Xenogeneic bone marrow transplantation: II. Porcine-specific growth factors enhance porcine bone marrow engraftment in an in vitro primate microenvironment

Abstract: Establishment of mixed bone marrow chimerism in pig-to-primate transplantation, as a means of inducing specific immune tolerance, will require that both immune and nonimmune barriers be overcome. As a preliminary step in evaluating nonimmune barriers in this system, we have developed an in vitro model of engraftment in which long-term culture of porcine bone marrow-derived hematopoietic cells is supported on preformed primate bone marrow stromal layers. In the absence of cytokine supplementation, primate stromal cells were unable to support long-term porcine hematopoiesis in these cultures. Supplementation with porcine Steel Factor was required for long-term maintenance of hematopoietic progenitor cell content and total hematopoietic activity. Addition of porcine IL-3, in combination with porcine Steel Factor, increased long-term progenitor cell content and hematopoietic activity on primate stroma to levels comparable to that obtained in cultures on porcine stroma. The combination of porcine GM-CSF and Steel Factor increased progenitor cell content and hematopoietic activity early in the cultures, but had little effect in long-term cultures. The Steel Factor and IL-3 combination was species-specific in its action in these cultures, as the corresponding human cytokines were unable to effectively support long-term porcine hematopoiesis. Likewise, the combination of porcine cytokines had only minimal effects on long-term bone marrow culture of primate CD34+ cells I on primate stroma.     

复合矫治弓丝接头的力学性能及接头组织观察

目的　测试复合矫治弓丝接头的机械性能及分析接头、接头断口变化。方法　测试复合矫治弓丝接头的拉伸强度、剪切强度、扭转强度、弯曲形变残余角,TiNi形状记忆合金丝超弹性,扫描电镜观察及分析接头、断口组织变化。结果　复合矫治弓丝接头抗拉伸强度为32 0～36 0MPa ,剪切强度为2 2 0～2 5 0MPa ,抗扭转强度为30～4 0N·m、断裂时扭转角度不小于1 4 4 0°,弯曲形变残余角为1 2～1 7°;钎焊异质接头中TiNi形状记忆合金丝超弹性几乎没有破坏;接头钎料与TiNi形状记忆合金界面不存在扩散层,与不锈钢丝界面之间有一较宽的扩散层,接头断裂多发生在钎料与TiNi形状记忆合金超弹界面处,部分发生在钎缝中心。结论　复合矫治弓丝机械性能符合正畸临床要求,可应用于临床。     

The effect of mechanical deformation on magnetic properties and MRI artifacts of type 304 and type 316L stainless steel

The purpose of this study was to evaluate the influence of composition and deformation of biomedical stainless steels on mechanical properties, magnetic properties, and MRI artifacts. Type 304 and Type 316L samples were prepared using standard wire-drawing techniques. Mechanical properties were determined using standard test methods. The amount of ferromagnetic phase present was estimated using a Severn Gage and x-ray diffraction. Magnetic field attraction and artifacts were determined using previously described techniques. The strength of both steels increased significantly with increasing deformation. None of the type 316L wires transformed to the magnetic phase. The amount of magnetic phase in the type 304 wires increased with increasing deformation. There was no magnetic field attraction, and artifacts were minimal for all of type 316L wires and the undeformed type 304 wire. Deflection and artifacts were significant for the deformed type 304 stainless steel. These results provide guidance regarding the use of type 304 and type 316L stainless steels for bioimplants. In this regard, type 316L stainless steel seems to be a more acceptable material with respect to MR compatibility.     

Occupational chronic exposure to metals

Summary Stainless steel welders (n = 103) were examined. To estimate external exposure, personal air sampling was used. Internal exposure was quantified by the determination of nickel levels in erythrocytes, plasma and urine. Men and women (n = 123) were examined for control purposes. In the plasma and erythrocytes of the controls the nickel concentration was below the level of detection (< 1.81 μg/l). The element concentrations in urine were between < 0.1 and 13.3 μg/l. Of the controls 95% showed nickel levels in urine below 2.2 μg/l (reference value). The average concentration of nickel in the air was 93 ± 81 μg/m³. The average concentration of nickel in the plasma samples was 4.9 ± 4.0 μg/l (95th percentile 12.8 μg/L). In erythrocytes nickel could not be detected. The nickel concentrations in the urine of the welders were 18.5 ± 28.5 μg/l on average (95th percentile 52.5 μg/l). Only a weak correlation between the nickel levels of plasma and urine could be detected (C_urine = 2.07 + 8.45 C_plasma; r = 0.294; p < 0.01). Based on our results and on the reported literature a future limit value for the nickel concentration in urine should lay between 30 and 50 μg/l. This value corresponds to an external exposure of 500 μg nickel per cubic metre.     

