Age trends in femur stresses from a simulated fall on the hip among men and women: evidence of homeostatic adaptation underlying the decline in hip BMD.

Age trends in proximal femur stresses were evaluated by simulating a fall on the greater trochanter using femur geometry from hip DXA scans of 5334 white men and women in the NHANES III survey. Expansion of femur outer diameter seems to counter net bone loss so that stresses remain similar across age groups, but stresses are higher in older women than in older men. INTRODUCTION: The age decline in hip BMD is caused by both bone loss and expansion of outer diameter that increases the region size over which mass is measured in a DXA scan. Because expansion has an opposing effect on structural strength, it may be a homeostatic adaptation to net bone loss to ensure that load stresses are kept within a narrow range. MATERIALS AND METHODS: Age trends in femur stresses were evaluated with an engineering beam simulation of a fall on the greater trochanter. Hip geometry was extracted from hip DXA scans using the Hip Structure Analysis (HSA) software on 2613 non-Hispanic white men and 2721 women from the third National Health and Nutrition Examination Survey (NHANES III). Using body weight as load, stresses were computed on the inferior-medial and superior-lateral femur neck at its narrowest point and the medial and lateral shaft 2 cm distal to the midpoint of the lesser trochanter. Stresses and the underlying geometries in men and women >50 years oaf age were compared with those 20-49 years of age. RESULTS: Compared with men <50 years of age, stresses in older men were 6% lower on both surfaces of the shaft, 4% lower on the inferior-medial neck, and not different on the superior-lateral neck. In women >50 years of age, stresses on the proximal shaft and inferior-medial neck remained within 3% of young values but were 13% greater on the superior-lateral neck. Neck stresses in young women were lower on the superior-lateral than the inferior-medial neck, but lateral stress increased to the level on the medial surface in older women. Stresses were higher in women than in men, with a greater gender difference in those >50 years of age. CONCLUSIONS: We conclude that femur expansion has a homeostatic effect in men and women that opposes bone loss so that stresses change little with age. Because expansion preserves stresses with progressively less bone mass, the process may reduce structural stability in the femoral neck under fall conditions, especially in the elderly female.     

In vitro performance of the novel coronary sinus AutoRetroPerfusion Cannula

Myocardial salvage through coronary sinus intervention has been documented. The AutoRetroPerfusion Cannula is a novel device that is able to perfuse the coronary bed retrogradely through the coronary sinus with arterial blood generated from a peripheral artery with no need for a pump. The cannula consists of a distal end that, once secured in the coronary sinus, opens an umbrella-like membrane to create pressure in the coronary sinus, and at the same time has small channels directed backwards to the right atrium to provide pressure relief. The cannula is introduced from the axillary vein under local anesthesia and the proximal end, which consists of a graft, is anastomosed to the axillary artery to start autoperfusion once the distal end is secured in the coronary sinus and the occluding membrane is open. The AutoRetroPerfusion Cannula was tested in the in vitro mock loop under 50-120 mm Hg of proximal pressure and 50, 100, and 150 ml/min of total flow in the cannula. We were able to achieve the nominal design point of 40-80 mm Hg of distal pressure and 50-150 ml/min of distal flow by adjusting the number, diameter, and length of the small backwards channels.     

Calculation of beta-ray dose distributions from ophthalmic applicators and comparison with measurements in a model eye

Dose distributions throughout the eye, from three types of beta-ray ophthalmic applicators, were calculated using the EGS4, ACCEPT 3.0, and other Monte Carlo codes. The applicators were those for which doses were measured in a recent international intercomparison [Med. Phys. 28, 1373 (2001)], planar applicators of 106Ru-106Rh and 90Sr-90Y and a concave 106Ru-106Rh applicator. The main purpose was to compare the results of the various codes with average experimental values. For the planar applicators, calculated and measured doses on the source axis agreed within the experimental errors (<10%) to a depth of 7 mm for 106Ru-106Rh and 5 mm for 90Sr-90Y. At greater distances the measured values are larger than those calculated. For the concave 106Ru-106Rh applicator, there was poor agreement among available calculations and only those calculated by ACCEPT 3.0 agreed with measured values. In the past, attempts have been made to derive such dose distributions simply, by integrating the appropriate point-source dose function over the source. Here, we investigated the accuracy of this procedure for encapsulated sources, by comparing such results with values calculated by Monte Carlo. An attempt was made to allow for the effects of the silver source window but no corrections were made for scattering from the source backing. In these circumstances, at 6 mm depth, the difference in the results of the two calculations was 14%-18% for a planar 106Ru-l06Rh applicator and up to 30% for the concave applicator. It becomes worse at greater depths. These errors are probably caused mainly by differences between the spectrum of beta particles transmitted by the silver window and those transmitted by a thickness of water having the same attenuation properties.     

