Fat extravasation due to unreamed and experimentally reamed intramedullary nailing of the sheep femur

Aim

To compare systemic fat extravasation in unreamed and experimentally reamed nailing.

Methods

An osteotomy was created in the proximal third of the femoral shaft in 16 sheep, and intramedullary pressure increase and fat extravasation were monitored for the two nailing techniques.

Results

The highest intramedullary pressures, median 2700 mmHg, and highest percentages of fat extravasation, peaking at almost 90% of fat, were found for the unreamed nailing technique. The values for the reamed group were significantly lower.

Conclusions

The extravasation of intramedullary fat can be attributed to the great increase in intramedullary pressure that occurs during unreamed nailing. Correctly performed intramedullary reaming with the new reaming system produces lower pressures and much less systemic fat extravasation, reducing the risk for fat embolism.     

Saturation‐recovery metabolic‐exchange rate imaging with hyperpolarized [1‐13C] pyruvate using spectral‐spatial excitation

Within the last decade hyperpolarized [1‐¹³C] pyruvate chemical‐shift imaging has demonstrated impressive potential for metabolic MR imaging for a wide range of applications in oncology, cardiology, and neurology. In this work, a highly efficient pulse sequence is described for time‐resolved, multislice chemical shift imaging of the injected substrate and obtained downstream metabolites. Using spectral‐spatial excitation in combination with single‐shot spiral data acquisition, the overall encoding is evenly distributed between excitation and signal reception, allowing the encoding of one full two‐dimensional metabolite image per excitation. The signal‐to‐noise ratio can be flexibly adjusted and optimized using lower flip angles for the pyruvate substrate and larger ones for the downstream metabolites. Selectively adjusting the excitation of the down‐stream metabolites to 90° leads to a so‐called “saturation‐recovery” scheme with the detected signal content being determined by forward conversion of the available pyruvate. In case of repetitive excitations, the polarization is preserved using smaller flip angles for pyruvate. Metabolic exchange rates are determined spatially resolved from the metabolite images using a simplified two‐site exchange model. This novel contrast is an important step toward more quantitative metabolic imaging. Goal of this work was to derive, analyze, and implement this “saturation‐recovery metabolic exchange rate imaging” and demonstrate its capabilities in four rats bearing subcutaneous tumors. Magn Reson Med, 2013. © 2012 Wiley Periodicals, Inc.     

Halogenated inhalational anaesthetics

The halogenated inhalational anaesthetics halothane, enflurane, isoflurane and desflurane can produce metabolic hepatocellular injury in humans to a variable extent. During metabolism of these anaesthetics, tissue acetylation occurs due to the formation of reactive intermediates. Proteins modified by acetylation may constitute neo-antigens with a potential for triggering an antibody-mediated immune response. The likelihood of suffering post-operative immune hepatitis depends on the amount of the anaesthetic metabolized and is thereby considerably less with enflurane, isoflurane or desflurane compared with halothane. Plasma inorganic fluoride concentrations are regularly increased after sevoflurane. Elevated inorganic fluoride concentrations have been associated with nephrotoxicity following methoxyflurane anaesthesia but not after sevoflurane. Another source of concern is the products of degradation from reactions with carbon dioxide absorbents. Most important is compound A, which has been shown to exhibit nephrotoxicity in rodents. However, no significant changes in renal function parameters have been reported in surgical patients.     