放置不锈钢IUD20年以上妇女的长期安全性研究——临床与病理分析

调查了上海市所属崇明、嘉定二个县及川沙县三个公社的全部放置了不锈钢宫内节育环20年以上妇女635人的临床情况;调查了上述地区年龄相似未放环的妇女724例作为对照。临床症状发生率经年龄与绝经年龄配对后,放环组中赤带的发生率增高4.87%(P<0.05),而月经量增多与不规则出血的发生率增高极少(P>0.05)。放环组取环374例其宫腔括出物中均未见癌,特别注意了内膜的直接压迫与移行区内膜亦未见明显间变。子宫内膜轻度增生过长9例,占2.41%。与放置时间长短无关。其中315例较完整的内膜中,有炎症者32例,占10.15%。其发生率与环的放置时间长短无关。内膜炎中3例为放线菌感染。374例取环困难情况与环的放置时间长短无明显关系,而与绝经年限长短有关,随着绝经年限增长而困难增多。23例宫腔X 线造影发现宫腔随着绝经年限增长而逐渐缩小,环的嵌顿越来越深。     

In vitro corrosion study of porous metal fibre coatings for bone ingrowth

As a first part of a biocompatibility testing programme, in vitro corrosion tests were carried out on porous stainless steel AISI 316L and titanium compacts made of 100 microns thick fibres. The present porous metal structures are used as coatings on permanent orthopaedic implants; with osseous tissue invading the pores, the implant becomes securely anchored to the surrounding bone. The results show that no inadvertent reactions occur with porous titanium. It can probably be used with no greater risk of localized electrochemical attack than the parent bulk material.     

Noise characteristics of stainless-steel surface electrodes

Bioelectric events measured with surface electrodes are subject to noise components which may be significant in comparison with low-level biological signals such as evoked neuroelectric potentials, and myoelectric potentials. In an effort to better understand noise arising from these electrodes, electrode and measurement system noise is modelled. The effect of electrode surface area on electrode impedance and noise is studied using circular stainless-steel electrodes of varying diameters. The main contributions of the work are the development of a model for stainless-steel electrode noise as a function of electrode area, and demonstrating that, for the band-width of interest to evoked neuroelectric and myoelectric signals (8–10 000 Hz), the primary noise components are thermal and amplifier current generated. The magnitudes of both of these depend on the electrode impedance magnitude. Electrode impedance is shown to be a power function of both electrode diameter and frequency, consistent with a capacitive electrode model.     

老年转子间骨折角型钢板治疗失误和并发症分析

目的分析角型钢板治疗股骨转子间骨折中出现的各种失误和并发症,并提出预防措施。方法1990年10月以来共治疗股骨转子间骨折68例,逐例分析治疗失误的原因。结果术中操作失误致股骨外侧皮质崩裂2例;钢板刀口穿破股骨头进入髋臼1例,术后切口感染1例,共8例出现并发症,发生率14．7％。结论角型钢板治疗股骨转子间骨折效果好,但不应忽视可能发生的各种失误和并发症。     

某型钢珠弹对绵羊四肢致伤效应的现场实验

目的 观察某型钢珠弹对四肢的致伤特点及规律,为四肢爆炸伤的救治提供依据。方法 以现场实验的方式,观察某型钢珠弹引爆后对实验动物的致伤作用。结果 伤后即刻死亡率为53.3%,伤后6h达70.6%,四肢残片伤的发生率为56.7%,其中软组织损伤占66.7%,骨折发生率为23.3%,且均为粉碎性骨折。合并伤以胸、腹部最为多见,分别为70.6%和64.7%。结论 四肢爆炸伤在该试验中发生率高,局部组织毁损严重,骨折均为粉碎性骨折,合合并全身多处损伤。