Dosimetry characterization of 32P catheter-based vascular brachytherapy source wire

Dosimetry measurements and Monte Carlo simulations for a catheter-based 32P endovascular brachytherapy source wire are described. The measured dose rates were obtained using both radiochromic dye film and an automated plastic scintillator. The investigated source has dimensions of 27 mm in length and 0.24 mm in diameter, and is encapsulated in NiTi. For the radiochromic film measurements, calibrated radiochromic dye film was irradiated at distances between 1 and 5 mm from the source axis in A-150 plastic, and read out with a high-resolution scanning densitometer. The depth-dose curve measured in A-150 is then converted to that in water using correction factors obtained from Monte Carlo calculations. For the scintillator system, direct measurements in water were acquired at distances between 1 and 6 mm from the center of the source, along the perpendicular bisector of the source axis. The scintillator was calibrated in terms of absorbed-dose rate in a reference beta-particle field at multiple depths. The measured dose rates obtained from the film and scintillator measurements were then normalized to the measured source activity, i.e., to convert the measured data to units of cGy/s/mCi. Theoretical dosimetry calculations of the catheter-based 32P wire geometry were also obtained from Monte Carlo simulations using the Electron Gamma Shower code (EGS4), the Monte Carlo N-particle transport code (MCNP4B), and CYLTRAN from the Integrated Tiger Series codes (ITS v.3) and found to be in good agreement. The results of both measurements and calculations are expressed as absorbed-dose rate in water per unit of contained activity (cGy/s/mCi). Comparisons indicate that the measured and calculated dosimetry are in good agreement (<10%) within the relevant treatment distances (1-5 mm). This work fully characterizes the radiation field around a novel 32P beta brachytherapy source in water. The depth-dose curve can be used to calculate the dose to the vessel wall from a 27 mm 32P source wire centered within the vessel lumen.     

Dose perturbation of a novel cobalt chromium coronary stent on 32P intravascular brachytherapy: a monte carlo study

Intravascular brachytherapy has been adopted for the indication of in-stent restenosis on the basis of results of clinical trials using mainly stainless steel stents. Recently, a new stent made of cobalt-chromium L-605 alloy (CoCr, p=9.22 g/cm3) (MULTI-LINK VISION) was introduced as an alternative to the 316L stainless steel stent design (SS, p=7.87 g/cm3) (MULTI-LINK PENTA). In this work, we used the Monte Carlo code MCNPX to compare the dose distribution for the 32P GALILEO source in CoCr and SS 8 mm stent models. The dose perturbation factor (DPF), defined as the ratio of the dose in water with the presence of a stent to the dose without a stent, was used to compare results. Both stent designs were virtually expanded to diameters of 2.0, 3.0, and 4.0 mm using finite element models. The complicated strut shapes of both the CoCr and SS stents were simplified using circular rings with an effective width to yield a metal-to-tissue ratio identical to that of the actual stents. The mean DPF at a 1 mm tissue depth, over the entire stented length of 8 mm, was 0.935 for the CoCr stent and 0.911 for the SS stent. The mean DPF at the intima (0.05 mm radial distance from the strut outer surface), over the entire stented length of 8 mm, was 0.950 for CoCr, and 0.926 for SS. The maximum DPFs directly behind the CoCr and SS struts were 0.689 and 0.644, respectively. All DPF estimates have a standard deviation of +/-0.6%(k=2), approximating the 95% confidence interval. Although the CoCr stent has a higher effective atomic number and greater density than the SS stent, the DPFs for the two stents are similar, probably because the metal-to-tissue ratio and strut thickness of the CoCr stent are lower than those of the SS stent.     

