Insight towards Nucleation Mechanism and Change in Morphology for Nanostructured Platinum Thin Film Directly Grown on Carbon Substrate via Electrochemical Deposition

Nanocrystalline platinum with different morphologies is synthesized via electrochemical deposition technique. The nucleation mechanism and its structural effect over the electrodeposited Pt on carbon electrodes have been systematically studied. Powder X-ray diffraction, X-ray photoelectron spectroscopy, and field-emission scanning electron microscopy are employed to study nucleation, oxidation states, and Pt structure growth on a carbon electrode. This study reports significant development of Pt metal nanoparticles with different morphologies such as a sphere, flower, core-flower, and rod-like structure directly fabricated on carbon electrode while tuning the deposition parameters such as current density, time, temperature, pH during the deposition process. The proposed electrochemical route represents a superior fabrication procedure for large-scale electrode fabrication compared to a conventional method for preparing membrane electrode assemblies for fuel cell stacks.     

Heteroepitaxy of Cerium Oxide Thin Films on Cu(111)

An important part of fundamental research in catalysis is based on theoretical and modeling foundations which are closely connected with studies of single-crystalline catalyst surfaces. These so-called model catalysts are often prepared in the form of epitaxial thin films, and characterized using advanced material characterization techniques. This concept provides the fundamental understanding and the knowledge base needed to tailor the design of new heterogeneous catalysts with improved catalytic properties. The present contribution is devoted to development of a model catalyst system of CeO₂ (ceria) on the Cu(111) substrate. We propose ways to experimentally characterize and control important parameters of the model catalyst—the coverage of the ceria layer, the influence of the Cu substrate, and the density of surface defects on ceria, particularly the density of step edges and the density and the ordering of the oxygen vacancies. The large spectrum of controlled parameters makes ceria on Cu(111) an interesting alternative to a more common model system ceria on Ru(0001) that has served numerous catalysis studies, mainly as a support for metal clusters.     

平时罕见,特殊情况下发生的几种伤病

一些损伤和疾病平时罕见，特殊情况下可以发生，造成严重危害。特殊情况主要包括严重事故、灾害、战争、恐怖主义活动以及特殊环境与特殊作业的危害等。本阐述了现代战争中发生的贫铀武器伤害、燃料空气炸弹伤害、微波武器伤害和战时精神疾病；可能源于恐怖主义活动的炭疽、天花；严重事故性伤害中的核事故、化学事故和煤矿事故伤害；严重灾害中的地震、海难(海战)落海伤害。中介绍了这些伤病的发生情况、伤害特点与医学救治。     

In-situ measurements of gas permeability in fuel cell membranes using a cylindrical microelectrode

A new method to study permeation of gases in proton conducting membranes using a cylindrical microelectrode is presented. The focus of this work was to develop an in-situ method to study transport properties of hydrogen and oxygen close to real fuel cell operating conditions. The gas permeability is strongly affected by the change of water content in the membrane and it is therefore of advantage that, by using this method, measurements can be carried out over a wide range of relative humidities. The numerical method makes it possible to separate the diffusion coefficient and the concentration of dissolved gas in the membrane and also allows kinetic limitations to be taken into account. Chronoamperometric measurements on Nafion® 117 were successfully evaluated numerically. Experiments at temperatures of 25 and 60 °C with respect to oxygen permeation and at 60 °C for hydrogen permeation at relative humidities in the range 30–94% are presented. The reproducibility of data was excellent when measuring with different microelectrodes on the same membrane sample, but differed when measuring on different samples. In general, the permeability increases with increasing temperature and relative humidity.     

导向喷动流化床生物质快速裂解制液体燃料

在冷模试验得到的优化的结构参数基础上，建立了一套生物质最大处理量为5kg／h的导向管喷动流化床生物质裂解反应器。反应在常压和440～520℃进行，以木屑为生物质原料，二氧化碳和氮气为喷动气或流化气，沙子为流化介质。结果表明该喷动流化床反应器可用于生物质的快速裂解。在400～480℃，液体产率随温度增加而上升，高于480℃时，二次反应的加剧又导致液体产品产率下降。固体和气体的产率则随温度的升高而减少。喷动气和流化气流量的增加均强化了反应器内的传热，并使生物质初始裂解产物的停留时间减少，二次反应进行程度减弱。在适当的裂解条件下液体产率可达73．2％，此时气体和焦的产率分别为12．8％和14．0％。所得液体产品为单一相液体，含水约30％，可用于燃烧。与流化床相比，喷动流化床作为生物质快速裂解反应器可明显提高液体产率。     

Limiting behaviour during the hydroperoxide ion generation in a flow alkaline fuel cell

A comparative study of an O₂-diffusion cathode and a H₂-diffusion anode has been performed to ascertain the limiting processes, when they are combined in a flow alkaline fuel cell with hydroperoxide ion generation. The linear sweep voltammograms and the impedance diagrams of both electrodes show large differences. The cathode reaction is charge transfer-controlled up to current densities of at least 1 A cm^?2, whereas the dissociative adsorption, charge transfer and diffusion of H₂ appear to limit the anode reaction. The anode, with limiting current densities of about 90 and 150 mA cm^?2 for 1.0 and 6.0 M KOH, respectively, then clearly controls the hydroperoxide ion production in the fuel cell. Diffuse reflectance infrared Fourier transform spectroscopy and X-ray photoelectron spectroscopy reveal that, the carbon of the H₂-diffusion anode does not undergo significant oxygen functionalisation during hydroperoxide ion generation in the fuel cell.     

