具有三层管壁结构组织工程血管支架的生物力学性能

目的针对组织工程血管的体内培养技术路线，对所制备的具有三层管壁结构的组织工程血管支架的生物力学性能进行测试，并研究了壁厚对支架力学性能的影响，以保证后续的动物体内移植实验能顺利进行。方法采用涂敷，喷涂．滤沥的方法制备了具有三层管壁结构（多孔PLGA层．致密PU层．多孔PLGA层）的可降解组织工程血管支架，用自制的设备测试了其爆破强度和径向顺应性，并对血管支架进行了缝合强度的测试。结果所制备的厚度为0．295mm-0．432mm的三层结构血管支架的径向顺应性为3．80％／100mmHg-0．57％／100mmHg，爆破强度为160kPa～183kPa，缝合强度为0．63N／针～1．52N／针。结论支架的管壁厚度，尤其是中间层厚度，对支架的力学性能有重要影响。增大壁厚可导致径向顺应性急剧下降，爆破强度和缝合强度线性提高。在所制备的样品中，管壁厚度为0．295mm的支架其综合力学性能最优，可满足血管组织工程体内植入的力学性能要求。     

A nonlinear model of the arterial vessels within a limb segment

The relationship between the arterial blood pressure and the volume of the arteries within a segment of an extremity is nonlinear. The present paper shows how the flow and volume pulsations of the arteries within a limb segment can be simulated taking this property into account. An electrical model was constructed comprising one resistor and two voltage dependent ‘capacitors’, the latter corresponding to the pressure dependent elasticity, or compliance, of the arteries. Adequate simulations were obtained over a wide pressure range, which is impossible with linear models. The nonlinear, i.e. pressure dependent, relationship between the volume and pressure of arteries, observed under static conditions, must also be taken into consideration when studying pulsatile events with models whether mathematical or physical.     

Responses of sacral visceral afferents from the lower urinary tract,colon and anus to mechanical stimulation

The discharge characteristics of sacral visceral afferents supplying the urinary bladder, urethra, colon and anus to mechanical stimuli were analyzed in the anaesthetized cat. The stimuli used were passive distension (urinary bladder, colon), isovolumetric contraction (urinary bladder), movements of the urethral catheter and mechanical shearing stimuli (mucosal skin of the anal canal). (1) In total 245 afferent units which projected in the pelvic nerve were isolated from the sacral dorsal roots. From one of the following organs, urinary bladder, colon, urethra and anus 117 afferent units were activated. By these stimuli from the bladder, urethra and anus 122 afferent units could not be activated, and as far as tested also not from the colon; in 6 afferent units the classification was unclear. (2) Afferent units from the urinary bladder and the colon responded consistently to passive distension of the respective organ. The units from the urinary bladder showed graded responses at intraluminal pressures of about 10–70 mm Hg and responded also to isovolumetric contractions of the organ. The thresholds of the units from the bladder to passive distension and contraction varied from about 5 to 20 mm Hg intravesical pressure. (3) The afferent units from the urethra and the anus did not react or showed some weak phasic and irregular responses to distension and contraction applied to the urinary bladder or to distension of the colon. They were consistently excited by low threshold mechanical stimulation of the urethra and anus, respectively. (4) The axons from the bladder, urethra and anus were presumably myelinated (conduction velocity above 2 m/s) and conducted at 10.3±6.1 m/s (n=34, mean±SD), 26.3±9.3 m/s (n=13) and 9.5±5.1 m/s (n=37), respectively. The axons from the colon conducted at about 0.5 to 16 m/s (n=20), 13 of them conducting at less than 2 m/s. About 75% of the axons which could not be activated by mechanical stimulation of the visceral organs were presumably unmyelinated (conduction velocity below 2 m/s). (5) Some ongoing activity was found in 9 out of 26 afferent units from the anus but, with one exception, the afferent units from the bladder, urethra and colon were silent. (6) It is concluded that the pelvic afferent units from the urinary bladder, urethra, colon and anus consist of distinct populations with characteristic response patterns. There is no indication from this investigation that the urinary bladder is supplied by sacral afferents which are only recruited at high intravesical pressures during passive distension and isovolumetric contractions and which are possibly associated with pain.Supported by the Deutsche Forschungsgemeinschaft     

