Secretion,blood levels and cutaneous expression of TL1A in psoriasis patients

TL1A is a TNF‐like cytokine which has been shown to co‐stimulate TH1 and TH17 responses during chronic inflammation. The expression of this novel cytokine has been investigated in inflammatory disorders like rheumatoid arthritis and inflammatory bowel disease, but little is known about expression and induction in psoriasis. Indeed, the pathogenesis in psoriasis is still not fully understood and it is speculated that cytokines other than TNF‐α are important in subsets of patients. Also, for patients with severe disease that are treated with systemic anti‐TNF‐α blockade, novel candidates to be used as disease and response biomarkers are of high interest. Here, we demonstrate TL1A expression in biopsies from psoriatic lesions. Also, we investigated spontaneous and induced TL1A secretion from PBMCs and blood levels from a cohort of psoriasis patients. Here, increased spontaneous secretion from PBMCs was observed as compared to healthy controls and a small subset of patients had highly elevated TL1A in the blood. Interestingly, activation of PBMCs with various cytokines showed a decreased sensitivity for TL1A activation in psoriasis patients compared to healthy controls.TL1A levels in blood and biopsies could not be correlated with disease activity with this patient cohort. Thus, additional large‐scale studies are warranted to investigate TL1A as a biomarker.     

Ultrasound-Assist Extrusion Methods for the Fabrication of Polymer Nanocomposites Based on Polypropylene/Multi-Wall Carbon Nanotubes

Isotactic polypropylenes (iPP) with different melt flow indexes (MFI) were used to fabricate nanocomposites (NCs) with 10 wt % loadings of multi-wall carbon nanotubes (MWCNTs) using ultrasound-assisted extrusion methods to determine their effect on the morphology, melt flow, and electrical properties of the NCs. Three different types of iPPs were used with MFIs of 2.5, 34 and 1200 g/10 min. Four different NC fabrication methods based on melt extrusion were used. In the first method melt extrusion fabrication without ultrasound assistance was used. In the second and third methods, an ultrasound probe attached to a hot chamber located at the exit of the die was used to subject the sample to fixed frequency and variable frequency, respectively. The fourth method is similar to the first method, with the difference being that the carbon nanotubes were treated in a fluidized air-bed with an ultrasound probe before being used in the fabrication of the NCs with no ultrasound assistance during extrusion. The samples were characterized by MFI, Optical microscopy (OM), Scanning electron microscopy (SEM), Transmission electron microscopy (TEM), electrical surface resistivity, and electric charge. MFI decreases in all cases with addition of MWCNTs with the largest decrease observed for samples with the highest MFI. The surface resistivity, which ranged from 10¹³ to 10⁵ Ω/sq, and electric charge, were observed to depend on the ultrasound-assisted fabrication method as well as on the melt flow index of the iPP. A relationship between agglomerate size and area ratio with electric charge was found. Several trends in the overall data were identified and are discussed in terms of MFI and the different fabrication methods.