降低隧道施工机械尾气污染的几项措施

目的　研究降低无轨运输方式施工隧道中空气污染的措施。方法　采用燃油添加剂 ,定期对施工机械进行维修和保养 ,减少发动机空档排气 ,将压入式通风口设置于距掌子面 8～ 10m处 ,保持通风管道密闭通畅致使有效送风。结果　隧道中有害气体CO、NOx及黑烟浓度至少降低 4 6 % ,55%和 4 2 %。结论　采取以上措施能明显改善施工环境的污染状况并减轻对施工人员身体健康的危害     

Dermal, oral, and inhalation pharmacokinetics of methyl tertiary butyl ether (MTBE) in human volunteers.

Methyl tertiary butyl ether (MTBE), a gasoline additive used to increase octane and reduce carbon monoxide emissions and ozone precursors, has contaminated drinking water and can lead to exposure by oral, inhalation, and dermal routes. To determine its dermal, oral, and inhalation kinetics, 14 volunteers were exposed to 51.3 microg/ml MTBE dermally in tap water for 1 h, drank 2.8 mg MTBE in 250 ml Gatorade(R), and inhaled 3.1 ppm. MTBE for 1 h. Blood and exhaled breath samples were then obtained. Blood MTBE peaked between 15 and 30 min following oral exposure, at the end of inhalation exposure, and ~5 min after dermal exposure. Elimination by each route was described well by a three-compartment model (Rsq >0.9). The Akaike Information Criterion for the three-compartment model was smaller than the two-compartment model, supporting it over the two-compartment model. One metabolite, tertiary butyl alcohol (TBA), measured in blood slowly increased and plateaued, but it did not return to the pre-exposure baseline at the 24-h follow-up. TBA is very water-soluble and has a blood:air partition ratio of 462, reducing elimination by exhalation. Oral exposure resulted in a significantly greater MTBE metabolism into TBA than by other routes based on a greater blood TBA:MTBE AUC ratio, implying significant first-pass metabolism. The slower TBA elimination may make it a better biomarker of MTBE exposure, though one must consider the exposure route when estimating MTBE exposure from TBA because of first-pass metabolism. Most subjects had a baseline blood TBA of 1-3 ppb. Because TBA is found in consumer products and can be used as a fuel additive, it is not a definitive marker of MTBE exposure. These data provide the risk assessment process of pharmacokinetic information relevant to the media through which most exposures occur-air and drinking water.     

Biomass fuel exposure and asthma symptoms among rural school children in Nigeria

Background: Approximately 70% of rural Nigerian households rely on biomass fuels for cooking. The International Study of Asthma and Allergies in Childhood (ISAAC) estimates the prevalence of current wheeze among children in Nigeria to have risen from 10.7% in 1999 to approximately 20% in 2014. Objective: To examine the effects of biomass smoke exposure on asthma symptom prevalence in rural children in Nigeria. Methods: We conducted a cross-sectional survey in rural communities in Nigeria. Asthma symptoms were defined according to ISAAC definitions. Biomass smoke exposure was determined by the types of fuel used for cooking. Logistic regression was used to explore associations between biomass smoke and asthma symptoms. Results: The study population comprised 1,690 school children, of which 865 lived in households cooking with biomass and 825 lived in households not using biomass. Asthma symptoms were reported in 481 (28.5%) children. Biomass fuel was associated with increased odds of asthma symptoms. Adjusted odds ratios (aORs) were 1.38 (95% CI: 1.05–1.80) for nocturnal cough, 1.26 (95% CI: 1.00–1.61) for current wheeze, and 1.33 (95% CI: 1.05–1.69) for report of any asthma-related symptoms. Sex modified the associations between asthma symptoms with biomass fuel: aORs were stronger and significant for males (nocturnal cough = 1.85, 95% CI: 1.24–2.76; current wheeze = 1.48, 95% CI: 1.03–2.13; report of any asthma-related symptoms = 1.60, 95% CI: 1.12–2.28), but weaker and non-significant for females.Conclusion: The risk of asthma symptoms related to biomass smoke exposure appears to differ by sex.     

IL6Rα function in myeloid cells modulates the inflammatory response during irritant contact dermatitis

Irritant contact dermatitis (ICD) is characterized by epidermal hyperplasia, infiltration of leucocytes into lesional skin and inflammatory cytokine release. The cellular infiltrate during ICD comprises primarily cells of the myeloid lineage. Our group has previously shown that the cytokine IL‐6 confers a protective effect to lesional skin during ICD. How IL‐6Rα function in myeloid cells is involved in the inflammatory response during ICD is, however, unknown. In the present study, utilizing a chemical model of ICD, it is shown that mice with a myeloid‐specific knockout of the IL‐6Rα (IL‐6Rα^Δmyeloid) display an exaggerated inflammatory response to benzalkonium chloride (BKC) and Jet propellant‐8 (JP8) fuel, two well‐characterized irritants relative to littermate control. Results from immunohistochemical and flow cytometric analyses revealed that IL‐6Rα^Δmyeloid mouse skin displayed increased epidermal hyperplasia and inflammatory monocyte influx into lesional skin but lower numbers of resident macrophages relative to littermate controls after irritant exposure. Multiplex immunoassay revealed significantly higher levels of pro‐inflammatory cytokines IL‐1α and TNF‐α, but reduced expression of chemokine proteins including CCL2‐5, CCL7, CCL11, CXCL1 and CXCL10 in IL‐6Rα^Δmyeloid mouse skin relative to littermate control following irritant exposure. These results highlight a previously unknown role of IL‐6Rα function in myeloid cells in modulating the inflammatory response and myeloid population dynamics during ICD.