Long-pulsed 1064-nm and 755-nm lasers for C1 leg veins on skin type IV patients: a side-by-side comparison

Lasers in Medical Science - Long-pulsed 1064-nm (LP1064) and 755-nm (LP755) lasers have been demonstrated as effective treatments for leg veins. However, few studies of these treatments on Asian...     

Interactions between imidazoline compounds and sulphonylureas in the regulation of insulin secretion

1. Imidazoline α₂-antagonist drugs such as efaroxan have been shown to increase the insulin secretory response to sulphonylureas from rat pancreatic B-cells. We have investigated whether this reflects binding to an islet imidazoline receptor or whether α₂-adrenoceptor antagonism is involved.
2. Administration of (±)-efaroxan or glibenclamide to Wistar rats was associated with a transient increase in plasma insulin. When both drugs were administered together, the resultant increase in insulin levels was much greater than that obtained with either drug alone.
3. Use of the resolved enantiomers of efaroxan revealed that the ability of the compound to enhance the insulin secretory response to glibenclamide resided only in the α₂-selective-(+)-enantiomer; the imidazoline receptor-selective-(−)-enantiomer was ineffective.
4. In vitro, (+)-efaroxan increased the insulin secretory response to glibenclamide in rat freshly isolated and cultured islets of Langerhans, whereas (−)-efaroxan was inactive. By contrast, (+)-efaroxan did not potentiate glucose-induced insulin secretion but (−)-efaroxan induced a marked increase in insulin secretion from islets incubated in the presence of 6 mM glucose.
5. Incubation of rat islets under conditions designed to minimize the extent of α₂-adrenoceptor signalling (by receptor blockade with phenoxybenzamine; receptor down-regulation or treatment with pertussis toxin) abolished the capacity of (+)-and (±)-efaroxan to enhance the insulin secretory response to glibenclamide. However, these manoeuvres did not alter the ability of (±)-efaroxan to potentiate glucose-induced insulin secretion.
6. The results indicate that the enantiomers of efaroxan exert differential effects on insulin secretion which may result from binding to effector sites having opposite stereoselectivity. Binding of (−)-efaroxan (presumably to imidazoline receptors) results in potentiation of glucose-induced insulin secretion, whereas interaction of (+)-efaroxan with a second site leads to selective enhancement of sulphonylurea-induced insulin release.

     

Multiple effector pathways regulate the insulin secretory response to the imidazoline RX871024 in isolated rat pancreatic islets.

When isolated rat islets were cultured for 18 h prior to use, the putative imidazoline binding site ligand, RX871024 caused a dose-dependent increase in insulin secretion at both 6 mM and 20 mM glucose. By contrast, a second ligand, efaroxan, was ineffective at 20 mM glucose whereas it did stimulate insulin secretion in response to 6 mM glucose. Exposure of islets to RX871024 (50 microM) for 18 h, resulted in loss of responsiveness to this reagent upon subsequent re-exposure. However, islets that were unresponsive to RX871024 still responded normally to efaroxan. The imidazoline antagonist, KU14R, blocked the insulin secretory response to efaroxan, but failed to prevent the stimulatory response to RX871024. By contrast with its effects in cultured islets, RX871024 inhibited glucose-induced insulin release from freshly isolated islets. Efaroxan did not inhibit insulin secretion under any conditions studied. In freshly isolated islets, the effects of RX871024 on insulin secretion could be converted from inhibitory to stimulatory, by starvation of the animals. Inhibition of insulin secretion by RX871024 in freshly isolated islets was prevented by the cyclo-oxygenase inhibitors indomethacin or flurbiprofen. Consistent with this, RX871024 caused a marked increase in islet PGE2 formation. Efaroxan did not alter islet PGE2 levels. The results suggest that RX871024 exerts multiple effects in the pancreatic beta-cell and that its effects on insulin secretion cannot be ascribed only to interaction with a putative imidazoline binding site.