Contractile properties of single motor units in two multi-tendoned muscles of the cat distal forelimb

Summary The contractile properties of motor units (MUs) in two multi-tendoned forelimb muscles were investigated. In anesthetized cats single MUs of the extensor carpi ulnaris (ECU) and extensor digitorum communis (EDC) muscles were selectively activated by stimulation of cervical ventral root filaments. MUs were characterized by various tests including single twitches, series of tetanic contractions providing a tension-frequency relation and a fatigue test. They were classified by the parameters contraction time (CT, time-to-peak within unpotentiated single twitches) and fatigue-index (R_B, according to Burke). The ECU muscle is composed of 38% type FR MUs (fast, fatigue-sensitive; CT<38 ms; R_B<0.5), 35% type FR MUs (CT<38 ms, R_B>0.5) and 27% type S MUs (slow; CT>38 ms, R_B>0.5). 46% of the EDC MUs were classified as FF (R_B0.25), 29% as FI (fast, intermediately fatiguable; 0.25<R_B<0.75) and 25% as FR/S (fatigue-resistant, fast or slow; R_B>-0.75). The latter group was devised since most MUs appeared as fast and the unequivocal presence of slow MUs could neither be demonstrated nor excluded. Normalized tension-frequency relations of fast ECU and EDC MUs were nearly identical and similar to those reported for fast MUs of other muscles. In contrast to this, the tension-frequency relation of slow ECU MUs has a different shape supporting the use of this function to distinguish fast from slow MUs. The distribution of different types of MUs is discussed with regard to the structure and function of the parent muscles and in relation to hindlimb muscles of comparable architecture. As revealed by comparison to EMG data gained in behaving animals (Fritz et al. 1985; Hoffmann et al. 1986, Botterman et al. 1985), the three muscles of the cat distal forelimb investigated so far seem to be adapted to different tasks: the EDC to rapid movements with a high proportion of type FF MUs, flexor carpi radialis to sustained contractions during the body support with a high proportion of fatigue-resistant MUs; the ECU which changes synergism between both muscles has an intermediate composition.     

Tensile Tests of Collagen Fibers Obtained from the Rabbit Patellar Tendon

Tensile properties of collagen fibers of approximately 1 m in diameter were determined using a newly developed micro tensile test system for cells and fine fibrous biological tissues. The test system consists of a thermostatic test chamber, an inverted microscope, micromanipulators, a direct drive linear actuator, a cantilever-type load cell, and a video dimension analyzer (VDA). The fibers were isolated with a mechanical method from collagen fascicles (approximately 300 m in diameter) cut out from the rabbit patellar tendon. The ends of each fiber were attached to the tips of a pair of glass microtubes (15 to 20 m in outer diameter) using a cyanoacrylate adhesive. One of the microtubes was attached to the load cell; the other one was connected to the linear actuator which was utilized to stretch the fiber. Load applied to the fiber was measured with the load cell, while its elongation was determined with the VDA using the images of the edges of the adhesive as markers. Tangent modulus, tensile strength, and strain at failure of the tested fibers were 54.3± 25.1 MPa, 8.5± 2.6 MPa, and 21.6± 3.0%, respectively. These values were much different from those of collagen fascicles (300 m in diameter) cut out from the rabbit patellar tendon and also from those of the bulk patellar tendon (Trans. ASME, J. Biomech. Eng. 121, 124–294, 1999); for example, tensile strength and strain at failure of the fibers were approximately 50 and 200% of those of the fascicles, respectively. These results suggest that the mechanical interactions between fibers and between fibers and ground substances contribute much to the mechanical properties of collagen fascicles and bulk tendons.     

Patient-ventilator interaction: A general model for nonpassive mechanical ventilation

A general mathematical model for the dynamic behaviour of asingle-compartment respiratory system in response to an arbitraryapplied inspiratory airway pressure and arbitrary respiratorymuscle activity is investigated. The model is used to computeexplicit expressions for ventilation and pressure variablesof clinical interest for clinician-selected and impedance-determinedinputs. The outcome variables include tidal volume, end-expiratorypressure, minute ventilation, mean alveolar pressure, averagepleural pressure, as well as the work performed by the ventilatorand the respiratory muscles. It is also demonstrated that undersuitable conditions, there is a flow reversal that can occurduring inspiration.     