Prevalence of dyslipidemic risk factors in hemodialysis and CAPD patients

BACKGROUND: Dyslipidemic factors obviously contribute to the high cardiovascular risk in dialysis patients but are often an underestimated problem. Therefore, we determined the prevalence of dyslipidemic factors in a large group of unselected hemodialysis (N = 564) and CAPD (N = 168) patients. METHODS: We used the recently published recommendations of the Medical Experts Group concerning cardiovascular risk factors for the categorization of dyslipidemic factors. These were total cholesterol>200 mg/dL, low-density lipoprotein (LDL) cholesterol>100 mg/dL, high-density lipoprotein (HDL) cholesterol <40 mg/dL, triglycerides>180 mg/dL, and Lp(a)>30 mg/dL. RESULTS: CAPD patients had, in sum, a markedly worse lipid profile when compared with HD patients. They had higher frequencies of elevated total cholesterol (67% vs. 34%), triglycerides (47% vs. 28%), and Lp(a) concentrations (37% vs. 30%) when compared with HD patients. In both patient groups, about two thirds of the patients had LDL cholesterol above 100 mg/dL and HDL cholesterol below 40 mg/dL. When we analyzed the total frequency of dyslipidemic factors, we observed that the CAPD group included a markedly higher number of patients with three or four concurrent dyslipidemic factors than HD patients (P < 0.001). Furthermore, we analyzed apolipoprotein A-IV (apoA-IV), which was recently shown to be associated with cardiovascular disease, and which was about twice as high in both patient groups when compared with controls (P < 0.001). CONCLUSIONS: Dyslipidemic risk factors are highly prevalent in dialysis patients, and the concomitant occurrence of several risk factors in a given patient is more often observed in CAPD than HD patients.     

Sonoelastography of the prostate: comparison with systematic biopsy findings in 492 patients

OBJECTIVE: The aim of this study was to assess the value of sonoelastography (SE) for prostate cancer detection in comparison with systematic biopsy findings. MATERIAL AND METHODS: Four hundred and ninety two PSA screening volunteers (mean age: 61.9+/-8.6) with an total PSA >1.25 ng/mL and a free to total PSA ration of <18% underwent SE of the prostate before 10 core systematic prostate biopsy. Tissue elasticity of the peripheral zone was investigated only. Tissue elasticity was displayed from red (soft) to green (intermediate) and to blue (hard). Only hard lesions (blue) were considered to be suspicious for prostate cancer. The peripheral zone of the prostate was divided in 3 regions on each side: base, mid-gland, apex. A different investigator performed systematic biopsy, and the biopsy findings were compared with the SE findings. RESULTS: In 125 of 492 patients (25.4%) systematic biopsy demonstrated prostate cancer. Cancer was detected in 321 of 2952 (11%) outer gland areas (74 in the base, 106 in the mid-gland, 141 in the apex). The Gleason score ranged from 3 to 10 (mean: 6.5). In SE 533 of 2952 (18.1%) suspicious areas were detected and 258 of these areas (48.4%) showed cancer. Most of the false-positive findings (275/533 areas; 51.6%) were associated with chronic inflammation and atrophy especially at the basal prostate areas. The sensitivity by entire organ was calculated with 86% and the specificity 72%. The analysis by outer gland areas showed the highest sensitivity in the apex (79%). The specificity by outer gland areas ranged between 85% and 93%. The correlation between SE findings and biopsy results was high (p<0.001). CONCLUSION: Sonoelastography findings showed a good correlation with the systematic biopsy results. The best sensitivity and specificity was found in the apex region. Sonoelastography seems to offer a new approach for differentiation of tissue stiffness of the prostate and may therefore improve prostate cancer detection.     

Differentiating normal hyaline cartilage from post-surgical repair tissue using fast gradient echo imaging in delayed gadolinium-enhanced MRI (dGEMRIC) at 3 Tesla

The purpose was to evaluate the relative glycosaminoglycan (GAG) content of repair tissue in patients after microfracturing (MFX) and matrix-associated autologous chondrocyte transplantation (MACT) of the knee joint with a dGEMRIC technique based on a newly developed short 3D-GRE sequence with two flip angle excitation pulses. Twenty patients treated with MFX or MACT (ten in each group) were enrolled. For comparability, patients from each group were matched by age (MFX: 37.1 ± 16.3 years; MACT: 37.4 ± 8.2 years) and postoperative interval (MFX: 33.0 ± 17.3 months; MACT: 32.0 ± 17.2 months). The Δ relaxation rate (ΔR1) for repair tissue and normal hyaline cartilage and the relative ΔR1 were calculated, and mean values were compared between both groups using an analysis of variance. The mean ΔR1 for MFX was 1.07 ± 0.34 versus 0.32 ± 0.20 at the intact control site, and for MACT, 1.90 ± 0.49 compared to 0.87 ± 0.44, which resulted in a relative ΔR1 of 3.39 for MFX and 2.18 for MACT. The difference between the cartilage repair groups was statistically significant. The new dGEMRIC technique based on dual flip angle excitation pulses showed higher GAG content in patients after MACT compared to MFX at the same postoperative interval and allowed reducing the data acquisition time to 4 min.     

