正常人眼球直肌Pulley功能位置的动态磁共振成像研究

目的研究正常人眼球运动动态磁共振成像（MRI）4条直肌Pulley（滑车）的功能性位置。方法采用西门子公司Sonata1.5T超导型MRI扫描仪,应用眼球运动动态MRI技术,获取20名正常人（20个眼眶）眼球原在位及上转、下转、内转、外转20度时垂直于眶轴的眼眶冠状位MRI图像。以眼球中心为原点建立三维坐标系,应用ScionImage医学图像测量软件分别测量各层面眼球垂直转动时水平直肌、眼球水平转动时垂直直肌的横截面质心。根据各层面直肌横截面质心的坐标值建立直线回归方程,分别求得眼球垂直转动时内、外直肌径路及眼球水平转动时上、下直肌径路直线回归曲线斜率变化最大的一点,即为该直肌Pulley的功能性位置。对4条直肌Pulley相对于眼球中心的坐标值（X、Y）进行统计。结果内直肌Pulley位于眼球中心后4mm,内14.7mm,下0.3mm;外直肌Pulley位于眼球中心后8mm,外9.8mm,下0.3mm;上直肌Pulley位于眼球中心后6mm,内1.6mm,上11.5mm;下直肌Pulley位于眼球中心后6mm,内4.4mm,下12.7mm。结论应用眼球运动动态MRI技术,分析眼球转动时直肌径路的变化,可证实4条直肌Pulley的存在并确定其功能位置。     

依西美坦片在不同介质中的溶出特性

目的:考察新药依西美坦片在3种不同介质中的溶出特性,以研究影响其口服吸收速率的主要因素和规律。方法:建立HPLC法检测其制剂含量和溶出液浓度,色谱柱:HypersilC18(150mm×4.6mm,5μm);流动相:甲醇:0.05mol/LKH2PO4溶液(60:40);检测波长:247nm。溶出介质选用水、0.1mol/L盐酸溶液及0.5%十二烷基硫酸钠溶液,采用转篮法,转速100r/min。结果:依西美坦片在水和0.1mol/L盐酸溶液中的溶出较差,在0.5%十二烷基硫酸钠溶液巾溶出迅速完全,60min时在3种介质中的溶出百分率分别为(60.25±3.76)%、(47.57±1.20)%和(82.24±0.96)%。结论:依西美坦片可能主要在肠道溶出,其溶出速率受介质影响大。     

有机-无机复合型聚合物电解质的研究进展

聚合物电解质是现在锂离子电池研究领域的热点，有机－无机复合型聚合物电解质（CSPE）是现在聚合物电解质的研究主流。在聚合物电解质中添加无机添末，特别是纳米材料，大大改善了聚合物电解质的机械性能、离子导电性能以及界面稳定性能。对CSPE性能进行了评价，对在CSPE中添加无机粉末性能改善机理作了概括和探讨，并对CSPE的前景作了展望。     

胆汁胆固醇对胆囊收缩素受体表达的影响

目的：探讨胆汁胆固醇对胆囊收缩素受体（CCK－R）表达的影响。方法 采用放射免疫分析法和受体放射配基结合法检测对照组、高胆固醇组、自然恢复组及治疗组豚鼠门静脉血CCK水平、胆囊CCK－R的最大结合容量（Bmax）和亲和力（Kd），同时观察空腹胆囊体积（FV）、胆囊胆汁量（FB）和餐后胆囊体积（RV）、胆囊胆汁量（RB）及胆囊收缩率（E％）、胆汁胆固醇浓度的变化。结果 与对照组比较，高胆固醇组豚鼠FV、FB增大（P＜0.05），RV、RB也增大，胆囊收缩率下降（P＜0.01），胆汁胆固醇浓度升高（P＜0.05），门静脉血CCK水平及CCK－R的Kd无改变，而CCK－R的Bmax下降（P＜0.01）；治疗组上述各项指标正常。结论 胆汁中的高胆固醇通过下调胆囊CCK－R表达而导致胆囊收缩功能障碍，降低胆汁高胆固醇浓度可以促进胆囊动力功能的恢复。     

巴乐梦病床控制电路的故障排除与改进

本文就巴乐梦电动病床的控制电路的常见故障进行了分析，利用中小功率晶体管直接取代功率输出型IC反向器电路，通过对控制电路的改进，降低了维修成本，提高了病床的使用寿命。     

应用3H-TdR掺入法对SMMC-7721细胞株药敏试验条件的探讨与应用

目的探讨3H-TdR掺入法在进行SMMC-7721系细胞肿瘤药敏试验实验时的最佳实验条件.方法确定出3H-TdR掺入法药敏实验时的最适细胞浓度、最适实验药物浓度、3H-TdR掺入最适时间;在最适条件下采用3H-TdR掺入法测定肝癌SMMC-7721细胞株对临床常用的9种抗癌药物的敏感性.结果应用3H-TdR掺入法检测肝癌SMMC-7721细胞株药敏试验的最适实验细胞浓度为1×104个/孔,最适试验药物浓度为1×PPC,3H-TdR最适掺入时间为收集细胞前8 h;肝癌SMMC-7721细胞株对DDP、ADM、5-FU、CPT高度敏感,对MTX、VP-16、MMC、NVB低度敏感,对PYM不敏感.结论 3H-TdR掺入法可用于肿瘤药物敏感性测定并确定出它的最适实验条件.     

