Off-Pump Extraanatomic Bypass from the Ascending to the Descending Aorta for Re-Operation of Interrupted Aortic Arch in an Adolescent

Abstract   The appearance of re-stenosis after repair of an interrupted aortic arch may be a surgical challenge due to adhesions. Here, we describe an approach using off-pump coronary artery bypass grafting techniques to reach the descending aorta through a median sternotomy in a patient with aortic arch stenosis after conduit repair. The 17-year-old patient with diagnoses of interrupted aortic arch and ventricular septal defect presented after two previous operations (one left lateral thoracotomy and one median sternotomy) with a stenosed vascular graft between ascending and descending aorta. Surgery was done via re-sternotomy without cardio-pulmonary bypass. An extraanatomic graft was used to connect ascending and descending aorta. When performing the distal anastomosis, the heart was exposed using a standard suction device. This case demonstrates that the use of modern techniques may facilitate surgical approaches dramatically. In our opinion the above-described technique is the first choice for all patients requiring arch repair following multiple previous operations, performed via sternotomy and thoracotomy.     

Accuracy of accelerated cine MR imaging at 3 Tesla in longitudinal follow-up of cardiac function

The ability of fast, parallel-imaging-based cine magnetic resonance (MR) to monitor global cardiac function in longitudinal exams at 3 Tesla was evaluated. Seventeen patients with chronic cardiac disease underwent serial cine MR imaging exams (n = 3) at 3 Tesla. Data were acquired in short-axis orientation using cine steady-state free precession (SSFP) with a spatial resolution of 2.5 x 1.9 mm(2) at 45 ms temporal resolution. Multislice imaging (three slices/breath-hold) was performed using TSENSE acceleration (R = 3) and standard single-slice cine (non-TSENSE) was performed at identical locations in consecutive breath-holds. End-diastolic volume (EDV), end-systolic volume (ESV), ejection fraction (EF) and myocardial mass (MM) of both cine approaches were compared for individual time-points as well as for longitudinal comparison. TSENSE-cine did not show significant differences for EDV (2.6 ml; P = 0.79), ESV (2.2 ml; P = 0.81), EF (-0.3%; P = 0.95) and MM (2.4 g; P = 0.72) in comparison with non-TSENSE. Longitudinal ANOVA analysis did not reveal significant differences for any parameter, neither for non-TSENSE data (all P > 0.7) nor for TSENSE data (all P > 0.9). Multifactorial ANOVA showed non-significant differences (all P > 0.7) at comparable data variances. Data acquisition was significantly shortened using TSENSE. Threefold accelerated multislice cine at 3 Tesla allows accurate assessment of volumetric LV data and accurate longitudinal monitoring of global LV function at a substantially shorter overall examination time.     

Kyphoplastie

Painful osteoporotic and malignant vertebral fractures are frequent causes of chronic back pain with negative consequences regarding immobility, quality of life, morbidity, mortality, and fracture incidence. The best currently available evidence-based treatment reduces vertebral fracture risk but does not totally prevent follow-up fractures. Kyphoplasty is a causal treatment of pain by internal stabilization that prevents the ongoing pain of constant vertebral (micro-)fracture. The indication for this minimally invasive procedure requires interdisciplinary discussion of the individual case to guarantee technical feasibility, increase the likelihood that kyphoplasty will indeed reduce pain, and embed this procedure in the individual patient’s long-term therapeutic concept or treatment of painful vertebral metastases. In addition to internal stabilization of painful vertebral fractures, kyphoplasty seeks to restore lost vertebral height, which appears promising in acute and painful vertebral fractures. Available controlled prospective studies demonstrate long-term patient benefits in terms of pain reduction, mobility, and improved quality of life.     

