HZ818树脂在紫杉醇初分离工艺中的应用

采用HZ818大孔吸附树脂对红豆杉浸膏中的紫杉醇成分进行吸附和洗脱试验，同时利用液质联用进行分析检测，确定了其最佳工艺参数。结果表明，HZ818树脂对紫杉醇有良好的吸附分离效果。优化工艺条件为：样品溶于体积分数40％甲醇，以1．5mL／min过柱，体积分数75％甲醇淋洗，体积分数85％甲醇以0．5mL／min洗脱，紫杉醇的质量分数从原浸膏中的1．02％提高到8．1％，回收率达98．6％。     

多官能度活性橡胶增韧环氧树脂的研究：Ⅲ.三元共混增韧环氧树脂

本文研究了双酚A对多官能度环氧基和羧基聚丙烯酸正丁酯橡胶增韧环氧树脂的影响。结果表明,加入双酚A,拉伸断裂能有大幅度提高,同时不降低弹性模量。这可能是由椽胶提高断裂伸长与双酚A提高屈服应力产生协同效应的结果。对羧基橡胶增韧的三元共混体系,拉伸断裂能随羧基官能度上升而增加。断裂面的形态研究表明,由于羧基橡胶与双酚A的酯化反应,大大减少了羧基橡胶聚集对增韧的不利影响。     

橡胶活性官能团对增韧环氧树脂动态力学性能的影响

用动态扭摆法测试聚丙烯酸丁酯橡胶增韧环氧树脂的动态力学行为,研究在环氧树脂低固化度和高固化度时,橡胶活性官能团种类(环氧基官能团与羧基官能团)和数量(官能度)对其影响。研究体系中橡胶玻璃化转变温度(Tg)的移动大小,与橡胶和基体树脂健合程度之间的关系。     

Radium-228 determination of natural waters via concentration on manganese dioxide and separation using Diphonix ion exchange resin

The objective of this work was to establish a new procedure for ²²⁸Ra determination of natural waters via preconcentration of radium on MnO₂ and separation of its daughter, ²²⁸Ac, using Diphonix ion exchange resin. Following removal of potential interferences via passage through an initial Diphonix Resin column, the first daughter of ²²⁸Ra, ²²⁸Ac, is isolated by chromatographic separation via a second Diphonix column. A holding time of >30 h for ²²⁸Ac ingrowth in between the two column separations ensures secular equilibrium. Barium-133 is used as a yield tracer. Actinium-228 is eluted from the second Diphonix Resin with 5 ml 1 M 1-Hydroxyethane-1,1-diphosphonic acid (HEDPA) and quantified by addition of scintillation cocktail and LSC counting. Radium (and ¹³³Ba) from the load and rinse solutions from the 2nd Diphonix column may be prepared for alpha spectrometry (for determination of ²²³Ra, ²²⁴Ra, and ²²⁶Ra) by BaSO₄ microprecipitation and filtration. Decontamination tests indicate that U, Th, and Ra series nuclides do not interfere with these measurements, although high contents of ⁹⁰Sr (⁹⁰Y) require additional treatment for accurate measurement of ²²⁸Ra. Addition of stable Sr as a “hold back” carrier during the initial MnO₂ preconcentration step was shown to remove most ⁹⁰Sr interference.     

接枝环氧树脂水分散液的合成、分离与表征

控制不同的反应条件,采用甲基丙烯酸、苯乙烯与环氧树脂在丙二醇丁醚/正丁醇溶剂中接枝共聚,合成了粒径在87～104nm范围的环氧树脂水分散液。通过环己烷/乙醇和丙酮两步萃取,对接枝共聚产物进行分离,用FTIR表征,并估算了接枝共聚物的组成。实验结果表明,所制备的粒径为纳米级的环氧树脂水分散液,具有良好的机械稳定性、冻融稳定性及贮存稳定性。ξ电位测定表明,产物在pH>8的条件下更为稳定。     

Dermatitis from hexavalent chromate in the accelerator of an epoxy sealant (PR1422) used in the aircraft industry

4 aircraft construction workers developed allergic contact dermatitis of the hands and forearms. The allergen was hexavalent chromate in the accelerating solution of an epoxy-based sealant (PR1422). Although chromate dermatitis from an epoxy resin has been described, epoxy system accelerators are a hitherto unrecognized source of occupational chromate dermatitis.     

Occupational allergic contact dermatitis and composition of acrylates in dentin bonding systems

Background Dentin-bonding systems contain sensitizing acrylates. They are increasingly used in dentistry, but only few cases of allergy have been encountered. Objective This study reports observations on eleven patients sensitized by acrylates in dentin-bonding compounds. Furthermore, the composition of dentin-bonding products was analysed and compared with the information given in the material safety data sheets. Methods Patch testing was performed to reveal allergic contact dermatitis, and chamber provocation tests to reveal possible respiratory sensitivity. Gas chromatography/mass spectrometry was used to analyse the chemical composition of the bonding products. Results The most common sensitizer in our material of eleven patients was 2-hydroxyethyl methacrylate (2-HEMA). Another putative sensitizer, BIS-GMA, used in dentin adhesives, did not cause sensitization. The typical allergic dermatitis localized to the fingertips (pulpitis). Seven of the eleven patients also developed paresthesia of the fingertips. One patient with positive patch test reactions to (meth)acrylates had pharyngitis hut no skin symptoms. One patient was sensitized because she had been patch tested with too high a concentration (undiluted) of dentin-bonding components. Material safety sheets gave inaccurate or wrong information about the contents. Conclusion Dentin-bonding acrylates are strong sensitizers, and even a single exposure may sensitize.     

复合树脂预热的研究现状和临床应用

复合树脂作为临床常用牙科充填材料存在耐磨性差、聚合收缩大和牙本质边缘适应性不佳等问题。近年有研究发现预热可以改善复合树脂的性能,本文就预热复合树脂对其单体转化率、边缘微渗漏、机械性能以及牙髓的影响等方面进行探讨,以供临床参考。     

人工关节置换充填骨水泥对血液动力学的影响

目的观察人工关节置换术中充填骨水泥对血液动力学的影响。方法40例ASAⅡ～Ⅲ级行人工关节置换术的患者，观察骨水泥充填后10min内血液动力学的变化。结果充填骨水泥后10min内患者血液动力学都有显著变化（P〈0．05），个别患者血压下降严重。需升压药支持。结论人工关节置换术中充填骨水泥可致血液动力学严重波动，应引起重视。