Tissue Doppler gated (TDOG) dynamic three-dimensional ultrasound imaging of the fetal heart.

Dynamic three-dimensional (3D) ultrasound imaging of the fetal heart is difficult due to the absence of an electrocardiogram (ECG) signal for synchronization between loops. In this study we introduce tissue Doppler gating (TDOG), a technique in which tissue Doppler data are used to calculate a gating signal. We have applied this cardiac gating method to dynamic 3D reconstructions of the heart of eight fetuses aged 20-24 weeks.The gating signal was derived from the amplitude and frequency contents of the tissue Doppler signal. We used this signal as a replacement for ECG in a 3D-volume reconstruction and visualization, utilizing techniques established in ECG-gated 3D echocardiography.The reliability of the TDOG signal for fetal cardiac cycle detection was experimentally investigated. Simultaneous recordings of tissue Doppler of the heart and continuous wave (CW) spectral Doppler of the umbilical artery (UA) were performed using two independent ultrasound systems, and the TDOG signal from one system was compared to the Doppler spectrum data from the other system. Each recording consisted of a two-dimensional (2D) sector scan, transabdominally and slowly tilted by the operator, covering the fetal heart over approximately 40 cardiac cycles. The total angle of the sweep was estimated by recording a separate loop through the center of the heart, in the elevation direction of the sweep.3D reconstruction and visualization were performed with the EchoPAC-3D software (GE Medical Systems). The 3D data were visualized by showing simultaneous cineloops of three 2D slices, as well as by volume projections running in cineloop.Synchronization of B-mode cineloops with the TDOG signal proved to be sufficiently accurate for reconstruction of high-quality dynamic 3D data. We show one example of a B-mode recording with a frame rate of 96 frames/s over 20 seconds. The reconstruction consists of 31 volumes, each with 49 tilted frames. With the fetal heart positioned 5-8 cm from the transducer, the sampling distances were approximately 0.15 mm in the beam direction, 0.33 degrees approximately 0.37 mm azimuth and 0.45 degrees approximately 0.51 mm elevation. From this single dataset we were able to generate a complete set of classical 2D views (such as four-chamber, three-vessel and short-axis views as well as those of the ascending aorta, aortic and ductal arches and inferior and superior venae cavae) with high image quality adequate for clinical use.     

Verruciform xanthoma]

BACKGROUND: Verruciform xanthoma (VX), a rare, benign lesion of the skin and mucosa, is slow-growing, asymptomatic and characterized by a granular (verruciform) surface. It is yellowish-red or grey in color and up to 2 cm in diameter. Histologically, a papillary and/or verrucous proliferation of the squamous epithelium with hyperparakeratosis and numerous foam cells is present. These cells are predominantly located within the papillae of the lamina propria. For differential diagnosis, other papillomatous and verrucous lesions such as verrucous carcinomas or squamous cell carcinomas need to be ruled out. CASE REPORT: A 46-year-old patient with VX located on the alveolar process regio 26-28 is presented. Clinically, a 2 x 2 cm granular, oral mucosa surface lesion extending onto the palate occurred in regio 26-28. Biopsy was characterized light microscopically by the presence of swollen, elongated cells in the submucosa, an indication of VX alterations. Transmission electron microscopy demonstrated foam cells in the subepithelium containing numerous membrane-bound vesicles similar in diameter and showing a wide variation in electron density. Morphologically, these cells resembled macrophage-related cells. The lesion was excised in total with no evidence of recurrence after 9 months. DISCUSSION: The pathogenesis of VX is still unclear. The characteristic xanthoma cells may play a major role in VX. Microscopic analysis of the morphology of the foam cells indicated that they may represent a differentiated form of macrophages. Lipid vesicles inside these cells differed in their electron density indicating a heterogeneous biochemistry or different states of maturation.     

P31 The relationship between the relative amount of Porphyromonas gingivalis in saliva and halitosis

Objectives  Porphyromonas gingivalis is one of the microorganisms that most actively produce CH₃SH and we have reported that subjects with P . gingivalis have higher CH₃SH levels than subjects without P .  gingivalis . However, little is known about the relationship between P . gingivalis levels in saliva and the condition of oral malodor. In this study, we evaluated the association between the relative amount of P . gingivalis in saliva and halitosis in mouth air.
Methods  All of the subjects were patients at the Preventive Dentistry and Breath Odor Clinic of Kyushu Dental College, where they received a periodontal examination. Volatile sulfur compounds (VSC: hydrogen sulfide and methyl mercaptan) were measured using gas chromatography. Saliva samples were collected in a sterile plastic tube over a period of 5 min while the subject chewed on paraffin wax, and were then immediately stored at –80°C until use. Template DNA was obtained from the stored saliva using an Easy-DNA Kit (Invitrogen, CA, USA) according to the manufacturer's instructions. Conventional PCR assays were used to confirm the presence of P . gingivalis . A 5' nuclease TaqMan PCR was used to quantify P . gingivalis in saliva. The relative numbers of bacteria were measured using the comparative threshold cycle method.
Results  We found a quantitative relationship between the P . gingivalis levels in saliva and the condition of halitosis in mouth air.
Conclusion  We analyzed the relationship between the relative amount of P . gingivalis in saliva and oral malodor.     

