Comparison of 2-dimensional and 3-dimensional acquisition for 18F-FDG PET oncology studies performed on an LSO-based scanner.

Three-dimensional (3D) PET acquisition has the potential to reduce image noise but the advantage of 3D PET for studies outside the brain has not been well established. To compare the performance of 2-dimensional (2D) and 3D acquisition for whole-body (18)F-FDG applications, a series of patient studies were performed using a lutetium oxyorthosilicate (LSO)-based tomograph. METHODS: Comparative 2D and 3D images were acquired for 27 oncology patients using an LSO-based tomograph. Data acquisition (350-650 keV, 6 ns) started 99 +/- 12 min (mean +/- SD) after injection of 624 +/- 76 MBq (18)F-FDG. Bias caused by tracer redistribution and decay was eliminated by acquiring dynamic data over a single-bed position using a protocol that alternated between septa-in and septa-out modes (2D, 3D, 2D, 3D, 2D, 3D). Frames were combined to form 8 statistically independent sinograms: four 2D replicates (105 s) and four 3D replicates (90 s). The different frame durations in 2D and 3D compensated for the different number of overlapping bed positions required for an 85-cm whole-body study. Images were reconstructed with either 2D or fully 3D ordered-subsets expectation maximization (2 iterations and 8 subsets; 2D 6-mm gaussian, 3D 5- and 6-mm gaussian). Image target-to-background ratio was assessed by dividing the lesion maximum by the mean within a neighboring background region. Image noise was assessed by applying background regions of interest to the replicate images and calculating the within-patient coefficient of variation. RESULTS: The difference in target-to-background ratio between the 2D and 3D images, when they were filtered with 6-mm and 5-mm gaussian filters, respectively, was not highly statistically significant (P = 0.16). The mean ratio of 3D to 2D image values was 0.94 with 95% limits of agreement of 0.63-1.41. The within-patient coefficients of variation for the 2D and 3D images were 13% +/- 15% and 9% +/- 10%, respectively (P = 0.0005). CONCLUSION: Under conditions of matched target to-to-background ratios, the 3D mode was found to produce images with significantly less variability than the 2D mode. These data provide support for the use of 3D acquisition with LSO detectors to reduce scan times in whole-body (18)F-FDG applications.     

Repeated measurements of mite and pet allergen levels in house dust over a time period of 8 years

BACKGROUND: Studies of the association between indoor allergen exposure and the development of allergic diseases have often measured allergen exposure at one point in time. OBJECTIVE: We investigated the variability of house dust mite (Der p 1, Der f 1) and cat (Fel d 1) allergen in Dutch homes over a period of 8 years. METHODS: Data were obtained in the Dutch PIAMA birth cohort study. Dust from the child's mattress, the parents' mattress and the living room floor was collected at four points in time, when the child was 3 months, 4, 6 and 8 years old. Dust samples were analysed for Der p 1, Der f 1 and Fel d 1 by sandwich enzyme immuno assay. RESULTS: Mite allergen concentrations for the child's mattress, the parents' mattress and the living room floor were moderately correlated between time-points. Agreement was better for cat allergen. For Der p 1 and Der f 1 on the child's mattress, the within-home variance was close to or smaller than the between-home variance in most cases. For Fel d 1, the within-home variance was almost always smaller than the between-home variance. Results were similar for allergen levels expressed per gram of dust and allergen levels expressed per square metre of the sampled surface. Variance ratios were smaller when samples were taken at shorter time intervals than at longer time intervals. CONCLUSION: Over a period of 4 years, mite and cat allergens measured in house dust are sufficiently stable to use single measurements with confidence in epidemiological studies. The within-home variance was larger when samples were taken 8 years apart so that over such long periods, repetition of sampling is recommended.     

Sodium MRI of the human kidney at 3 Tesla.

The sodium concentration gradient in the kidney (from the cortex to the medulla) serves to regulate fluid homeostasis and is tightly coupled to renal function. It was previously shown that renal function and pathophysiology can be characterized in rat kidneys by measuring the sodium gradient with (23)Na MRI. This study demonstrates for the first time the ability of (23)Na MRI to map the distribution of sodium in the human kidney and to quantify the corticomedullary sodium gradient. The study was performed on a 3T Signa LX scanner (GE) using an in-house-built quadrature surface coil. (23)Na images of volunteers were acquired using a 3D coronal gradient-echo sequence at a spatial resolution of 0.3 x 0.3 x 1.5 cm(3) in a 25-min scan time. The signal intensity (relative to the noise) increased linearly from the cortex to each of the medullae with a mean slope of 1.6 +/- 0.2 in relative arbitrary units per mm (Rel.u./mm, N = 6) and then decreased, as expected, toward the renal pelvis. Water deprivation (12 hr) induced a significant increase of 25% (P < 0.05) in this gradient. Based on these results, we suggest that sodium MRI can serve as a valuable noninvasive method for functional imaging of the human kidney.