MRI thermometry: Fast mapping of RF‐induced heating along conductive wires

Conductive implants are in most cases a strict contraindication for MRI examinations, as RF pulses applied during the MRI measurement can lead to severe heating of the surrounding tissue. Understanding and mapping of these heating effects is therefore crucial for determining the circumstances under which patient examinations are safe. The use of fluoroptic probes is the standard procedure for monitoring these heating effects. However, the observed temperature increase is highly dependent on the positioning of such a probe, as it can only determine the temperature locally. Temperature mapping with MRI after RF heating can be used, but cooling effects during imaging lead to a significant underestimation of the heating effect. In this work, an MRI thermometry method was combined with an MRI heating sequence, allowing for temperature mapping during RF heating. This technique may provide new opportunities for implant safety investigations. Magn Reson Med, 2008. © 2008 Wiley‐Liss, Inc.     

Penetration of left and right atrial wall and aortic root by an Amplatzer atrial septal occluder in a nine year old boy with Marfan syndrome: Case report

Background  

To describe complications associated with Amplatzer septal occluders in a patient with Marfan syndrome     

Intraoperative assessment of femoral component rotational alignment in total knee arthroplasty

Poor clinical results following total knee arthroplasty like flexion gap instability or anterior knee pain may be related to femoral component rotational malalignment. The transepicondylar axis has been recommended as a landmark to consistently recreate a balanced flexion gap. However, the reproducibility to identify the transepicondylar axis intraoperatively is low. In this feasibility study we wanted to find out whether fluoroscopy-based CT scans obtained by a motorized mobile C-arm (Iso C 3D) may be useful to asses the transepicondylar axis intraoperatively. Following the femoral resections the Iso C 3D was used intraoperatively in ten knees with mild to severe deformities. On multiplanar reconstructions of the distal femur the clinical epicondylar axis as well as the angle to the posterior cut (condylar twist angle) could be easily measured. The scanning time was 40 s and the extra time needed for the whole setup about five to ten minutes. The Iso C 3D was helpful to intraoperatively identify the transepicondylar axis and the condylar twist angle, especially in cases with severe deformity or dysplasia when standard landmarks are difficult to determine. Florian Geiger and Dominik Parsch contributed equally to this article.     

Crossed screws versus dorsomedial locking plate with compression screw for first metatarsocuneiform arthrodesis: a cadaver study

BACKGROUND: We hypothesized that a dorsomedial locking plate with adjunct screw compression would provide superior rigidity compared to crossed screws for first metatarsocuneiform (MTC) arthrodesis. MATERIALS AND METHODS: In ten matched lower extremity pairs, specimens in each pair were randomly assigned to receive screw fixation or plate with screw fixation. Bone mineral density (BMD) was measured. For the crossed-screw construct, two 4.0-mm cannulated screws were used. One screw was inserted dorsal to plantar beginning from the first metatarsal 10 to 15 mm distal to the joint, and the second was inserted from the cuneiform 8 to10 mm proximal to the joint, medial to the first screw, into the first metatarsal. For the plate construct, a 4.0-mm cannulated compression screw was inserted from the dorsal cortex of the first metatarsal to the plantar aspect of the medial cuneiform. A locking plate was inserted dorsomedially across the MTC joint. Specimens were loaded in four-point bend configuration (displacement rate, 5 mm/min) until failure of the fixation or 3-mm deformation. An extensometer was used to measure deformation. RESULTS: There was no difference in load to failure or stiffness between the two groups. BMD was positively correlated with load to failure in the screw (r = 0.893, p = 0.001) and the plate (r = 0.858, p = 0.001) construct. CONCLUSION: The plate construct with compression screw did not show different rigidity as compared with the screw construct with the numbers available. CLINICAL RELEVANCE: Further investigation of a dorsomedial plate with adjunct screw compression may be warranted for first MTC arthrodesis.