Repair of large midline incisional hernias with polypropylene mesh: Comparison of three operative techniques

Polypropylene mesh is widely used for the reconstruction of incisional hernias that cannot be closed primarily. Several techniques have been advocated to implant the mesh. The objective of this study was to evaluate, retrospectively, early and late results of three different techniques, onlay, inlay, and underlay. The records of 53 consecutive patients with a large midline incisional hernia — 25 women and 28 men, mean age 60.4 (range 28–94) — were reviewed. Polypropylene mesh was implanted using the onlay technique in 13 patients, inlay in 23 patients, and underlay in 17 patients. Either the greater omentum or a polyglactin mesh was interponated between the mesh and the viscera. The records of these 53 patients were reviewed with respect to: size and cause of the hernia, pre- and postoperative mortality and morbidity, with special attention to wound complications. Patients were invited to attend the outpatient clinic at least 12 months after implantation of the mesh for physical examination of the abdominal wall. Postoperative complications occurred in 14 (26.4%) patients. The onlay technique had significantly more complications, as compared to both other techniques. Reherniation occurred in 15 (28.3%) patients. The reherniation rate of the inlay technique was significantly higher than after the underlay technique (44% vs 12%, P=0.03) and tended to be higher than the onlay technique (44% vs 23%, P=0.22). Repair of large midline incisional hernias with the use of a polypropylene mesh carries a high risk of complications and has a high reherniation rate. The underlay technique seems to be the better technique.     

Nonheme iron in sickle erythrocyte membranes: association with phospholipids and potential role in lipid peroxidation

Previous studies documented the abnormal association of heme and heme proteins with the sickle RBC membrane. We have now examined RBC ghosts and inside-out membranes (IOM) for the presence of nonheme iron as detected by its formation of a colored complex with ferrozine. Sickle ghosts have 33.8 +/- 18.2 nmol nonheme iron/mg membrane protein, and sickle IOM have 4.3 +/- 3.0 nmol/mg. In contrast, normal RBC ghosts and IOM have no detectable nonheme iron. The combination of heme and nonheme iron in sickle IOM averages nine times the amount of membrane- associated iron in normal IOM. Kinetics of the ferrozine reaction show that some of this nonheme iron on IOM reacts slowly and is probably in the form of ferritin, but most (72% +/- 18%) reacts rapidly and is in the form of some other biologic chelate. The latter iron compartment is removed by deferoxamine and by treatment of IOM with phospholipase D, which suggests that it represents an abnormal association of iron with polar head groups of aminophospholipids. The biologic feasibility of such a chelate was demonstrated by using an admixture of iron with model liposomes. Even in the presence of tenfold excess adenosine diphosphate, iron partitions readily into phosphatidylserine liposomes; there is no detectable association with phosphatidylcholine liposomes. To examine the bioavailability of membrane iron, we admixed membranes and t-butylhydroperoxide and found that sickle membranes show a tenfold greater peroxidation response than do normal membranes. This is not due simply to a deficiency of vitamin E, and this is profoundly inhibited by deferoxamine. Thus, while thiol oxidation in sickle membranes previously was shown to correlate with heme iron, the present data suggest that lipid peroxidation is related to nonheme iron. In control studies, we did not find this pathologic association of nonferritin, nonheme iron with IOM prepared from sickle trait, high-reticulocyte, postsplenectomy, or iron-overloaded individuals. These data provide additional support for the concept that iron decompartmentalization is a characteristic of sickle RBCs.     

Effects of finite angular steps and extent of profile data on the calculation of rotational x-ray dose distributions

Computer algorithms for rotational therapy beams, in most cases, perform dose calculations by summing stored fixed beam data at finite angular steps. Such an algorithm, based on the Bentley beam model, was evaluated by comparing calculations with measured data for an 18-MV x-ray beam. Measurements were made in a specially constructed cylindrical water phantom of 15-cm radius using a 0.1-cm3 ionization chamber for an arc of 180 degrees and for a field size of 7.2 X 7.2 cm2 at 100-cm source-axis distance. This study revealed that the Bentley beam model, with fixed beams summed every 10 degrees, predicts the dose in the treatment volume, centered about the isocenter, with an accuracy of approximately 2%. However, dose at depths between the phantom surface and the treatment volume could be underestimated by as much as 10% (3% of isocenter). This was shown to be partially due to the truncated tails of the off-axis profiles in the Bentley model, which extend only 8 mm outside the edge of the radiation field, and the large angular increment of integration (10 degrees). Using beam profiles extending to 4 cm outside the edge of the radiation field and angular steps of 5 degrees or less for summation of fixed beams reduced errors to less than 5%. Therefore, extended beam profiles and smaller angular steps for summing fixed beams are recommended for photon rotation calculation when increased accuracy is required.     

Female and male partner age and menotrophin requirements influence pregnancy rates with human menopausal gonadotrophin therapy in combination with intrauterine insemination

This study analyses the influence of female and male patient age and human menopausal gonadotrophin (HMG) requirements on clinical pregnancy rates and live birth rates with ovulation stimulation using HMG in combination with intrauterine insemination (IUI). In this study, 363 consecutive HMG/IUI treatment cycles in 184 patients carried out at a university fertility centre were analysed in a retrospective fashion. The main outcomes measured were clinical pregnancy rates and live birth rates. Increased female partner age (> or = 35) and male partner age (> or = 40) were found to negatively influence pregnancy rates with HMG/ IUI therapy. In addition, this study demonstrated a critical threshold of HMG requirements beyond which pregnancy did not occur. No pregnancies occurred in treatment cycles requiring > 25 ampoules (1875 IU) of menotrophins to achieve follicular maturity, irrespective of patient age. In conclusion, female partner age, male partner age, and HMG requirements all significantly influence pregnancy rates with HMG/IUI therapy.      

The intron 4c allele of the NOS3 gene is associated with ischemic stroke in African Americans

Background  

Ischemic stroke is the most common cause of disability in North America and in addition to the generally accepted risk factors, there is increasing evidence for the potential pathophysiological role of genes. One of these genes, the endothelial nitric oxide synthase gene (NOS3) has been reported as a genetic risk factor for ischemic stroke. To independently confirm and extend the results of these previous reports, we investigated this gene as a risk factor for stroke in an ethnically diverse study population.     

Field matching of electron beams using plastic wedge penumbra generators.

We describe the use of polystyrene wedges to match adjacent electron beams with improved dose uniformity. These wedges were designed to increase the penumbra width at the field junction from about 1.5 to about 3.5 cm, to achieve dose uniformity. Measurements using thermoluminescent dosimeters (TLD) and therapy localization film showed that the use of polystyrene wedges (penumbra generators) produced only a small increase (less than 3%) in the surface dose and a small increase (less than 1%) in the x-ray contamination. Without wedges at the field junction, lateral mismatching of beam edges by 2 or 3 mm may introduce high dose variations (120% or more or 50% or less). Similar 2-3 mm set-up errors did not cause more than +/- 5% dose variations when plastic wedges were used to match the fields. These wedges are particularly useful when matching fields of different beam energies or matching fields on curved surfaces, such as the chest wall.