Vertebroplasty with self-locking hexagonal metal implants shows comparable primary and secondary stiffness to PMMA cement augmentation techniques in a biomechanical vertebral compression fracture model

With the growing incidence of vertebral compression fractures in elderly patients having a fair overall health condition, minimal-invasive treatment techniques are getting in focus of surgical therapy. Cement augmentation is widely performed and its complications and mechanical limitations are well described. Implants avoiding the side effects of cement augmentation while reaching the same level of stability would be desirable. The primary and secondary stability of a new augmentation method with self-locking hexagonal metal implants were investigated and compared with the performance of established augmentation options. 18 fresh-frozen human spinal specimens (Th12–L2/L3–L5) were tested with pure moments of 7.5 Nm in a six-degree-of-freedom spine simulator to investigate primary and secondary stability of three augmentation techniques: (1) vertebroplasty, (2) PMMA filled cavity and (3) hexagonal metal implants. An increasing three-step cyclic loading model was included. Elastic displacement and height loss under loading did not show significant differences between the three test groups. Investigation of primary and secondary stability evenly demonstrated comparable results for all techniques indicating an insufficiency to stabilise the fracture with higher load cycles. The newly introduced method for augmentation with the metal implant Spine Pearls achieved comparable results to bone cement based techniques in a biomechanical in vitro study. Midterm and longterm reduction preservation and ingrowth of the implants have to be proven in further studies.     

Magnetic resonance imaging for assessment of radiofrequency lesions in kidney tissue immediately after ablation: an experimental study

BACKGROUND AND PURPOSE: Radiofrequency ablation (RFA) is an attractive minimally invasive treatment option for small renal masses. The purpose of this study was to investigate the morphologic imaging appearance of RF lesions immediately after the ablation of kidney tissue using standard clinical MR sequences, as well as to investigate the correlation between MR and gross lesion size. MATERIALS AND METHODS: Ablations were performed 17 times in a standardized model of ex-vivo perfused porcine kidneys using a resistance-controlled RF device (250 W, 470 kHz) and a nonexpandable bipolar applicator inserted into the center of healthy renal parenchyma. The RF current was applied for 9 minutes at 20 W. Imaging was performed after ablation using standard clinical MR sequences: morphologic T(1)/T(2)- weighted images and an isotropic post-contrast T(1) high-resolution measurement (VIBE). Maximum lesion diameters were measured in three directions and were compared with the measurements of the gross lesions. Histologic (hematoxylin + eosin and nicotinamide adenine dinucleotide staining) and statistical analyses were performed. RESULTS: The gross pathologic examination showed a firm, white-yellow ablation zone sharply demarcated from the untreated tissue. The histologic examination confirmed cellular viability outside but not in the treatment zone. The RF lesions were hyperintense on T(1)-weighted images and hypointense on T(2)-weighted images. The lesion size measured in the VIBE images correlated best with the macroscopic lesion size (N = 16). CONCLUSIONS: Morphologic MR T(1) and T(2) sequences of RF lesions immediately after ablation produce reliable and consistent imaging characteristics. The post-contrast, high-resolution sequence (VIBE) enables the extent of the lesion to be determined accurately. The potential uses of this imaging strategy in clinical practise warrant further investigation on human renal-cell carcinoma.     

Diagnostic value of increased diffusion weighting of a steady-state free precession sequence for differentiating acute benign osteoporotic fractures from pathologic vertebral compression fractures

BACKGROUND AND PURPOSE: Differentiating acute benign from neoplastic vertebral compression fractures can pose a problem in differential diagnosis on routine MR sequences, as signal changes can be quite similar. Our purpose was to assess the value of increasing the diffusion weighting of a diffusion-weighted steady-state free precession (SSFP) sequence for differentiating these two types of vertebral compression fractures. METHODS: Twenty-nine patients with 32 acute vertebral compression fractures caused by osteoporosis (n = 15) or malignancy (n = 17) were examined with a diffusion-weighted SSFP sequence, a T1-weighted spin-echo sequence, and a short-inversion-time inversion recovery sequence. The SSFP sequence was performed with increased diffusion weighting (delta = 0.6, 3.0, 6.0, and 9.0 ms). The signal intensities of the fractured vertebral bodies were rated on a five-point scale from markedly hypointense to markedly hyperintense relative to normal adjacent vertebral bodies. Quantitative analysis was performed by region-of-interest measurements and by calculating the bone marrow contrast ratio. Statistical analysis was performed with the Mann Whitney U test and Student's t test. RESULTS: At delta = 3 ms, the osteoporotic fractures yielded hypointense signal in seven cases, isointense signal in six, and hyperintense signal in two. The fractures showed a progressive signal loss with increased diffusion weighting, so that hypointensity was reached in all but one case. All metastatic fractures had hyperintense signal with delta = 3 and 6.0 ms. With delta = 9.0 ms, four fractures became isointense. CONCLUSION: Increasing diffusion weighting can reduce false-positive hyperintense osteoporotic fractures or make hypointensity more obvious in cases of osteoporotic fractures.     

