Tuberculosis notifications in Australia, 2003.

The National Notifiable Disease Surveillance System (NNDSS) received 982 tuberculosis (TB) notifications in 2003, of which 947 were new cases, 33 were relapses and two were cases with unknown history. The incidence of TB in Australia has remained at a stable rate since 1985 and was 4.9 cases per 100,000 population in 2003. The high-incidence groups remain people born overseas and Indigenous Australians at 19.9 and 8.7 cases per 100,000 population, respectively. By contrast the incidence in non-Indigenous Australians was 0.9 per 100,000. Comparison of the 2003 TB notification data against the performance indicators set by National Tuberculosis Advisory Committee highlights that enhanced TB control measures should be considered among these high-risk groups.     

Pet ownership and survival of European older adults

With pet ownership on the rise, millions of individuals are exposed to this environmental exposure. Although the subject has been largely studied, more evidence is needed to clarify the potential association of pet ownership with human health. The aim of this research is to study the potential association of pet exposure (any pet, cat, dog, bird, fish) with all-cause, cardiovascular and cancer mortality of older (≥ 50 years) European residents. To this end, a total of 23,274 participants from the Survey of Health Ageing and Retirement in Europe (SHARE) were employed (median follow-up 119 months). All-cause mortality (5163 events), as well as cardiovascular (CVD) (1832 events), and cancer mortality (1346 events) were examined using Cox Proportional Hazards models for their relation with pet exposure at baseline. Stratified analyses were also performed by gender and for single or multi-person households. No significant association was observed for any of the pets with all-cause mortality on the whole sample and the fully adjusted models. In stratified analyses, bird exposure significantly increased the risk of all-cause mortality in women [Hazard Ratio (HR)=1.23; 95% CI 1.04–1.44] as well as women living alone (HR=1.38; 95% CI 1.02–1.85). Cause-specific models revealed an increased risk of death for women bird owners for causes other than cancer and CVD (HR=1.40; 95% CI 1.05–1.99). In conclusion, bird ownership may be negatively associated with survival of older women in Europe.     

PROTEIN AI Advisor: A Knowledge-Based Recommendation Framework Using Expert-Validated Meals for Healthy Diets

AI-based software applications for personalized nutrition have recently gained increasing attention to help users follow a healthy lifestyle. In this paper, we present a knowledge-based recommendation framework that exploits an explicit dataset of expert-validated meals to offer highly accurate diet plans spanning across ten user groups of both healthy subjects and participants with health conditions. The proposed advisor is built on a novel architecture that includes (a) a qualitative layer for verifying ingredient appropriateness, and (b) a quantitative layer for synthesizing meal plans. The first layer is implemented as an expert system for fuzzy inference relying on an ontology of rules acquired by experts in Nutrition, while the second layer as an optimization method for generating daily meal plans based on target nutrient values and ranges. The system’s effectiveness is evaluated through extensive experiments for establishing meal and meal plan appropriateness, meal variety, as well as system capacity for recommending meal plans. Evaluations involved synthetic data, including the generation of 3000 virtual user profiles and their weekly meal plans. Results reveal a high precision and recall for recommending appropriate ingredients in most user categories, while the meal plan generator achieved a total recommendation accuracy of 92% for all nutrient recommendations.     

Corifollitropin alfa compared with follitropin beta in GnRH-antagonist ovarian stimulation protocols in an unselected population undergoing IVF/ICSI

Recombinant DNA technologies have produced Corifollitropin alfa (CFa) used during IVF/ICSI in order to keep the circulating FSH levels above the threshold necessary to support multi-follicular growth for a week. In this prospective case-control study, we compared 70 participants treated with 150?μg CFa combined with 150?IU of follitropin beta (study group) with 70 subfertile participants with matching baseline characteristics, conforming with the same inclusion criteria and treated with an antagonist protocol using follitropin beta (control group). Live birth was the primary outcome, while secondary outcome measures were IVF/ICSI cycles characteristics, including adverse events and complications. Live birth was determined in reduced rates in the study compared to the control group, reaching statistical significance [6/70 versus 20/70, p?=?0.002], as also in the respective number of clinical pregnancies [9/70 versus 23/70, p?=?0.005], although the incidence of miscarriage was similar for both groups [6/70 versus 5/70, p?>?0.99]. Most of the secondary parameters examined were similar between groups. Logistic regression revealed that protocol and AFC had a direct impact on live birth. Ovarian stimulation with CFa does not seem to constitute an equally effective method as compared with follitropin beta to be offered in a general subfertile population seeking IVF/ICSI treatments.     