大鼠脂肪干细胞复合胶原-壳聚糖-硫酸软骨素三维支架构建组织工程软骨

Objective To evaluate the character of the collagen-chitosan-chondroitin sulfate scaffold seeded with rat adipose tissue-derived stromal cells. Methods A dipose tissue were harvested from 6 weeks old Wistar rats and the stromal cells were harvested by type Ⅰ collagenase and then cultured in vitro. Type Ⅰ collagen was fully mixed with chitosan, freeze-dried and cross-linked with chondroitin sulfate, then freeze-dried again and sterilized by ethylene oxide. The pore diameter, water content, porosity of the scaffold were tested. The adipose tissue-derived stromal cells were digested, seeded into the plates, scaffold, and cen-trifuged into pellet, and then induced into cartilage. MTT detection for cell proliferation was done. After 3 weeks, the cell morphology, and cell proliferation and adhesion were observed, and chondrngenic differenti-ation was also analyzed. Results The pore diameter, water content, porosity tested for the scaffold showed an appropriate form. Cell proliferation showed faster in the scaffold and pellet culture system after 5 day, there was still cell proliferation in the scaffold system after 14 days but no obvious changes in the pellet cul-ture system; ceils on the scaffold proliferated densely showed by histological staining, but there was a scaf-fold structure residues in the inner layer. The finding of type Ⅱ immunohistochemistry stain showed that cells express strong positive for type Ⅱ collagen in the scaffold and pellet culture system whereas it was weakly positive in the plate culture system; the specific mRNA for cartilage, type Ⅱ collagen, aggrecan and SOX-9 were expressed in all three systems showed by RT-PCR, but type X collagen was expressed continu-ously in the plate culture system and expressed after 21 days in the pellet culture system, whereas it was not detected in the collagen-chitosan-chondroitin sulfate scaffold system. Conclusion The parameters of the collagen-chitosan-chondroitin sulfate scaffold were suitable in our study. The results suggested that it can promote the adipose tissue-derived stromal cells proliferation and chondrogenic differentiation better than the plate and pellet culture systems and maintain the phenotype of chondrocytes well; it is the optimal choice for cartilage tissue engineering in the future.     

福田4500型B超软故障检修与分析

通过福田4500型B超软故障检修与分析，介绍了该机故障检修分析过程及造成该故障的原因。     

罗格列酮对多囊肾囊肿衬里上皮细胞p38促分裂原活化蛋白激酶信号通路的影响

Objective To investigate the effect of rosiglitazone on p38 mitogen-activated protein kinase (p38MAPK) pathway in polycystic kidney cyst-lining epithelial cells. Methods The cyst-lining epithelial cells (PKD cells) from human polycystic kidney were treated with rosiglitazone (10 μmol/L), peroxisome proliferator-activated receptor-γ (PPARγ) inhibitor GW9662 (10 μmol/L), rosiglitazone (10 μmol/L) +GW9662 (10 μmol/L), p38MAPK specific inhibitor SB203580 (10 μmol/L), SB203580 (10 μmol/L)+ rosiglitazone(10 μmol/L) for 2 hours followed by epidermal growth factor (EGF) stimulation. Protein expressions of p38, phuspho-p38 (p-p38) and proliferating cell nuclear antigen (PCNA) were detected by Western blot. p38 mRNA was examined by RT-PCR. Expression of c-fos and c-jun was observed by immunocytochemistry. Results (1) EGF markedly up-regulated the expressions of p38, p-p38, PCNA, c-fos anti c-jun compared with control group (P<0.01). (2) Compared with EGF treated group, rosiglitazone significantly reduced p38 activation and mRNA expression (P<0.01, respectively). Rosiglitazone, rosiglitazone+SB203580 could significantly down-regulated p-p38, PCNA, c-fos and c-jun expression (P<0.01, respectively) with no significant difference between these two groups. (3) GW9662 partially reversed the reduction effect of rosiglitazone. Conclusions Rosiglitazone can inhibit proliferation of autosomal dominant polycystic kidney disease cyst-lining epithelial cells partially through down-regulating p38 activation and reducing c-fos, c-jun and PCNA expression. The above effect of rosiglitazone is in part PPARγ-independcnt.     

人resistin基因原核表达载体构建和表达

[目的]构建人resistin基因原核表达载体并观察其表达,为开展对resistin的研究打下实验基础.[方法]酚氯仿一步法从一位2型糖尿病合并胆管癌患者腹壁皮下脂肪组织抽取总RNA,RT-PCR法扩增出re-sistin基因cDNA,经测序后,PCR产物亚克隆入T载体,用EcoRI和KpnI分别酶切重组T质粒和原核表达载体pGENKS,然后resistin基因片段和表达载体通过T4DNA连接酶进行定向连接,用核酸内切酶EcoRI、KpnI酶切和测序方法鉴定出重组表达质粒.重组表达质粒转化大肠杆菌JM109,经1 mmol/LIPTG在32℃诱导表达2 h,裂解细菌,进行PAGE凝胶电泳鉴定融合蛋白的表达.[结果]RT-PCR扩增产物分子大小为327 bp,序列分析表明为人resistin基因完整编码区.PCR产物与T载体连接、转化大肠杆菌后,从细菌质粒中酶切回收了目的片段.重组表达质粒经EcoRI和KpnI双酶切后能产生出327 bp、4 980 bp大小的两个片段,序列分析表明重组表达质粒包含人resistin基因完整编码区,基因编码无移位,PAGE凝胶电泳表明在细菌裂解上清有分子质量为39.5 kD的融合蛋白.[结论]成功构建了人resistin基因原核表达载体,且构建的载体能表达出含目的蛋白的融合蛋白,为下一步研究打下了实验基础.