Effects of industrial noise on circumpulpar dentin - a field emission scanning electron microscopy and energy dispersive spectroscopy analysis

Chronic exposure to Industrial Noise (IN), rich in Low Frequency Noise (LFN), causes systemic fibrotic transformation and sustained stress. Dental wear, significantly increased with exposure to LFN, affects the teeth particularly through the circumpulpar dentin. Our goal is to understand the consequences of IN exposure on the circumpulpar dentin of Wistar rats. 10 Wistar rats were exposed to IN for 4 months, according to an occupationally simulated time schedule and 10 animals were used as age-matched controls. The first and the second upper and lower molars of each animal were processed for observation by Field Emission Scanning Electron Microscopy (FESEM) and Energy Dispersive Spectroscopy (EDS) analysis was performed. In exposed animals FESEM showed a 2.0 to 6.0 μm-dense mineral band between dentin and the pulp with no regular continuity with the tubules. This structure had a few tubules where the odontoblasts processes could be observed embedded within the band and collagen fibers were trapped inside. EDS analysis revealed that it was hydroxyapatite similar to dentin, with a higher carbon content. FESEM results show that the band may be tertiary reparative dentin formed by odontoblast-like cells, but the increased amount of carbon (EDS) could mean that it is sclerotic dentin. IN should be acknowledge as a strong stimulus, able to cause an injury to odontoblasts and to the formation of reparative tertiary dentin, in a process that may accelerate the aging of the teeth, either by direct impact of acoustic pressure pulsations or by increased stress and dental wear.     

The Number of Bleaching Sessions Influences Pulp Tissue Damage in Rat Teeth

Introduction

Hydrogen peroxide tooth bleaching is claimed to cause alterations in dental tissue structures. This study investigated the influence of the number of bleaching sessions on pulp tissue in rats.

Methods

Male Wistar rats were studied in 5 groups (groups 1S–5S) of 10 each, which differed by the number (1–5) of bleaching sessions. In each session, the animals were anesthetized, and 35% hydrogen peroxide gel was applied to 3 upper right molars. Two days after the experimental period, the animals were killed, and their jaws were processed for light microscope evaluation. Pulp tissue reactions were scored as follows: 1, no or few inflammatory cells and no reaction; 2, <25 cells and a mild reaction; 3, between 25 and 125 cells and a moderate reaction; and 4, 125 or more cells and a severe reaction. Results from each experimental group were compared between groups and within groups to the corresponding unbleached upper left molars and analyzed for significant differences using the Kruskal-Wallis test (P < .05).

Results

All tissue sections showed significant bleaching-induced changes in the dental pulp. After 1 bleaching session, necrotic tissue in the pulp horns and underlying inflammatory changes were observed. The extent and intensity of these changes increased with the number of bleaching sessions. After 5 sessions, the changes included necrotic areas in the pulp tissue involving the second third of the radicular pulp and intense inflammation in the apical third.

Conclusions

The number of bleaching sessions directly influenced the extent of pulp damage.     

Dental injury after conventional direct laryngoscopy: a prospective observational study

This observational study assessed the frequency and risk factors of dental damage after classic direct laryngoscopy for tracheal intubation in 536 adult patients. The patients' sex, age, height, weight, dental condition, dental mobility, Mallampati class, interincisor gap, thyromental distance, neck circumference, and head and neck extension were recorded. From anaesthesia records, the difficulty of intubation, the number of attempts, type of neuromuscular blocking agent used and duration of anaesthesia were recorded. After anaesthesia, examination revealed that 134 patients (25.0%) had dental damage affecting 162 teeth (147 maxillary; 15 mandibular). Enamel fracture was the commonest injury. In tooth number 21, the interincisor gap (OR 2.5 (95% CI 1.0–5.9)) and in tooth number 22, the number of intubation attempts (OR 5.3 (95% CI 1.3–22.0)) were considered a risk factor for dental injury. Conventional direct laryngoscopy is associated with a strikingly high incidence of dental damage, although specific risk factors remain unclear.     

Laser Doppler anemometry measurements of steady flow through two bi-leaflet prosthetic heart valves

Introduction

In vitro hydrodynamic characterization of prosthetic heart valves provides important information regarding their operation, especially if performed by noninvasive techniques of anemometry. Once velocity profiles for each valve are provided, it is possible to compare them in terms of hydrodynamic performance. In this first experimental study using laser doppler anemometry with mechanical valves, the simulations were performed at a steady flow workbench.

Objective

To compare unidimensional velocity profiles at the central plane of two bi-leaflet aortic prosthesis from St. Jude (AGN 21 - 751 and 21 AJ - 501 models) exposed to a steady flow regime, on four distinct sections, three downstream and one upstream.

Methods

To provide similar conditions for the flow through each prosthesis by a steady flow workbench (water, flow rate of 17L/min. ) and, for the same sections and sweeps, to obtain the velocity profiles of each heart valve by unidimensional measurements.

Results

It was found that higher velocities correspond to the prosthesis with smaller inner diameter and instabilities of flow are larger as the section of interest is closer to the valve. Regions of recirculation, stagnation of flow, low pressure, and flow peak velocities were also found.

