Zinc sulfate addition to glass-ionomer-based cements: influence on physical and antibacterial properties, zinc and fluoride release.

OBJECTIVES: The aim of this study is to evaluate the effect of ZnSO(4) addition to a conventional glass ionomer and a resin-modified glass ionomer on solubility, flexural strength, zinc and fluoride (F) release, and Streptococcus mutans growth inhibition. METHODS: 5 or 10% ZnSO(4) was added to Vitremer and Ketac-Fil powders. Solubility test was performed based on ISO 7489. Flexural strength was determined by 3-point bending test based on ISO 4049. Zn release/uptake was determined by atomic emission spectrometry; F release/uptake was measured using a F-specific electrode. Both release measurements were performed for 15 d before and 15 d after recharging. Antibacterial test was conducted according to agar plate methods against S. mutans, by measuring the inhibition halos in 1-h and 15-d specimens. Data were analyzed by ANOVA. RESULTS: Solubility increased with higher ZnSO(4) content, but remained below the ISO 7489 limit. Flexural strength was not affected by ZnSO(4) addition, and Vitremer performed better than Ketac-Fil. The control materials released no zinc. Vitremer with 10% ZnSO(4) released the highest amount of zinc. Fluoride release was similar for Ketac-Fil and Vitremer. In both cases, the highest amounts were released in the first 24 h. The growth inhibition halo of S. mutans was similar for both materials with highest content of ZnSO(4) and occurred only with 1-h specimens. SIGNIFICANCE: Zinc addition decreased microorganisms growth and improved fluoride release, without significantly affecting the materials' flexural strength and solubility.     

Critical study of hair growth analysis with computer-assisted methods

BACKGROUND: Computer-assisted image analysis has been proposed for human hair growth studies. METHODS: The performances of Trichoscan, a commercially available automated system combining epiluminiscence microscopy with digital image analysis, developed for office-based hair growth measurements, have been evaluated comparatively on the same skin sites using standardized photographic equipment and calibrated processing for contrast-enhanced phototrichogram (CE-PTG) analysis. This reference method has been validated with scalp biopsies and histological examination of serial sectioning. RESULTS: Besides edge effects, hair fibres escaped the Trichoscan analysis for various reasons including, but not limited to, thickness, pigmentation, closeness and crossing. CONCLUSION: Most of these problems have been identified in the late 1980s and remain largely unsolved by the processing software that was evaluated in 2004. Therefore claims promoting the Trichoscan method for accurate hair measurements in clinical trials on scalp and body hair are not supported by the present investigation. The speed at which the analysis is performed is outweighed by the errors in signal detection. Therefore we suggest that improvements must be clearly documented before Trichoscan is established for quantified diagnostic purposes and detailed hair cycle monitoring during hair trials.     

双波长紫外分光光度法测定贝母中腺苷和胸苷的含量

将4种贝母的甲醇提取物经薄层色谱法粗分离后,直接用双波长紫外分光光度法测定其含量。结果表明,该方法线性关系好,腺苷和胸苷标准曲线的相关系数均为0.9999,同时也发现平贝、炉贝和伊贝中腺苷都占核苷总量60%以上,而浙贝中仅占约40%,提示贝母生药的抗凝血活性可能与贝母中核苷类化合物的种类和含量的差别有关。     

Study of talc for pharmaceutical use. Trials of pharmacopoeias

A study has been carried out on the possible pharmaceutical use of spanish talcs following the normalized assays of the main european pharmacopoeia and other quantitative methods. Only the talc nr3, not processed, meets all the assays of pharmacopoeia. The samples 2 and 4 (crushed) exceed the highest tolerated content in chlorides. The talc 1 (also crushed) only meets the loss on drying. The measures of some of these assays by using quantitative methods lead to more correct results and even sometimes in opposition with those obtained by pharmacopoeia methods. The particle size estimated by shifting and sedimentation shows that the crushed talcs are silty, whereas the only talc not processed is sandy. Considering the medium sizes estimated by scanning microscopy, it can be said that the pulverization of the talcs 1, 2 and 4 is characteristic of a micronization.