克痛喷剂的质量标准研究

采用薄层色谱法对克痛喷剂中蟾酥、冰片、大黄、栀子、白芷进行定性鉴别；并应用气相色谱法对冰片的含量进行测定。实验结果证明方法简便，斑点圆整，重现性及专属性均好，可国该制剂的质量控制标准。     

用三参量模糊分析法识别潜水减压气泡信号的研究

目的 探讨潜水减压多普勒超声气泡信号的模糊识别方法。方法 根据气泡信号的频谱分布特征，构建f-f-△p三参量模糊算法，并通过减压病动物模型进行验证，同时对66例氦氧150m饱和-180m巡回潜水减压的数据进行检测。结果 在减压病动物模型中分别检测到I～Ⅱ级气泡(按Spencer分级标准)，气泡数量6～113个／3s内不等；在饱和潜水减压资料中，检测到1人两次有I级气泡音，气泡数量分别为3个(11s录音)与6个(17s录音)，与人工监听结果基本一致。结论 用三参量模糊分析方法充分借鉴了多年来人工分析所积累的经验，同时利用了计算机辅助分析技术，气泡信号的检测分析较为准确客观。     

Techniques in facial identification: Computer-aided facial reconstruction using a laser scanner and video superimposition

A facial image was reconstructed from the skull, part of a complete skeleton found in woodland, of a male person who had hanged himself from a tree. In addition, video superimposition was carried out with antemortem photographs of a person suspected of being the victim, and a good match was obtained. In a further case, a cheaper video-transparency superimposition was carried out, with identity later being confirmed on the basis of dental records. The techniques and the problems encountered are discussed. According to our experience, 3D computer reconstruction and video superimposition have a useful role in the process of identification, particularly in the early stages of an investigation and when other more definitive methods may not be available.     

Development of a real-time fluorescence resonance energy transfer PCR to identify the main pathogenic Campylobacter spp.

A simple real-time fluorescence resonance energy transfer (FRET) PCR, targeting the gyrA gene outside the quinolone resistance-determining region, was developed to identify Campylobacter jejuni and Campylobacter coli. These species were distinguished easily, as the corresponding melting points showed a difference of 15 degrees C. A second assay using the same biprobe and PCR conditions, but different PCR primers, was also developed to identify the less frequently encountered Campylobacter fetus. These assays were applied to 807 Campylobacter isolates from clinical specimens. Compared to phenotypic identification tests, the FRET assay yielded the same results for all except three of the isolates. Analysis by standard PCR and 16S rDNA sequencing demonstrated that two of these isolates were hippurate-negative C. jejuni strains, resulting in an erroneous phenotypic identification, while the third was an isolate of C. coli that contained a gyrA gene typical of C. jejuni, resulting in misidentification by the FRET assay. The FRET assay identified more isolates than standard PCR, which failed to yield amplification products with c. 10% of isolates. It was concluded that the FRET assays were rapid, reliable, reproducible and relatively cost-efficient, as they require only one biprobe and can be performed directly on boiled isolates.     

Identification of antigenic epitopes in the haemagglutinin protein of H7 avian influenza virus

ABSTRACT

The H7 subtype avian influenza virus (AIV) has been reported to infect not only poultry but also humans. The haemagglutinin (HA) protein is the major surface antigen of AIV and plays an important role in viral infection. In this study, five monoclonal antibodies (mAbs, 2F8, 3F6, 5C11, 5E2 and 5C12) against the HA protein of H7 virus were produced and characterized. Epitope mapping indicated that ¹⁰³RESGSS¹⁰⁷ was the minimal linear epitope recognized by the mAbs 2F8/3F6/5C11, and mAbs 5E2/5C12 recognized the epitope 103-145aa. The protein sequence alignment of HA indicated that the two epitopes were not found in other subtypes of AIV, and none of the five mAbs cross-reacted with other subtypes, suggesting these mAbs are specific to H7 virus. The epitope ¹⁰³RESGSS¹⁰⁷ was highly conserved among Eurasian lineage strains of H7 AIV, whereas three amino acid substitutions (E104R, E104K and E104G) in the epitope occurred in 98.44% of North-American lineage strains. Any of these single mutations prevented the mutated epitope from being recognized by mAbs 2F8/3F6/5C11; thus, these mAbs can distinguish between Eurasian and North-American lineages of H7 strains. Furthermore, the mAbs 2F8, 3F6 and 5C11 could be highly blocked with H7-positive serum in blocking assays, revealing that ¹⁰³RESGSS¹⁰⁷ may be a dominant epitope stimulating the production of antibodies during viral infection. These results may facilitate future investigations into the structure and function of HA protein, as well as surveillance and detection of H7 virus.

RESEARCH HIGHLIGHTS

• Five mAbs against HA protein of H7 AIV were generated and characterized.

• Two novel epitopes ¹⁰³RESGSS¹⁰⁷ and 103-145aa were identified.

