Major liver resection results in early exacerbation of insulin resistance, and may be a risk factor of developing overt diabetes in the future

Purpose

This single center prospective cohort study evaluated the influence of hemihepatectomy on glucose homeostasis.

Methods

The study included 30 patients undergoing hemihepatectomy. All patients underwent an oral 75 g glucose tolerance test before (baseline), 1 week and 1 month after the surgery. Plasma glucose, insulin and glucagon were measured in the OGTT samples, and the HOMA index was calculated. The fasting levels of interleukin 6 and 1β, tumor necrosis factor and adiponectin were assessed.

Results

The fasting plasma and 120-min post-challenge mean glucose level increased during the study from 89.6 to 103.5 mg/dl (by 15.5 %) and from 136.4 to 162.2 (by 18.9 %; p = 0.51), respectively, accompanied by an increase in fasting glucagon (from 3.2 to 5.9 ng/mL; p = 0.043) and insulin (from 14.6 to 19.3 IU/mL) and by a decrease in plasma insulin at 60 min of OGTT (p = 0.34). An increase of IL-6 (p = 0.015) and TNF (from 49.7 to 53 pg/mL), and decrease of plasma APO (7658 to 5152 ng/mL) and exacerbation of insulin resistance (p = 0.007) were noted.

Conclusion

Hemihepatectomy resulted in moderate disturbances in glucose homeostasis, in a majority of patients that was likely to be of minor clinical relevance. However, the patients might be at higher risk of developing overt diabetes following long-term survival.     

Magnetic resonance spectroscopy and molecular studies in ornithine transcarbamylase deficiency novel mutation c.802A>G in exon 8 (p.Met268Val)

Ornithine transcarbamylase (OTC) deficiency, an X-linked, semidominant disorder, is the most common inherited defect in ureagenesis, resulting in hyperammonaemia type II. The OTC gene, localised on chromosome X, has been mapped to band Xp21.1, proximate to the Duchenne muscular dystrophy (DMD) gene. More than 350 different mutations, including missense, nonsense, splice-site changes, small deletions or insertions and gross deletions, have been described so far. Almost all mutations in consensus splicing sites confer a neonatal phenotype. Most mutations in the OTC gene are ‘private’ and are distributed throughout the gene with a paucity of mutation in the sequence encoding the leader peptide (exon 1 and beginning of exon 2) and in exon 7. They have familial origin or occur de novo. Even with sequencing of the entire reading frame and exon/intron boundaries, only about 80% of the mutations are detected in patients with proven OTC deficiency. The remainder probably occur within the introns or in regulatory domains. The authors present a 4-year-old boy with the unreported missense mutation c.802A>G. The nucleotide transition leads to amino acid substitution Met to Val at codon 268 of the OTC protein.     

Low-level laser irradiation effect on endothelial cells under conditions of hyperglycemia

Diabetes mellitus is considered to be a very serious lifestyle disease leading to cardiovascular complications and impaired wound healing observed in the diabetic foot syndrome. Chronic hyperglycemia is the source of the endothelial activation. The inflammatory process in diabetes is associated with the secretion of inflammatory cytokines by endothelial cells, e.g., tumor necrosis factor-alpha (TNF-α) and interleukin 6 (IL-6). The method of phototherapy using laser beam of low power (LLLT—low-level laser therapy) effectively supports the conventional treatment of diabetic vascular complications such as diabetic foot syndrome. The aim of our study was to evaluate the effect of low-power laser irradiation at two wavelengths (635 and 830 nm) on the secretion of inflammatory factors (TNF-α and IL-6) by the endothelial cell culture—HUVEC line (human umbilical vein endothelial cell)—under conditions of hyperglycemia. It is considered that adverse effects of hyperglycemia on vascular endothelial cells may be corrected by the action of LLLT, especially with the wavelength of 830 nm. It leads to the reduction of TNF-α concentration in the supernatant and enhancement of cell proliferation. Endothelial cells play an important role in the pathogenesis of diabetes; however, a small number of studies evaluate an impact of LLLT on these cells under conditions of hyperglycemia. Further work on this subject is warranted.     

