征动力学进行了研究,实验采用等温积分反应器,在320－480度,6．0MPa-10.0MPa,5000h^-1--30000h^-1的条件下测定了反应器出口氨浓度,建立了Temkin形式的动力学方程,获得了反应的活化能及指前因子。     

丝光沸石催化剂上正己烷异构化反应机理

以轻质烷烃异构化中试放大用的丝光沸石催化剂为研究对象,运用“原位”红外反应技术和催化剂活性评价手段,并结合反应动力学参数计算,探讨了正已烷异构化反应机理。结果表明,可用五配位反应中间物种机理解释正碳离子的生成。用双分子六元环反应中间物机理能较好地解释正已烷在氢型丝光沸石(HM)上的异构化过程。对正已烷在Pd/HM上的反应过程也可用正碳离子机理结合双分子六元环中间物机理解释。     

聚合物负载的手性催化剂和手性试剂和合成及应用

近年来,用聚合物负载的手性催化剂和手性试剂完成的不对称合成反应主要集中在潜手性酮的不对称还原反应;烯烃的不对称双羟基化反应;烯烃的不对称环氧化反应;不对称Ｄｉｅｌｓ－Ａｌｄｅｒ反应和饱和碳原子上的不对称取代反应。就近十年来聚合物负载手性催化剂和手性试剂的合成及应用进行了讨论。