Conclusions

Considering the hydrodynamic aspect and for every section measured, it could be concluded that the prosthesis model AGN 21 - 751 (RegentTM) is superior to the 21 AJ - 501 model (Master Series). Based on the results, future studies can choose to focus on specific regions of the these valves.     

Analysis of the interfacial micromorphology and bond strength of adhesive systems to Er:YAG laser-irradiated dentin

This study evaluated the effects of different parameters of dentin irradiation with erbium-doped yttrium aluminum garnet (Er:YAG) laser on bond strength to dentin and analyzed the ultramorphological characteristics of resin–laser-irradiated dentin interfaces using a transmission electron microscope (TEM). Dentin surfaces were abraded with SiC paper (600 grit) or Er:YAG laser-irradiated (120/4, 140/6, 180/4, or 200/6 mJ/Hz). Three adhesive systems were tested: Single Bond Plus (3M ESPE), Clearfil Protect Bond (Kuraray Med.), and Clearfil Tri-S Bond (Kuraray Med.). Treatments were performed over flat dentin surfaces of human third molars. Specimens were stored in distilled water for 1 week or 6 months and prepared for a microtensile bond strength test and interfacial ultrastructure for analysis. Microtensile bond strength data (n?=?5) were analyzed with three-way analysis of variance. Irradiation with Er:YAG laser did not reduce the bond strength values for self-etching adhesives even after 6 months of water storage. The hybrid layer formation was observed only when the adhesives were applied to non-irradiated dentin (control group). Nanoleakage occurred in all resin–dentin interfaces using Single Bond Plus for both periods. Nanoleakage pattern and bond strength of self-etching adhesives to dentin were less affected by Er:YAG laser irradiation and by the 6-month storage in water than was those of the etch-and-rinse adhesive. TEM analysis revealed no hybridization when dentin was laser-irradiated. Clinical significance: Minimally invasive caries removal has been proposed. Nevertheless, bonding mechanisms to lased dentin are not entirely described. Knowing the interaction between the treated dentin and bonding agents and its behavior over time is of utmost importance for new technologies. Regarding that, two-bottle self-etching adhesive system provided a more consistent evidence of its better behavior when bonding to lased substrate.     

Platelet aggregation at discharge: A useful tool in acute coronary syndromes?

IntroductionInhibition of platelet aggregation appears two hours after the first dose of clopidogrel, becomes significant after the second dose, and progresses to a steady-state value of 55% by day seven. Low response to clopidogrel has been associated with increased risk of stent thrombosis and ischemic events, particularly in the context of stable heart disease treated by percutaneous coronary intervention.ObjectiveTo stratify medium-term prognosis of an acute coronary syndrome (ACS) population by platelet aggregation.MethodsWe performed a prospective longitudinal study of 70 patients admitted for an ACS between May and August 2009. Platelet function was assessed by ADP-induced platelet aggregation using a commercially available kit (Multiplate^® analyzer) at discharge. The primary endpoint was a combined outcome of mortality, non-fatal myocardial infarction, or unstable angina, with a median follow-up of 136.0 (79.0–188.0) days.ResultsThe median value of platelet aggregation was 16.0 U (11.0–22.5 U) with a maximum of 41.0 U and a minimum of 4.0 U (normal value according to the manufacturer: 53–122 U). After ROC curve analysis with respect to the combined endpoint (AUC 0.72), we concluded that a value of 18.5 U conferred a sensitivity of 75.0% and a specificity of 68% to that result. We therefore created two groups based on that level: group A – platelet aggregation <18.5 U, n = 44; and group B – platelet aggregation ≥18.5 U, n = 26. The groups were similar with respect to demographic data (age 60.5 [49.0–65.0] vs. 62.0 [49.0–65.0] years, p = 0.21), previous cardiovascular history, and admission diagnosis. There were no associations between left ventricular ejection fraction, GRACE risk score, or length of hospital stay and platelet aggregation. The groups were also similar with respect to antiplatelet, anticoagulant, proton pump inhibitor (63.6 vs. 46.2%, p = 0.15) and statin therapy. The variability in platelets and hemoglobin was also similar between groups. Combined event-free survival was higher in group A (96.0 vs. 76.7%, log-rank p < 0.01). Platelet aggregation higher than 18.5 U was an independent predictor of the combined event (HR 6.75, 95% CI 1.38–32.90, p = 0.02).ConclusionIn our ACS population platelet aggregation at discharge was a predictor of medium-term prognosis.     

Coronary artery anomalies

Coronary artery anomalies (CAAs) are a rare entity but their true incidence in the general population has yet to be determined. Most CAAs are asymptomatic, but they are nevertheless the second leading cause of sudden death in apparently healthy young athletes. The new imaging methods available to cardiologists, including CT angiography and MRI, now enable noninvasive diagnosis and characterization of these anomalies. The authors review the literature and present a retrospective study of 360 consecutive patients who underwent cardiac CT angiography. Demographic, clinical and angiographic characteristics were studied. The incidence of CAAs in this population was 2.69%. In order to better characterize this disorder, including diagnostic strategy, screening, treatment and prognosis, the authors suggest the establishment of a national registry of cardiac CT angiography. Such a registry would fill the existing gap in information on exams performed in the country, enriching current knowledge about this disease and noninvasive cardiac imaging in Portugal.