Relations between chronic stimulation-induced changes in contractile properties and the Ca2+-sequestering system of rat and rabbit fast-twitch muscles

This study compares changes in contractile properties, Parvalbumin content, and Ca²⁺-uptake by the sarcoplasmic reticulum (SR) of low-frequency stimulated rat and rabbit tibialis anterior (TA) muscles. Time to peak tension increased 1.8-fold in 35-day stimulated rabbit TA, while no change occurred in rat TA. Isometric twitch tension increased 2-fold in rabbit TA, but was unaltered in rat TA. Parvalbumin (PA) content was more than 90% reduced in rabbit TA, but only 60% in rat TA after 35 days. At this time, PA content of the stimulated rat TA was still higher than that of normal rabbit TA. Taking into account the suggested role of PA as a cytosolic Ca²⁺ buffer, its decrease could lead to an impaired free Ca²⁺-decay with a prolonged active state and a higher tension output during a single twitch. This would explain why chronic stimulation led to an increase in isometric twitch tension in rabbit TA, but not in rat TA. The 1.6-fold rise in half-relaxation time of 35-day stimulated rat and rabbit TA most likely resulted from a 50% reduced Ca²⁺-uptake by the SR, due to a still unknown modification of the Ca²⁺-transport ATPase.     

内骨架一体化小腿假肢的生物力学研究

一体化假肢是以聚合物为材料从接受腔到假腿一体成型的新型下肢假肢，它比传统型假肢更经济、美观、轻便，具有较大的应用前景。目前的相关研究主要集中在设计与制作及少量的临床研究方面。由于一体化假肢与传统型假肢在结构上的差异，有必要对其进行应力分析。本研究的目的是开展内骨架一体化假肢的生物力学研究，本研究基于内骨架一体化小腿假肢的真实几何构型，建立三维有限元模型，计算该模型在模拟Heel OH步态时相的载荷作用下的应力分布；在保持该模型的几何形状不变的情况下，建立了三个不同壁面厚度的一体化小腿假肢的有限元模型，分析壁面厚度对一体化小腿假肢应力分布的影响；通过分别赋予模型四种不同高分子聚合物的材料力学特性值，分析不同材料的一体化假肢的应力分布特点；分别对模型施加与正常步态的五个典型时相对应的载荷，分析一体化小腿假肢在各步态时相的应力分布特点。本研究结果对一体化假肢设计有指导价值。     

Flexible versus rigid endoscopes for outpatient hysteroscopy: a prospective randomized clinical trial

To evaluate patient acceptance, optical properties and the clinical feasibility of flexible compared with rigid hysteroscopes, 142 patients undergoing outpatient hysteroscopy were included in a prospective, randomized clinical trial. The flexible hysteroscope was used in 70 patients, and the rigid instrument in 72. At different stages of the hysteroscopy the level of pain experienced by the women was assessed using a 10 cm visual analogue scale. Optical properties characterized by the parameters intrauterine visibility, hysteroscopic view and diagnostic accuracy were ranked by the surgeons using a 5-point scale (1 = excellent to 5 = insufficient), and duration of the hysteroscopy was measured. Hysteroscopy was successful in 87.5 and 100% of patients in the flexible and rigid groups respectively. With the use of rigid telescopes, discomfort at introduction and during the hysteroscopy was significantly greater (median 1.7 versus 0.7, P = 0.003; 3.1 versus 1.2, P < 0.001 respectively), but optical properties were judged to be far superior (P < 0.001 for all three comparisons) and procedure time was significantly shorter (median 70 versus 120 s, P = 0.003). In conclusion, outpatient hysteroscopy seems to be less painful when using flexible telescopes. However, rigid hysteroscopes provide superior optical qualities and permit a more rapid performance with higher success rates at much lower cost.     

兔眼虹膜组织力学特性的实验研究

利用我们创建的将兔眼蝉孔水密缝合后，模拟眼内前后房压强差，对虹膜整体进行加压的实验方法，对兔眼虹膜的力学特性进行了实验研究。结果表明：兔眼虹膜是典型的粘弹性物质；面积模量与前后方压强差之间基本成线性关系。实验结果可为青光眼致盲机制解释和瞳孔阻滞力的估算提供参考。