Highly sensitive p-type 4H-SiC van der Pauw sensor

This paper presents for the first time a p-type 4H silicon carbide (4H-SiC) van der Pauw strain sensor by utilizing the strain induced effect in four-terminal devices. The sensor was fabricated from a 4H-SiC (0001) wafer, using a 1 μm thick p-type epilayer with a concentration of 10¹⁸ cm⁻³. Taking advantage of the four-terminal configuration, the sensor can eliminate the need for resistance-to-voltage conversion which is typically required for two-terminal devices. The van der Pauw sensor also exhibits an excellent repeatability and linearity with a significantly large output voltage in induced strain ranging from 0 to 334 ppm. Various sensors aligned in different orientations were measured and a high sensitivity of 26.3 ppm⁻¹ was obtained. Combining these performances with the excellent mechanical strength, electrical conductivity, thermal stability, and chemical inertness of 4H-SiC, the proposed sensor is promising for strain monitoring in harsh environments.

This paper presents for the first time a p-type 4H silicon carbide (4H-SiC) van der Pauw strain sensor by utilizing the strain induced effect in four-terminal devices.     

Polypyrrole/tannin biobased nanocomposite with enhanced electrochemical and physical properties

In this research, tannin (TA) extracted from Acacia mangium and a cationic surfactant, cetyltrimethylammonium bromide (CTAB), were used to modify and enhance the physical and electrochemical properties of a polypyrrole (PPy) composite. Brunauer–Emmett–Teller (BET) analysis presented a higher degree of surface area and porosity for the PPy/TA/CTAB nanocomposite. A highly porous and rod like structure with a lumpy surface was observed for PPy/TA prepared in the presence of CTAB by Field Emission Scanning Electron Microscopy (FESEM) and Transmission Electron Microscopy (TEM). Cyclic voltammograms of the modified SPE electrode using PPy/TA/CTAB displayed an enhanced current response compared to the electrode modified with only PPy or PPy/TA. Electrochemical Impedance Spectroscopy (EIS) exhibited a lower value of charge transfer resistance (R_ct) and higher electron transfer for the modified electrode, making the nanocomposite a promising candidate for biosensor application.

Tannin (TA) extracted from Acacia mangium and a cationic surfactant, cetyltrimethylammonium bromide (CTAB), were used to modify and enhance the physical and electrochemical properties of polypyrrole (PPy) composite.     

Salbutamol in acute organophosphorus insecticide poisoning – a pilotdose-response phase II study

Background: Treatment of acute organophosphorus (OP) insecticide poisoning is difficult, with many patients dying despite best care. Pre-clinical studies have shown benefit from salbutamol, possibly due speeding alveolar fluid clearance or reducing bronchoconstriction. In this small pilot dose-response study, we aimed to explore whether addition of nebulized salbutamol to standard care might improve resuscitation.

Methods: We performed a single-blind phase II study comparing the effect of two different doses of nebulized salbutamol versus saline placebo, in addition to standard treatment. Primary outcome was oxygen saturations over the first 60?min of resuscitation; secondary outcomes included heart rate, incidence of dysrhythmias, time to ‘atropinization’, atropine dose required, and mortality.

Result: Seventy-five patients were randomized to receive 5?mg (Salb5, n?=?25) or 2.5mg (Salb2.5, n?=?25) of salbutamol, or saline placebo (NoSalb, n?=?25), by nebulizer. Oxygen saturations did not differ between groups over the first 60?min of resuscitation (median AUC NoSalb: 1376 [95% CI 1282 to 1470], Salb2.5: 1395 [1305 to 1486], Salb5: 1233 [1100 to 1367]; p?=?.9898). Heart rate was also similar across the three arms. Median time to full atropinization, and atropine dose required, were the same for all three arms (NoSalb 15.0 [10–16] min and 12.6 [8.0–13.4] mg, Salb2.5 15.0 [10–16] min and 12.6 [9.3–16.8] mg, and Salb5 15.0 [10–20] min and 12.6 [10.7–20.6] mg; p?=?.4805 and p?=?.1871, respectively). Three (12%) patients died in the Salb2.5 and Salb5 groups and two (8%) in the NoSalb group.

Conclusion: This pilot study, within the limitations of its small size and variation between patients, found no apparent evidence that administration of nebulized salbutamol improved resuscitation of patients with acute OP insecticide self-poisoning. The data obtained provides a basis to design further studies to ultimately test the role of salbutamol in OP insecticide poisoning.     

