胸部气道的CT研究

作者采用自己设计的两种扫描方法与常规扫描方法对照对６７例患者的正常气道的ＣＴ表现进行分析，比较不同扫描方法在显示气道方面的优劣。结果显示：常规ＣＴ扫描方法能显示大部分支气管分枝，最远可分辨亚段支气管，但对右侧Ｂ４、Ｂ５，左侧Ｂ２、ＬＢ、Ｂ４、Ｂ５及两侧Ｂ７、Ｂ８显示差；扫描架向头侧倾斜２５°能明显改善右侧Ｂ４、Ｂ５，左侧ＬＢ、Ｂ４、Ｂ５的显示情况。     

有机药物化学中不对称合成手性产率及其随温度变化规律的研究

本文首次用分子力学计算产物或过渡态分子内张力能来估算热力学或动力学,控制不对称合成反应生成的立体异构体的相对比例,并从热力学上推导了这一比例随温度变化公式,而且从实验上得到证明,在有机或药物化学最富有挑战性的领域——不对称合成中具有重要的理论和实际意义。     

冠心病患者血脂异常与胰岛素抵抗的关系

目的 :探讨冠心病患者血脂异常与胰岛素抵抗的关系。方法 :观察 68例冠心病患者与 66例对照者的血脂、血糖、胰岛素等生化指标 ,以胰岛素释放指数———空腹胰岛素 (FIns) /空腹血糖 (FBG)和胰岛素敏感指数(1 /FBG×FIns)作为胰岛素抵抗 (IR)的指标 ,与空腹血脂进行直线相关分析。结果 :冠心病组与对照组对比 ,血糖水平无明显差异 (P >0 .0 5) ,而血胰岛素、胰岛素释放指数明显较对照组增高 (P <0 .0 5) ,胰岛素敏感指数明显较对照组低 (P <0 .0 5)。冠心病组的甘油三酯 (TG)、总胆固醇 (TC)、低密度脂蛋白胆固醇 (LDL -C)明显较对照组增高 (P <0 .0 5)、高密度脂蛋白胆固醇 (HDL -C)明显较对照组低 (P <0 .0 5)。冠心病组胰岛素释放指数、胰岛素敏感指数分别与TG ,TC和LDL -C呈正相关 ,与HDL -C呈负相关。结论 :冠心病患者存在着高胰岛素血症和胰岛素抵抗 ,而且冠心病患者的胰岛素抵抗和血脂异常密切相关。     

电脑控制连续式料位仪的研制

论述了电脑控制连续式料位仪的原理及性能，研制了一种先进可靠的物料料位测量工具。     

Quantitative analysis of the tomographic technetium-99m MIBI (99mTc-MIBI) myocardial bullseye display: Application to diagnosis of coronary artery disease

Summary In this study, the^99mTc-MIBI myocardial bullseye display of 31 healthy persons and 34 patients with myocardial ischemia and 17 patients with myocardial infarction were analyzed quantitatively, and compared with the results of myocardial tomography analysis and qualitative bullseye analysis. The sensitivities of the three methods were 88.2%, 91.2% and 94.1% respectively (P>0.05), and the specificities were 93.5%, 83, 9% and 83.9% respectively (P<0.05). On the other hand, the quantitative analysis obviously outperformed the other two methods in the detection of ischemic segments of myocardhum near infarction zone (P<0.01). The quantitative analysis of^99mTc-MLBI myocardial bullseye (quantitative bullseye) was an objective, specific and sensitive method for diagnosis of coronary artery disease.     

氩激光治疗中心性浆液性脉络膜视网膜病变

应用氩绿激光光凝治疗中心性浆液性脉络膜视网膜病变36例41只眼。结果视力≥1.0者从术前的17.1％增加到术后的63.5％,而视力≤0.6者从术前的61％降低到术后14.6％,术后1周至1月,多数患眼视网膜下液全部吸收,部分患眼中心凹反光重显。结果还显示术后视力与病程长短有关,但术后视力与渗漏点的方位、渗漏点中心凹距离以及神经上皮脱离的大小无关。     

粮谷尘致肺损害的实验研究

粮谷尘为混合性粉尘，含游离ＳｉＯ２９．７７％，分离培养出普通高温放线菌。染尘动物肺脏早期病变主要为小灶性肺泡炎、灶性间质性肺炎、异物肉芽肿等，大、中支气管壁脱颗粒肥大细胞增多。９０ｄ以后，上述病变明显减少，但逐渐出现少数小的细胞结节，间质轻度纤维组织增生、支气管慢性炎症和小叶中央型肺气肿样病变，观察１ａ（年）未见明显纤维化。     

微波等离子体化学气相沉积合成TiN超细颗粒

热力学计算表明，Ｈ２，Ｎ２的过量有助于提高ＴｉＮ的产率，但能耗也相应增加。为此考察了温度，流量，ＴｉＣｌ４携带量，混合方式对产物性能的影响。结果表明，流量增加，温度升高，ＴｉＣｌ４携带量增加，混合愈好，则产物粒径愈小。在此基础上采用微波等离子体化学气相沉积法，合成了粒径为１２３－２８４ｎｍ的ＴｉＮ超细颗粒     

The fit of fixed partial dentures joined by infrared soldering.

This study determined the accuracy of fit of three-unit fixed partial dentures joined by an infrared soldering technique compared with one-piece fixed partial denture castings and individually cast crowns. Wax patterns of prepared Ivorine teeth, maxillary left central incisor and maxillary left canine, were injection molded; a plastic rod was used as a pontic. One group of patterns was cast as one-piece dentures; the other group was sectioned in the connector area, cast individually and then joined by infrared soldering. Castings were seated on their respective dies, embedded in epoxy resin, and sectioned. Gap distances between the casting and the die were measured at specified marginal sites with a profile projector. Results showed that the fit of infrared-soldered fixed partial dentures was significantly better than that of one-piece castings and was comparable with the fit of single crowns. The gap openings measured in all castings were within the range of clinical acceptability.