The spectrum of spontaneous mutations caused by deficiency in proteasome maturase Ump1 in Saccharomyces cerevisiae

Ump1 is responsible for maturation of the catalytic core of the 26S proteasome. Dysfunction of Ump1 causes an increase in the frequency of spontaneous mutations in Saccharomyces cerevisiae. In this study we analyze the spectrum of mutations occurring spontaneously in yeast deficient in Ump1 by use of the SUP4-o system. Single base substitutions predominate among the mutations analyzed (73 of the 91 alterations examined). Two major classes are GC to TA transversions and GC to AT transitions ( approximately 50 and approximately 30% of base substitutions, respectively). Besides base substitutions, almost all the major types of sequence alterations are represented. The specificity and distribution of mutations occurring in the ump1 strain are unique compared to the spectra previously established for other yeast mutators. However, the profile of mutations arising in this strain is similar to that observed in wild type. The same similarity has previously been reported for yeast deficient in Mms2, a protein involved in Rad6-dependent postreplication DNA repair (PRR). The specificity of the mutator effect caused by ump1 is discussed in light of the proposed role of the proteasome activity in the regulation of the PRR mechanisms.     

Bisphenol A induce ovarian cancer cell migration via the MAPK and PI3K/Akt signalling pathways

Bisphenol A (BPA), is present in a multitude of products, including food and water containers, food can linings, dentistry sealants, and thermal paper. BPA can induce the growth of human ovarian cancer cell lines. Reduction of adhesion and the initiation of metastasis are important events in cancer progression; therefore, this study investigated the effects of BPA (0.1–100 nM) on the migration of OVCAR-3 ovarian cancer cells and the expression levels of metalloproteinases (MMPs) and cadherins. The oestrogenic compound 17β-estradiol (40 nM) was used as a positive control for estrogenic properties of bisphenol A. BPA stimulated cell migration, and the effect of BPA was similar to that of 17β-estradiol. BPA-induced cell migration was accompanied by up-regulation of the migration-related factors MMP-2, MMP-9 and N-cadherin, but E-cadherin expression and activity was unaffected. The stimulatory effects of BPA on cell migration were abolished by pre-treatment of the cells with inhibitors of the mitogen-activated protein kinase (MAPK) and phosphatidylinositol 3-kinase pathways (PI3K). In conclusion, the results presented here show that BPA induces OVCAR-3 cells migration by activating MAPK and PI3K/Akt signalling pathways.     

Effect of Low Zeolite Doses on Plants and Soil Physicochemical Properties

Thousands of tons of zeolitic materials are used yearly as soil conditioners and components of slow-release fertilizers. A positive influence of application of zeolites on plant growth has been frequently observed. Because zeolites have extremely large cation exchange capacity, surface area, porosity and water holding capacity, a paradigm has aroused that increasing plant growth is caused by a long-lasting improvement of soil physicochemical properties by zeolites. In the first year of our field experiment performed on a poor soil with zeolite rates from 1 to 8 t/ha and N fertilization, an increase in spring wheat yield was observed. Any effect on soil cation exchange capacity (CEC), surface area (S), pH-dependent surface charge (Qv), mesoporosity, water holding capacity and plant available water (PAW) was noted. This positive effect of zeolite on plants could be due to extra nutrients supplied by the mineral (primarily potassium—1 ton of the studied zeolite contained around 15 kg of exchangeable potassium). In the second year of the experiment (NPK treatment on previously zeolitized soil), the zeolite presence did not impact plant yield. No long-term effect of the zeolite on plants was observed in the third year after soil zeolitization, when, as in the first year, only N fertilization was applied. That there were no significant changes in the above-mentioned physicochemical properties of the field soil after the addition of zeolite was most likely due to high dilution of the mineral in the soil (8 t/ha zeolite is only ~0.35% of the soil mass in the root zone). To determine how much zeolite is needed to improve soil physicochemical properties, much higher zeolite rates than those applied in the field were studied in the laboratory. The latter studies showed that CEC and S increased proportionally to the zeolite percentage in the soil. The Qv of the zeolite was lower than that of the soil, so a decrease in soil variable charge was observed due to zeolite addition. Surprisingly, a slight increase in PAW, even at the largest zeolite dose (from 9.5% for the control soil to 13% for a mixture of 40 g zeolite and 100 g soil), was observed. It resulted from small alterations of the soil macrostructure: although the input of small zeolite pores was seen in pore size distributions, the larger pores responsible for the storage of PAW were almost not affected by the zeolite addition.     

