Attempt to eliminate health inequalities in Poland arising at the time of political and economic transformation: Polish 400 Cities Project.

AIM: Epidemiological data show that citizens of small towns and villages have presented worse trends in cardiovascular mortality during the political, social and economic transformation in Poland during past 15 years than citizens of large towns. To try to eliminate these inequalities the Polish 400 Cities Project (P400CP), a large educational and interventional project, was prepared. The project consists of two arms: medical and social interventions. MATERIAL AND METHODS: The main aim of the medical screening intervention in P400CP is to increase detection and control of cardiovascular risk factors in inhabitants of 418 small cities (<8000 inhabitants) and surrounding villages, particularly in men and people of lower education. In 2003 and 2004 the P400CP covered 123 cities. All together, 36 696 subjects aged between 18 and 98 years were examined. In all participants, blood pressure (BP), anthropometric measurements, laboratory tests and questionnaire interviews were performed. The social arm of P400CP is one of multi-level educational intervention. Modern techniques of social psychology and marketing were involved to increase participation in interventions. RESULTS: Only 12.5% of all subjects had normal BP, cholesterol (<190 mg/dl) and glucose (<100 mg/dl in whole capillary blood) levels. During the first screening visit 65.5% of all examined subjects had BP>/=140 mmHg or >/=90 mmHg. The fasting glucose level was increased in 19% of women and 26% of men. Almost two-third of all subjects had a total cholesterol level above the norm. CONCLUSIONS: The prevalence of cardiovascular risk factors in participants of the screening programme P400CP in small towns in Poland was very high. High prevalence and low control of risk factors in participants of the P400CP confirm the decision to target this programme at citizens of small towns and villages.     

Magnetic Properties and the Electronic Structure of the Gd0.4Tb0.6Co2 Compound

We report on the comprehensive experimental and theoretical studies of magnetic and electronic structural properties of the Gd_0.4Tb_0.6Co₂ compound crystallization in the cubic Laves phase (C15). We present new results and compare them to those reported earlier. The magnetic study was completed with electronic structure investigations. Based on magnetic isotherms, magnetic entropy change (ΔS_M) was determined for many values of the magnetic field change (Δμ₀H), which varied from 0.1 to 7 T. In each case, the ΔS_M had a maximum around room temperature. The analysis of Arrott plots supplemented by a study of temperature dependency of Landau coefficients revealed that the compound undergoes a magnetic phase transition of the second type. From the M(T) dependency, the exchange integrals between rare-earth R-R (J_RR), R-Co (J_RCo), and Co-Co (J_CoCo) atoms were evaluated within the mean-field theory approach. The electronic structure was determined using the X-ray photoelectron spectroscopy (XPS) method as well as by calculations using the density functional theory (DFT) based Full Potential Linearized Augmented Plane Waves (FP-LAPW) method. The comparison of results of ab initio calculations with the experimental data indicates that near T_C the XPS spectrum collects excitations of electrons from Co3d states with different values of exchange splitting. The values of the magnetic moment on Co atoms determined from magnetic measurements, estimated from the XPS spectra, and results from ab initio calculations are quantitatively consistent.     

Heat Losses Caused by the Temporary Influence of Wind in Timber Frame Walls Insulated with Fibrous Materials

The paper presents the results of research concerning three fiber materials—mineral wool, hemp fiber and wood wool—as loose-fill thermal insulation materials. The analysis used the material parameters determined in previous works conducted by the authors, such as thermal conductivity and air permeability in relation to bulk density. These materials exhibit open porosity; thus, convection is an essential phenomenon in the heat transfer process. The paper aimed at conducting thermal simulations of various frame wall variants which were filled with the above-mentioned insulation materials. The simulations were performed with the Control Volume Method using the Delphin 5.8 software. The studies accounted for the effect of wind pressure and the time of its influence on a wall insulated by means of fiber material with a thickness of 150 as well as 250 mm. The simulation enabled us to obtain such data as maximal R-value reduction and time to return to equilibrium after filtration for the analyzed materials. The study proved that heat transfer in these insulations strongly depends on the bulk density, thickness of the insulation and wind pressure. The decrease in R is reduced as the density increases. This results from the decreased air permeability characterizing the material. Wind washing causes lower R reduction than air filtration in all models. The greater the thickness, the longer it takes for the models to return to the equilibrium state following air filtration (and wind washing). This period is comparable for air filtration and wind washing. Hemp fibers were characterized with the strongest susceptibility to air filtration; in the case of wood wool, it was also high, but lower than for hemp fibers, while mineral wool was characterized with the lowest.     

Viral Infections in Burn Patients: A State-Of-The-Art Review

Infections that are triggered by the accompanying immunosuppression in patients with burn wounds are very common regardless of age. Among burn patients, the most frequently diagnosed infections include the bacterial ones primarily caused by Pseudomonas aeruginosa or Klebsiella pneumonia, as well as fungal infections with the etiology of Candida spp. or Aspergillus spp. Besides, burn wounds are highly susceptible to viral infections mainly due to the impaired immune responses and defective functions of the immune cells within the wound microenvironment. The most prevalent viruses that invade burn wounds include herpes simplex virus (HSV), cytomegalovirus (CMV), human papilloma virus (HPV), and varicella zoster virus (VZV). Likewise, less prevalent infections such as those caused by the orf virus or Epstein–Barr Virus (EBV) might also occur in immunosuppressed burn patients. Viral infections result in increased morbidity and mortality rates in severely burned patients. Additionally, a positive correlation between the hospitalization duration and the severity of the viral infection has been demonstrated. Viral infections trigger the occurrence of various complications, ranging from mild symptoms to even fatal incidents. Accurate detection of viral infection is of great clinical importance because of the possibility for a quicker introduction of proper treatment therapy and shortening of hospitalization time. The aim of this paper is to provide a comprehensive review of the literature and summarize the findings regarding the most common viral infections in immunosuppressed burn patients.