Recent progress in biochar-supported photocatalysts: synthesis,role of biochar,and applications

Incorporating photocatalytic nanoparticles with biochar templates can produce biochar-supported photocatalysts (BSPs) and combine the advantages of biochar with catalytic nanoparticles. The obtained composite exhibits excellent surface properties, crystallinity, chemical stability, recoverability, and higher photocatalytic competency than the bare semiconductor photocatalyst. The literature and advances in BSPs based on the combination of low-cost biochar and catalytic nanoparticles are presented in this review. Various synthetic techniques and physicochemical properties of BSPs are summarized. The article then discusses in detail the important role of biochar in influencing the photocatalytic performance of BSPs such as supporting nanoparticles, increasing the surface area and the number of active sites, shuttling electrons, acting as an electron reservoir, increasing charge separation, and reducing band gap energy. Furthermore, the synergistic effects of adsorption and photodegradation of organic pollutants by BSPs are discussed with in-depth mechanistic evidence. Finally, the application of BSPs in various fields and constructive suggestions for their future development are reported.

Incorporating photocatalytic nanoparticles with biochar templates can produce biochar-supported photocatalysts (BSPs) and combine the advantages of biochar with catalytic nanoparticles.     

3T multiparametric MR imaging,PIRADSv2-based detection of index prostate cancer lesions in the transition zone and the peripheral zone using whole mount histopathology as reference standard

Abdominal Radiology - To evaluate 3T mpMRI characteristics of transition zone and peripheral zone index prostate cancer lesions stratified by Gleason Score and PI-RADSv2 with whole mount...     

Enhanced removal of hexavalent chromium from aqueous media using a highly stable and magnetically separable rosin-biochar-coated TiO2@C nanocomposite

Recently, nanosized metal-oxides have been extensively investigated for their ability to remove metal ions from aqueous media. However, the activity and capacity of these nanosized metal-oxides for removing metal ions decrease owing to their agglomeration in aqueous media. Herein, we synthesized a highly stable and magnetically separable rosin-biochar-coated (RBC) TiO₂@C nanocomposite through a facile and environment-friendly wet chemical coating process, followed by a one-step heating route (pyrolysis) for efficient removal of Cr(vi) from aqueous solution. An array of techniques, namely, TEM, HRTEM, TEM-EDS, XRD, FTIR, VSM, BET and TGA, were used to characterize the prepared nanocomposite. The pyrolysis of rosin into biochar and the fabrication of Fe onto the RBC-TiO₂@C nanocomposite were confirmed by FTIR and XRD examination, respectively. Moreover, TEM and HRTEM images and elemental mapping using TEM-EDS showed good dispersion of iron and carbon on the surface of the RBC-TiO₂@C nanocomposite. Sorption of Cr(vi) ions on the surface of the RBC-TiO₂@C nanocomposite was very fast and efficient, having a removal efficiency of ∼95% within the 1^st minute of reaction. Furthermore, thermodynamic analysis showed negative values of Gibb''s free energy at all five temperatures, indicating that the adsorption of Cr(vi) ions on the RBC-TiO₂@C nanocomposite was favorable and spontaneous. Conclusively, our results indicate that the RBC-TiO₂@C nanocomposite can be used for efficient removal of Cr(vi) from aqueous media due to its novel synthesis and extraordinary adsorption efficacy during a short time period.

A biochar-coated RBC-TiO₂@C nanocomposite was synthesized using a wet chemical coating followed by a one-step heating route (pyrolysis) for the efficient removal of Cr(vi).     

Microbiota That Affect Risk for Shigellosis in Children in Low-Income Countries

Pathogens in the gastrointestinal tract exist within a vast population of microbes. We examined associations between pathogens and composition of gut microbiota as they relate to Shigella spp./enteroinvasive Escherichia coli infection. We analyzed 3,035 stool specimens (1,735 nondiarrheal and 1,300 moderate-to-severe diarrheal) from the Global Enteric Multicenter Study for 9 enteropathogens. Diarrheal specimens had a higher number of enteropathogens (diarrheal mean 1.4, nondiarrheal mean 0.95; p<0.0001). Rotavirus showed a negative association with Shigella spp. in cases of diarrhea (odds ratio 0.31, 95% CI 0.17–0.55) and had a large combined effect on moderate-to-severe diarrhea (odds ratio 29, 95% CI 3.8–220). In 4 Lactobacillus taxa identified by 16S rRNA gene sequencing, the association between pathogen and disease was decreased, which is consistent with the possibility that Lactobacillus spp. are protective against Shigella spp.–induced diarrhea. Bacterial diversity of gut microbiota was associated with diarrhea status, not high levels of the Shigella spp. ipaH gene.