New Acceptor–Donor–Acceptor Systems Based on Bis-(Imino-1,8-Naphthalimide)

In this paper, six novel symmetrical bis-(imino-1,8-naphthalimides) differing in core and N-substituent structure were synthesized, and their thermal (TGA, DSC), optical (UV-Vis, PL), electrochemical (DPV, CV) properties were evaluated. The compounds were stable to 280 °C and could be transferred into amorphous materials. Electrochemical investigations showed their ability to occur reductions and oxidations processes. They exhibited deep LUMO levels of about −3.22 eV and HOMO levels above −5.80 eV. The optical investigations were carried out in the solutions (polar and non-polar) and in films and blends with PVK:PBD. Bis-(imino-1,8-naphthalimides) absorbed electromagnetic radiation in the range of 243–415 nm and emitted light from blue to yellow. Their capacity for light emission under voltage was preliminarily tested in devices with an active layer consisting of a neat compound and a blend with PVK:PBD. The diodes emitted green or red light.     

Mechanical and Combustion Properties of Agglomerates of Wood of Popular Eastern European Species

The objective of the reported project was to produce wood agglomerates from popular East European species to determine their strength and combustion properties. Closed-die pellets were produced from sawdust of six types of wood common on the East European market: pine, willow, oak, poplar, birch, and beech. The properties of pellets, determined by the type of wood, were influenced by the compaction pressure and the moisture content of the sawdust. The highest average pellet density was obtained for oak sawdust, while the lowest density was obtained for poplar pellets. Expansion of pellets after removing from the die was found to be dependent on the wood species, and as expected, on compaction pressure. The pellet expansion increased after 2 h of conditioning in the laboratory and with an increase in moisture content. The highest and the smallest strength were obtained for oak pellets and for birch sawdust, respectively. The strength of the pellets increased by more than 100% with an increase in the compaction pressure from 60 MPa to 120 MPa. The average strength decreased by 65% with increasing moisture content. For all tested materials, drop resistance remained at a high level, acceptable in industrial practice. The highest calorific value of 18.97 MJ/kg was obtained for pine pellets. The highest ash value of 1.52% was obtained for willow pellets and the lowest value of 0.32% for pine pellets.     

Influence of the Type of Cement on the Action of the Admixture Containing Aluminum Powder

The study of the effect of cement type on the action of an admixture increasing the volume of concrete (containing aluminum powder), used in amounts of 0.5–1.5% of cement mass, was presented. The tests were carried out on cement mortars with Portland (CEM I) and ground granulated blast-furnace slag cement (CEM III). The following tests were carried out for the tested mortars: the air content in fresh mortars, compressive strength, flexural strength, increase in mortar volume, bulk density, pore structure evaluation (by the computer image analysis method) and changes in the concentration of OH⁻ ions during the hydration of used cements. Differences in the action of the tested admixture depending on the cement used were found. To induce the expansion of CEM III mortars, a smaller amount of admixture is required than in the case of CEM I cement. Using the admixture in amounts above 1% of the cement mass causes cracks of mortars with CEM III cement due to slow hydrogen evolution, which occurs after mortar plasticity is lost. The use of an aluminum-containing admixture reduces the strength properties of the cement mortars, the effect being stronger in the case of CEM III cement. The influence of the sample molding time on the admixture action was also found.     

Influence of Long-Term Storage on the Caking Properties Determined in Punch Test and Fungal Contamination of Potato Starch and Wheat Flour

The presented results are an attempt to identify the changes taking place during a punch test experiment and the development of fungal impurities of powdered food materials over long-term storage at 75% RH. The potato starch and wheat flour market has a large share of the global production of bulk materials. The growing interest in powdered food materials requires additional production expenditure. This is associated with an increase in storage time of the discussed product and providing it with the appropriate conditions. The samples of potato starch and wheat flour were stored in perforated containers in a climatic chamber at 75% humidity and 21 °C for five months and then samples were measured by a punch test in a Lloyd LRX materials testing machine. The graphs obtained in the potato starch punch test differed significantly from wheat flour. The thickening of potato starch was observed in the form of layers, while potato starch was uniformly thickened throughout the experiment. The conditions of 75% humidity and 21 °C can be described as the beginning of the caking process. In potato starch, linear sections were observed, which changed the length of their storage time and, additionally, was correlated with the appearance of fungal contamination. These results may suggest the influence of fungi on the phenomenon of bulk material caking.