Thermal chondroplasty with radiofrequency energy. An in vitro comparison of bipolar and monopolar radiofrequency devices

The purpose of this study was to examine the in vitro effects of three radiofrequency energy devices (two bipolar devices and one monopolar device) for the performance of thermal chondroplasty. Thirty-two fresh bovine femoral osteochondral sections (approximately 3 x 4 x 5 cm) from eight cows were divided into four groups (three treatment patterns and one sham-operated group with eight specimens per group). The three treatment patterns consisted of 1) radiofrequency energy delivered by a mechanical jig at 1 mm/sec in a contact mode (50 g of pressure), 2) radiofrequency energy delivered by a mechanical jig at 1 mm/sec in a noncontact mode (1 mm between probe tip and articular cartilage surface), and 3) radiofrequency energy smoothing of abraded cartilage during arthroscopic visualization. Thermal smoothing of the abraded cartilage surface was accomplished with all three devices. Significant chondrocyte death, as determined by confocal laser microscopy and cell viability staining, was observed with each device. The bipolar radiofrequency systems penetrated 78% to 92% deeper than the monopolar system. The bipolar systems penetrated to the level of the subchondral bone in all osteochondral sections during arthroscopically guided paintbrush pattern treatment. Radiofrequency energy should not be used for thermal chondroplasty until further work can establish consistent methods for limiting the depth of chondrocyte death while still achieving a smooth articular for thermal chondroplasty until further work can establish consistent methods for limiting the depth of chondrocyte death while still achieving a smooth articular surface.     

Thermal capsulorrhaphy treatment of shoulder instability: basic science

Thermal capsulorrhaphy is a new treatment modality for shoulder instability, where the joint capsular tissue is heated and reduced in length by laser or radiofrequency energy to regain joint stability. Experimental studies have shown that (1) joint capsular tissue can be modified significantly (shortened) by thermal energy at the temperature range of 70 degrees to 80 degrees C; (2) thermal energy causes immediate deleterious effects such as loss of the mechanical properties, collagen denaturation, and cell necrosis; (3) thermally treated tissue is repaired actively by a residual population of fibroblasts and vascular cells, with concomitant improvement of mechanical properties; (4) the shrunken tissue stretches with time if the tissue is subjected to physiologic loading immediately after surgery; and (5) leaving viable tissue between treated regions significantly improves the healing process. Therefore, the application of thermal energy to achieve joint stability relies on an initial effect (shrinkage), and to a great extent the tissue's healing response to regain the tissue's mechanical properties. Particularly, induction of active repair and joint capsular thickening with tissue remodeling regulated by functional demand seem to be essential factors for a successful outcome. Thermal treatment causes an initial deleterious effect on the tissue's properties, and overtreatment can lead to severe immediate and permanent tissue damage. In addition, scientific data of newly developed devices are limited, and the information from manufacturers often is unreliable and misleading. Carefully controlled long-term clinical and scientific studies should be done to additionally clarify the advantages and disadvantages of this technique.     

Instrumented measurement of in vivo anterior-posterior translation in the canine knee to assess anterior cruciate integrity.

This study was designed to objectively quantify in vivo anterior-posterior canine knee translation relative to anterior cruciate ligament (ACL) integrity. Tibial translation was determined in one knee of 43 crossbreed hounds from radiographs performed while a set anterior and then posterior force was applied to the tibia using a custom designed device. The total (TTT), anterior (ATT), and posterior (PTT) tibial translation were measured (absolute) and normalized to the width of the tibia (normalized). Absolute and normalized TTT was significantly greater in ruptured ACL knees than in partially disrupted (PD) ACL knees, which were significantly greater than in intact ACL knees. ATT and PTT was significantly greater in ruptured ACL knees than in PD or intact ACL knees, which were not significantly different. The sensitivity and specificity of normalized TTT to distinguish knees with intact from PD ACLs were both 100%. Normalized TTT to distinguish knees with PD from ruptured ACLs had a sensitivity and specificity of 100% and 92%, respectively. Intra- and inter-observer intra-class correlation coefficients were 0.84 or higher for all translations. This precise non-invasive technique to assess canine knee translational stability and ACL integrity permits repetitive, objective measurements for diagnostic use and to assess therapeutic intervention efficacy.     

Thermal response and torque resistance of five cortical half-pins under simulated insertion technique

A model was developed that can quantitate heat generation during placement of half-pins in cortical bone. Five half-pins were tested to assess differences in insertion torque, heat generation, and microdamage at the pin-bone interface. Thin thermocouple probes were placed 0.5 mm from the track of the pin and within the pin to measure its temperature during insertion. Scanning electron microscopy was used to view the pin-bone interface to assess the microdamage during placement. The design of the tip of the pin influenced insertion torque and heat generation. Higher heat generation was measured when a thermocouple was placed within the pin itself and less was measured when thermocouple probes were placed within bone samples 0.5 mm from the impending pin track. Furthermore, insertion torque and thermal responses were related, but there were no significant differences in microdamage to bone when different pins and drilling/tapping techniques were used. Due to the significant heat generation at the pin-bone interface, proper cooling with saline irrigation should be applied during pin insertion regardless of the design of the pin. The microdamage observed at the surface of the pin track may have significant implications with regard to loosening of pins, but such effects must be studied with in vivo models.     

Increased platelet adhesion and aggregation in hypertensive patients: effect of atenolol.

Fourteen patients with established hypertension followed a double-blind crossover-styled trial to study the effects of 100 mg/day atenolol compared to placebo. Atenolol was found to be an effective antihypertensive agent, reducing both systolic and diastolic blood pressure. Hypertensive patients appear to have increased in vitro platelet adhesion and aggregation. Atenolol significantly reduced platelet adhesion, but had little effect on aggregation. This may be important in contributing towards the now-recognised cardio-protective effect of the beta-adrenoceptor blocking agents. Blood chemistry and haematological parameters were unchanged; but whereas plasma cholesterol and plasma triglyceride levels remained normal, there was a significant fall in plasma high-density lipoprotein cholesterol levels. Side effects were very few.     

Multiple projection optical diffusion tomography with plane wave illumination

We describe a new data collection scheme for optical diffusion tomography in which plane wave illumination is combined with multiple projections in the slab imaging geometry. Multiple projection measurements are performed by rotating the slab around the sample. The advantage of the proposed method is that the measured data are more compatible with the dynamic range of most commonly used detectors. At the same time, multiple projections improve image quality by mutually interchanging the depth and transverse directions, and the scanned (detection) and integrated (illumination) surfaces. Inversion methods are derived for image reconstructions with extremely large data sets. Numerical simulations are performed for fixed and rotated slabs.     

Growing pains: are they due to increased growth during recumbency as documented in a lamb model?

The rate and patterns of longitudinal bone growth are affected by many different local and systemic factors; however, uncompromised growth is usually considered to be smoothly continuous, with predictable accelerations and decelerations over periods of months to years. The authors used implanted microtransducers to document bone growth in immature lambs. Bone length measurements were sampled every 167 seconds for 21 to 25 days. The authors show that at least 90% of bone elongation occurs during recumbency and almost no growth occurs during standing or locomotion. The authors hypothesize that growth may also occur in children during rest or sleep, thus supporting the concept of nocturnal growth and perhaps a relationship to growing pains.