Peripheral mechanisms of fatigue in muscles of normal and dystrophic mice.

We evaluated the contribution of different processes to fatigue of normal and dystrophic mouse muscles using an in vitro electromyography chamber. Fatigue was induced by repetitive nerve stimulation at 30 Hz for 0.5 s, every 2.5 s until tension decreased by about 50%. We monitored the compound nerve action potential (AP), compound muscle AP, and isometric tension responses to nerve stimulation, and compound muscle AP and tension responses to direct muscle stimulation. In normal mice, about 50% reduction in nerve-evoked tension occurred by 2.4 min in extensor digitorum longus (EDL), 4.8 min in diaphragm, and 9 min in soleus. Analysis of the responses revealed that the fatigue was caused by failure of more than one process in all muscles, and failure of nerve conduction did not contribute to fatigue in any muscle. Failure of neuromuscular transmission, muscle membrane excitation, and excitation-contraction (E-C) coupling and contractility accounted for 55, 45, and 0%, respectively, of the fatigue in EDL, for 21, 74, and 5% of the fatigue in diaphragm, and for 2, 54, and 44% of the fatigue in soleus. In dystrophic mice, while about 50% reduction in nerve-evoked tension occurred by 8.1 min in EDL and 5.6 min in diaphragm, only 29% reduction in tension occurred by 80 min in soleus. Failure of neuromuscular transmission, muscle membrane excitation, E-C coupling and contractility accounted for 22, 63 and 15% of the fatigue in EDL, for 21, 79, and 0% of the fatigue in diaphragm, and for 15, 59, and 26% of the fatigue in soleus. The proportion of slow-twitch oxidative fibers was more than normal in dystrophic EDL, but the same as normal in dystrophic diaphragm and soleus. The slower onset of fatigue was attributable to lesser failure of neuromuscular transmission in dystrophic EDL, and to lesser failure of E-C coupling and contractility in dystrophic soleus.     

Occupational injury and illness in the semiconductor manufacturing industry

Two thousand nine hundred and ninety-four reports of OSHA-reportable occupational injury or illness cases in 1984 from member companies of a national trade association of semiconductor manufacturing firms were analyzed. The 37 participating manufacturing facilities represented 16 companies employing over 95,000 persons, or approximately one-third of the U.S. work force for this industry in 1984. The annual incidence rate for all reportable injuries and illnesses was 2.7 per 100 full-time employees (FTE) for men and 3.7 per 100 FTE for women. Strains, sprains, or dislocations were the most frequently reported incidents (N = 956 [31.9%]), followed by cuts, lacerations, punctures, scratches, and abrasions (N = 445 [14.9%]), and chemical burns (N = 401 [13.4%]). Increased work-loss days per case were associated with manufacturing sites that did not have an employee health clinic on the premises, with custodial occupations, and with female gender.     

Mathematically directed single-cut osteotomy for correction of tibial malunion

In 1986 and 1987, four patients with tibial malunion involving both angular and torsional misalignment underwent surgical correction by a single-cut technique based on a mathematical model of long bone deformity. The technique involved a single surgical cut, followed by rotation of the two fragments along the osteotomy plane. The orientation of the osteotomy is based on a computer-assisted design. The deformity is measured on radiographs, computed tomography, and clinical exam and is then plotted on graphs to find the osteotomy orientation. The deformity involved varus and extension in four cases, internal rotation in 2, and external rotation in two. The deformities ranged from 9 to 26 degrees. The cutting angle of the osteotomy ranged from 50 to 66 degrees as measured from the transverse plane. Actual lengthening of 1 cm and functional lengthening over 1.5 cm was obtained without the use of bone graft. As no wedge of bone was removed, all corrected bones were easily suited to rigid internal fixation across the cut surface. In all cases, the desired correction was obtained within measurable error, and union was obtained with minimal immobilization. There were no soft tissue or joint contractures, and no neurovascular complications. In one patient, who had had four prior surgical procedures on the involved limb, an infection developed 6 weeks postoperatively that required debridement and delayed primary closure. As the technique involves only one cut, no wedge of bone is removed, no shortening occurs, and the osteotomy is highly suitable for rigid internal fixation. The described technique is the first to integrate in a precise way the correction of torsion with the correction of angular deformity.(ABSTRACT TRUNCATED AT 250 WORDS)