Reduced thirst in old, thermally dehydrated rats

Water intake and blood parameters of young (7-month) and old (23-month) male Brown Norway rats were assessed following a period of thermal dehydration. Rats of both ages were randomly assigned to one of three groups: (1) Unheated-blood sample, (2) Heated-blood sample, and (3) Heated-water intake. The colonic temperature of heated rats was raised at the rate of 0.05 degrees C/min for 1 h using an infrared heat lamp. Water intake was then measured over the following 2 h. The heating protocol resulted in a similar level of dehydration in both young and old rats; however, plasma osmolality and sodium concentration increased to a significant extent only in the young rats. Old rats drank significantly less water at all time points during the 2 h following the heat stress. While neither group replaced the water lost as a result of the thermal dehydration, the young rats did rehydrate to a greater extent. These results suggest that the diminished level of rehydration in aged rats, following a thermal dehydration, is due to an attenuated rise in plasma osmolality.     

Determination of capillary leakage due to recombinant interleukin-2 by means of noninvasive conductivity measurements

Summary One of the most common side effects of treatment with recombinant interleukin-2 (IL-2) is capillary leakage. Its genesis is not completely understood. The aim of the study was to determine whether capillary leakage can be monitored by means of a non-invasive conductivity technique and to study its starting point. Eight patients with advanced renal cell cancer were studied in a medium care section of the Department of Medical Oncology, University Hospital over 4 days during treatment sessions of continuous, intravenously administered IL-2 (mean dose of 15.6 × 10⁶ IU · m^–2 · day ^–1). The fluid shift from the intravascular to the extra- and intracellular compartments was monitored by means of noninvasive conductivity measurements. Changes in blood volume were calculated from serial erythrocyte counts. The clinical parameters of capillary leakage (oliguria, positive fluid balance, and gain in mass) were recorded. The mean gain in mass was 9% after 4 days of IL-2 treatment. The extracellular fluid volume increased significantly [46 (SD 23.2)%; P < 0.01], whereas the intracellular fluid volume did not change. The increase in blood volume (BV) amounted to 7% (P < 0.05). The decline in albumin concentration was significantly more than the increase in BV [38 (SD 4.3) %; P < 0.01], indicating capillary albumin leakage. The main changes were observed after the 2nd day of treatment. From this study, it is suggested that conductivity measurements are a suitable method to monitor capillary leakage induced by IL-2, and could be used to detect the exact onset and severity of this leakage. The leakage started within the first 24 h of treatment and was detected as a fluid shift from the intravascular to the extracellular space, while the intracellular compartment remained stable. These measurements could be useful during intervention studies with the aim of preventing this adverse effect of IL-2.     

Effect of temporal and spatial temperature gradients on the ampullae of Lorenzini

Summary Afferent single fiber impulses were recorded from isolated ampullae of Lorenzini of dogfishes (Scyliorhinus canicula). The ampullae were placed between two thermodes, each of which could be circulated separately with water at 12°, 18° and 24° C, thus allowing cooling and warming with various combinations of spatial temperature gradients. At constant temperature, there was a static discharge in the ampullary fibers. Cooling elicited a dynamic overshoot in frequency, followed by adaptation to a new steady state, whereas warming led to a transient inhibition. Within the limits of error the direction and slope of the spatial temperature gradient had no influence whatsoever on the static and dynamic responses of the ampullae, the only effective parameters being the temperature at the site of the receptor and the rate of temperature change with time.About 13% of the single fibers responded with bursts of impulses, interrupted by silent intervals, and 10% showed an inversed dynamic response, i.e. dynamic overshoot on warming and transient inhibition on cooling. It is possible that these patterns of activity are anomalous responses.This work was supported by the Deutsche Forschungsgemeinschaft.     

Direct measurement of the thermal responses of nude resting men in dry environments

Summary Two nude resting men were exposed for two-hour periods to each of 25 dry environments, with air temperatures ranging between 12.8° C and 49.1° C and wind speeds between 0.67 m/sec and 4.94 m/sec. The mean radiant temperature of the surroundings was kept equal to the air temperature. Rates of radiant and convective heat exchange were measured directly, separately and continuously. The men had reached a thermal steady state after 105 min in the warm environments, but not in the cold environments. Graphs are presented to show the effect of ambient temperature and wind speed on the radiation and convection rates attained after 105 min, as well as on metabolic rate, sweat evaporation rate, rectal temperature and mean skin temperature. These graphs revealed some important aspects of the behaviour of man's thermal control system. In particular the physiological conductance increased with increasing ambient temperature and then saturated at an ambient temperature near 35° C. This saturation resulted in a constant difference between rectal temperature and mean skin temperature irrespective of the environmental conditions.Published with the permission of the Chamber of Mines of South Africa.     