Thermomechanical Fatigue Testing on Fe-Mn-Si Shape Memory Alloys in Prestress Conditions

Active materials have gained increasing momentum during the last decades due to their ability to act as sensors and actuators without the need for an external controlling system or an electronic signal. Shape memory alloys (SMAs), which are a subcategory of active materials, are slowly being introduced in the civil engineering sector in applications that refer to prestressing and strengthening of various structural elements. Low-cost iron-based SMAs are a good alternative to the Ni-Ti SMAs for such uses since the cost of large-scale civil engineering applications would otherwise be prohibitive. The scope of this study is the investigation of the thermomechanical response of the Fe-17Mn-5Si-10Cr-4Ni-1(V,C) ferrous SMA. In particular, this study focuses on the application of prestress, and on the alloy’s behavior under fatigue loadings. In addition, the effect of loading frequency on the recovery stress of the material is thoroughly investigated. Four dog-bone specimens were prepared and tested in low-cycle fatigue. All the experiments aimed at the simulation of prestress. The recovery stress was monitored after pre-straining and heating applied under strain–control conditions. The experimental results are promising in terms of the is situ prestress feasibility since the measured recovery stress values are satisfactory high.     

Methods of Preparation and Performance Evaluation of ABS/Mineral Microsphere Composites Produced through FDM and Compression Molding

The use of amorphous microspheres as filler in composites is promising due to their light weight, low cost, incombustibility, and the ability to alter relevant properties of the final composite. Contrary to glass spheres, perlite microspheres are much cheaper and can be tailor-made to facilitate purpose-oriented alteration of the final composite. We report the use of perlite microspheres for the preparation of: (1) composites, through a compression molding (hot pressing) technique; and (2) composite filaments, in a single screw extruder, as well as their use for sample printing through Fused Deposition Modeling (FDM). Proper characterization of the produced composites allows for their evaluation in terms of physical, thermal, and mechanical properties and with regards to the manufacturing technique, the filler fraction, and size. Composite samples of acceptable quality in terms of filler survival and dispersion as well as mechanical properties were produced through compression molding using fine expanded perlite microspheres (<90 μm) up to an infill ratio of 40 vol.%. Fine fillers (<90 μm) performed well in FDM, allowing printing of composite dogbone samples with a higher Young’s modulus and elongation and similar ultimate tensile strength compared to benchmark, up to an infill ratio of 20 vol.%. Composite samples present a slightly lower burning rate compared to those produced solely by ABS. Perlite microspheres present good workability in both applications, possessing satisfactory performance as filler in the composites, and can thus be assumed a promising multifunctional filler for various thermoplastics considering their low price, environmental impact, and fire rating.     

COVID-19 in the endoscopy unit: How likely is transmission of infection? Results from an international,multicenter study

BACKGROUND Coronavirus disease 2019(COVID-19) significantly affected endoscopy practice,as gastrointestinal endoscopy is considered a risky procedure for transmission of infection to patients and personnel of endoscopy units(PEU).AIM To assess the impact of COVID-19 on endoscopy during the first European lockdown(March-May 2020).METHODS Patients undergoing endoscopy in nine endoscopy units across six European countries during the period of the first European lockdown for COVID-19(MarchMay 2020) were included. Prior to the endoscopy procedure, participants were stratified as low-or high-risk for potential COVID-19 infection according to the European Society of Gastrointestinal Endoscopy(ESGE) and the European Society of Gastroenterology and Endoscopy Nurses and Associates(ESGENA) joint statement, and contacted 7-14 d later to assess COVID-19 infection status. PEU were questioned regarding COVID-19 symptoms and/or infection via questionnaire, while information regarding hospitalizations, intensive care unitadmissions and COVID-19-related deaths were collected. The number of weekly endoscopies at each center during the lockdown period was also recorded.RESULTS A total of 1267 endoscopies were performed in 1222 individuals across nine European endoscopy departments in six countries. Eighty-seven(7%) were excluded because of initial positive testing. Of the 1135 pre-endoscopy low risk or polymerase chain reaction negative for COVID-19, 254(22.4%) were tested post endoscopy and 8 were eventually found positive, resulting in an infection rate of 0.7% [(95%CI: 0.2-0.12]. The majority(6 of the 8 patients, 75%) had undergone esophagogastroduodenoscopy. Of the 163 PEU, 5 [3%;(95%CI: 0.4-5.7)] tested positive during the study period. A decrease of 68.7%(95%CI: 64.8-72.7) in the number of weekly endoscopies was recorded in all centers after March 2020. All centers implemented appropriate personal protective measures(PPM) from the initial phases of the lockdown.CONCLUSION COVID-19 transmission in endoscopy units is highly unlikely in a lockdown setting, provided endoscopies are restricted to emergency cases and PPM are implemented.