Reconstruction methods in postprocessing of CT- and MR-angiography of the aorta

The aim of the study was to investigate the use of 2D and 3D reconstructions in examinations of the aorta with CT and MRI. Postprocessing of 5 data sets including 2D MPR reconstructions, 3D MIP reconstructions and 3D volume rendering reconstructions acquired with contrast enhanced CTA and 5 data sets acquired with contrast enhanced MRA were performed. The luminal diameter, the length of the aneurysm and the detection of dissection was assessed for the reconstructions and the source images. Aneurysms and dissections of the aorta were correctly identified on source images. 2D MPR reconstructions and source images allow for a clear and easy image analysis including cases with high signal intensity or density of surrounding tissue and complex anatomical structures. The diameter and length of pathological findings can be determined correctly wit 2D MPR reconstructions, even when the vessel orientation is not exactly inplane or throughplane in relation to the source images. MIP reconstructions are suitable for contrast enhanced MRA data sets with high C/N ratio and volume rendering reconstructions are suitable for contrast enhanced CTA data sets, where calcifications and bone have also high density. For 3D visualization of large volumes MIP reconstructions are the method of choice for MRA and volume rendering reconstructions for CTA, respectively. In addition, 2D MPR can be necessary to determine the diameter and length of pathological findings.     

Long-Term Results of a Contemporary Metal-on-Metal Total Hip Arthroplasty : A 10-Year Follow-Up Study

The goal of the study was to evaluate the long-term results of a metal-on-metal articulation. We evaluated the results and histologic findings in patients who had undergone revision. One hundred total hip arthroplasties with a Lubrimet metal-on-metal articulation (Smith and Nephew, Rotkreuz, Switzerland) were implanted in 99 consecutive unselected patients in 1995 and 1996, and the results were prospectively analyzed up to a mean of 126 months postoperatively. Periprosthetic tissues of all 6 hips that had undergone revision because of aseptic loosening, mechanical failure, or periprosthetic fracture showed metallosis and extensive lymphocytic and plasma cell infiltration around the metal debris. With removal of the component because of aseptic loosening as the end point, survivorship was 98% for the stem and 96% for the cup.     

Urine analysis performed by flow cytometry: reference range determination and comparison to morphological findings, dipstick chemistry and bacterial culture results--a multicenter study

AIM: To validate whether quantitative flow-cytometric analysis of particulate matter in urine would allow for accurate and rapid enumeration of red blood cells (RBC), leukocytes (WBC), squamous epithelial cells (EC), casts, and bacteria, a Sysmex UF-100 analyzer was tested in a multicenter study. MATERIAL AND METHODS: At first, reference values were established and found to be < 14 for RBC, < 16 for WBC, < 9 for EC, < 2 for casts and < 173 for bacteria, respectively (counts per microl; 97.5 percentile). Due to the wide use of dipstick and microscopic sediment analysis in routine urine diagnostics, comparative studies on 950 random urine samples were performed. Bacterial counting combined with WBC enumeration was further compared in 266 routine urinary microbiologic cultures. RESULTS: Good correlations were found comparing UF-100 results of RBC (r = 0.89), WBC (r = 0.94), and EC (r = 0.74) with Fuchs-Rosenthal Chamber (FRC) counts. However, some misclassification of casts (r = 0.32) could be observed. Correlations of UF-100 with dipstick and sediment testing was significant (p < 0.001), but the scatter of the latter two methods is too wide to consider them as quantitative methods. Promising results further revealed that the analyzer has a good negative predictive value (NPV) for microbiologically negative cultures, especially for cultures with bacterial counts of 10(5)/l (NPV = 95%). CONCLUSION: The analyzer is capable of providing rapid and reliable urine analysis of cellular particles avoiding the known imprecision of dipstick and sediment methodology. Thus, when used in an algorithm, combined with dipstick or quantitative urine chemistry analysis (for hemoglobin, esterase, protein, glucose, etc.), this analyzer might serve as a rapid and accurate screening tool in routine urine analysis, thereby reducing manual reviewing rate as well as the number of missed samples, compared to screening with dipstick alone.