Noise characteristics of stainless-steel surface electrodes

Bioelectric events measured with surface electrodes are subject to noise components which may be significant in comparison with low-level biological signals such as evoked neuroelectric potentials, and myoelectric potentials. In an effort to better understand noise arising from these electrodes, electrode and measurement system noise is modelled. The effect of electrode surface area on electrode impedance and noise is studied using circular stainless-steel electrodes of varying diameters. The main contributions of the work are the development of a model for stainless-steel electrode noise as a function of electrode area, and demonstrating that, for the band-width of interest to evoked neuroelectric and myoelectric signals (8–10 000 Hz), the primary noise components are thermal and amplifier current generated. The magnitudes of both of these depend on the electrode impedance magnitude. Electrode impedance is shown to be a power function of both electrode diameter and frequency, consistent with a capacitive electrode model.     

Thermal pleasantness sensation: an indicator of thermal stress

Summary The degree of pleasantness or unpleasantness of thermal sensation aroused by a particular peripheral thermal stimulus has been shown to be an indicator of thermal state of the body in relation to the thermoregulatory set point. This phenomenon is known as thermal alliesthesia. The quantification of thermal alliesthesia was possible using two methods: (1) A set of temperature stimuli (15, 20, 25, 30, 35, and 38 C) was applied, by means of a Peltier thermode 5.5×2.7 cm², on the back of the hand, the forehead, and the back of the neck. When each stimulus had been applied for 5 s the subjects voted their degree of thermal pleasantness/unpleasantness on a psychophysical scale ranging from +2.0 for very pleasant to –2.0 for very unpleasant. (2) The subjects were also asked to adjust the Peltier thermode temperature, without looking at the temperature scale, such that the temperature (on the back of the neck) was maintained at the level the subjects considered most pleasant. The subjects also rated their general thermal comfort sensation on a five point scale ranging from +2.0 for very comfortable to –2.0 for very uncomfortable. Rectal temperature and skin temperature at eight locations were continuously recorded. Passive thermal exposures (54) were made with nine passive subjects and 42 exposures were done with working (50 watt) subjects. All exposures were carried out in a climatic chamber at a constant temperature, relative humidity (45%), and air speed (0.3 m/s). Each subject underwent 6 exposures at six room temperatures of 15, 20, 25, 30, 35, and 40 C. The results of work exposures confirmed the findings of previous studies; namely, the effect of core temperature change overrides any effect due to mean skin temperature on alliesthesial response. A mathematical function to predict the mean slope of the thermal pleasantness rating/stimulus line (a measure of the alliesthesial response) was derived using the data obtained from the passive thermal exposures. The results indicate that alliesthesial response can be used as a quantitative indicator of thermal stress.Supported by the European Coal and Steel Community, Luxembourg     

Heat and water vapour transfer of protective clothing systems in a cold environment,measured with a newly developed sweating thermal manikin

A moveable sweating thermal manikin has recently been developed. Thermal and water-vapour resistances of three kinds of cold-protective clothing ensembles, laminated with polytetrafluoroethylene, polyurethane and without a laminate were measured, with the aid of the manikin in a cold environment of 5°C with a relative humidity of 70% and an air velocity of around 1.5 m s^–1. Two sweating rates of 65 and 130 g m^–2 h^–1 were employed. Supplied heat fluxes in both of the sweat rates ranged from 350 W m^–2 to 400 W m^–2. To maintain a comfortable condition, the skin wettedness (w) (mean weighted value) had to be kept at 0.6. The measurements obtained from the manikin when testing the three ensembles were w=0.3 (approximately) for the low sweat rate and w0.6 for the high sweat rate, irrespective of the property differences among the ensembles. In addition, the condensation in the ensembles in comparison with those calculated from an analytical equation is discussed. Condensation mass fluxes in the ensembles obtained byexperiment and those from the calculation agreed sufficiently well. Thus, distribution of the condensation in the ensembles was estimated using the equation.     

Dry heat loss in incubator: comparison of two premature newborn sized manikins

Keeping premature newborns warm is crucial for their survival. Their ability to prevent excessive heat loss to the environment and to control their body temperature is limited. The risk of hypothermia is particularly important for low-birth-weight newborns with a large body surface area in relation to their mass of heat-producing tissues. The present study was performed to assess the body heat loss difference between small and large body-size premature newborns using two anthropomorphic thermal manikins of premature newborns of 900 g and 1,800 g (respective body surface areas of 0.086 and 0.150 m²). The dry heat loss from the six body segments of the small manikin (S) was measured and compared with that of the large manikin (L). The two manikins were exposed to five different environmental temperatures ranging between 29 and 35°C in a single-walled, air-heated closed incubator. The magnitudes of heat loss decreased significantly by 20.4% between the two manikins [small manikin 110.1 (44.3) W/m² vs large manikin 87.6 (25.8) W/m², mean values with one standard deviation]. The results obtained from the comparison of the heat loss measures from the two manikins confirm the fact that the heat loss increases with an increase in the ratio of the body surface area to body mass. The thermal manikin appears to provide an accurate method for the assessment of thermal conditions in neonatal care.