• The epitope ¹⁰³RESGSS¹⁰⁷ differs between Eurasian and North-American lineages.

• The mAbs 2F8, 3F6 and 5C11 could distinguish two lineages of H7 strains.

     

Determination of rate-constants as a method to describe passive expiration

To describe the relaxed expiration by a two-compartment model, we introduced a gas/energy transfer between the lung compartment (V₁) and a second one (V₂). If V₂ were a real volume, the rate-constants (i.e. the flow/volume ratios) of the compartments would describe a real gas-exchange. Alternatively, if a viscoelastic behaviour of the lung or an energy-exchange between compartments was simulated, V₂ would become a "pseudo-volume". We studied nine mechanically ventilated subjects. Changes in volume were transduced by respiratory inductive plethysmography. The rate-constants were assumed (together with the initial volumes of the compartments) as parameters to fit the total volume [V₁(t)+V₂(t)]. Once the best fitting was performed using these "physiological" parameters, the system was directly identified and the compartments were independently analysed. The time profile of the second compartment showed a maximum that depended on the value of the rate-constants. Appropriate tests confirmed the reliability of our procedure. In conclusion, our analysis demonstrated that the energy/volume of the second compartment may increase at the beginning of expiration and then decrease, showing a maximum, even though the total curve can only be a decreasing one. In other words, the slowing down of the curve representing expiratory volume is due not only to the longer emptying of the second compartment, but also to the interaction between the two compartments. As presently proposed, this interaction can be represented by either a gas exchange between two actual volumes, or a mechanical energy transfer between the lung and the tissue compartment.     

Analysis of dynamic cerebral autoregulation using an ARX model based on arterial blood pressure and middle cerebral artery velocity simulation

The study aimed to model the cerebrovascular system, using a linear ARX model based on data simulated by a comprehensive physiological model, and to assess the range of applicability of linear parametric models. Arterial blood pressure (ABP) and middle cerebral arterial blood flow velocity (MCAV) were measured from 11 subjects non-invasively, following step changes in ABP, using the thigh cuff technique. By optimising parameters associated with autoregulation, using a non-linear optimisation technique, the physiological model showed a good performance (r=0.83±0.14) in fitting MCAV. An additional five sets of measured ABP of length 236±154 s were acquired from a subject at rest. These were normalised and rescaled to coefficients of variation (CV=SD/mean) of 2% and 10% for model comparisons. Randomly generated Gaussian noise with standard deviation (SD) from 1% to 5% was added to both ABP and physiologically simulated MCAV (SMCAV), with ‘normal’ and ‘impaired’ cerebral autoregulation, to simulate the real measurement conditions. ABP and SMCAV were fitted by ARX modelling, and cerebral autoregulation was quantified by a 5 s recovery percentage R5% of the step responses of the ARX models. The study suggests that cerebral autoregulation can be assessed by computing the R5% of the step response of an ARX model of appropriate order, even when measurement noise is considerable.     

Determining appropriate models for joint control using surface electrical stimulation of soleus in spinal cord injury

The mechanical impedance of the ankle joint during electrical stimulation of the soleus is studied by applying constant-velocity 10° angular perturbations to the ankle and measuring the resultant torque. Both neurologically intact subjects and spinal cord injured subjects are tested. Lumped, piecewise linear models are developed to predict the torque from the measured displacement and acceleration signals. The commonly used second-order mass-spring-dashpot model fails to predict the changes in torque that occur following imposed movements. A fiveelement, directionally-dependent piecewise linear model is much better at predicting the measured responses for velocities up to 50° s⁻¹. Numerical least squared error indentification techniques are used to estimate the model parameters for three neurologically intact and three spinal cord injured subjects. The average error between the model’s response and the measured response across all subjects is 10·9%. There is some evidence that a velocity-dependent non-linear model could produce better results than the directionally-dependent piecewise linear model.     

Dynamic relationship between EMG and torque at the human ankle: Variation with contraction level and modulation

Stochastic system identification techniques were used to determine the dynamic relationship between the electromyogram (EMG) and torque in the ankle muscles of normal human subjects. EMG and torque were recorded while subjects modulated ankle torque by tracking a computer-generated stochastic waveform. Nonparametric impulse response functions (IRFs) relating EMG to ankle torque were computed and parameterised by determining the parameters of the second-order system which provided the best least-squares fit. Two sets of experiments were carried out. In the first, the mean level of torque was varied from 5 per cent of the maximum voluntary contraction (MVC) to 30 per cent MVC while the depth of modulation was held constant at ±5 per cent of MVC. In the second series of experiments the mean torque was held constant at 25 per cent MVC while the depth of modulation was varied from ±2.5 per cent to ±25 per cent. The major findings were: (1) A second-order, low-pass filter provided a good quasilinear model of the EMG/force dynamics under all conditions; (2) The model parameters depended only weakly on the mean level of torque; (3) In contrast, the model parameters depended strongly on the amplitude with which the contraction was modulated; the natural frequency increased significantly with the depth of modulation.