再生丝素/NMMO·H2O溶液的流变性能

使用N-甲基吗啉-N-氧化物的水合物(NMMO·H2O)作为再生丝素的溶剂.可以得到w=0.10～0.25的再生丝素/NMMO·H2O溶液.研究了再生丝素/NMMO·H2O溶液流变性能,讨论了剪切速率、温度和溶液中的再生丝素的含量对再生丝素/NMMO·H2O溶液流变性能的影响.     

Ⅰ、Ⅲ型前胶原基因第2外显子核酶对靶RNA的体外切割活性的研究

目的 体外研究锤头型α1Ⅰ型及Ⅲ型前胶原基因第2外显子片段核酶对各自靶RNA分子的切割活性及反应条件。同时观察两反义核酶对瘢痕中成纤维细胞胶原合成的影响。方法 将含α1Ⅰ型及Ⅲ型前胶原基因第2外显子片段的重组质粒(pT-Ⅰ、pT-Ⅲ)，经体外^32P标记转录后形成产物靶RNA。同时将含特异性核酶基因的重组质粒(pT-gⅠ、pT-gⅢ)进行非标记的体外转录，产物(核酶)与各自的^32P-靶RNA按不同的条件混和反应，电泳后放射自显影观察结果。将构建好的核酶以脂质体包裹后导入培养的成纤维细胞内，采用图像分析法观察核酶对成纤维细胞Ⅰ型、Ⅲ型胶原蛋白mRNA合成的影响。结果 两种核酶在37℃、42℃均能有效切割各自的靶RNA，对Mg^2 浓度的要求范围较宽(10～20mmol／L)；反应温度从65℃逐渐降至并维持在37℃的条件下核酶切割活性显提高。Ⅰ、Ⅲ型胶原蛋白mRNA的表达明显降低，胶原蛋白生成降低，胶原生成明显受抑制。结论 针对α1Ⅰ型及Ⅲ型前胶原基因第2外显子片段的核酶能有效地在体外对靶RNA进行切割并能有效地抑制瘢痕中成纤维细胞胶原的合成。     

Stability of poly(D,L-lactide-co-glycolide) and leuprolide acetate in in-situ forming drug delivery systems.

In-situ forming drug delivery systems are prepared by dissolving a drug and a biodegradable polymer (poly(D,L-lactide-co-glycolide), PLGA) in a biocompatible organic solvent (In-situ implant, ISI) or further emulsified into an external phase (oil or aqueous solution), resulting in oil-in-oil or oil-in-water emulsions (In-situ forming microparticles, ISM). The chemical stability of PLGA and the drug is a major concern. In this study, the stability of PLGA and leuprolide acetate in the in-situ forming systems and lyophilized sponges was investigated. The degradation of PLGA increased with increasing storage temperature and water content in the biocompatible solvents. A faster degradation occurred in polar protic solvents (2-pyrrolidone, PEG 400, triethyl citrate) than in polar aprotic solvents (N-methyl-2-pyrrolidone, DMSO, triacetin, ethyl acetate). The presence of leuprolide acetate significantly accelerated PLGA degradation, especially in solution state. PLGA was stable in oily suspensions at 4 degrees C and degraded only slightly faster than solid powder at 25 degrees C. No interaction between the oils and the PLGA was observed as indicated by an unchanged T(g) of approx. 47 degrees C. PLGA underwent a slight degradation at 4 degrees C after 150 days in water and saturated sodium chloride solution. The degradation was slower in saturated sodium chloride solution than in water at 25 degrees C. Residual acetic acid in lyophilized sponges facilitated the PLGA degradation in contrast to dioxane. Leuprolide acetate did not affect the PLGA stability negatively. However, lidocaine significantly enhanced the polymer degradation in the sponges. Finally, leuprolide acetate was chemically stable in the sponges, the oils and the polymer solutions in suspension state, but unstable (aggregation) when dissolved in the polymer solutions and stored at 25 degrees C and 40 degrees C.     

左双腔支气管导管管端位置与吸气峰压变化的关系

目的 观测无隆突钩双腔支气管导管(DLT)管端位置与吸气峰压(Ppeak)以及肺顺应性环形状改变的关系，探讨用Ppeak和顺应性环的变化评估DLT管端位置的可行性。方法 拟行右侧剖胸手术的成年患者32例，静脉诱导后插入左Mallinckrodt DLT，吸入氧化亚氮和地氟醚维持麻醉。按纤维支气管镜(FOB)确认DLT管端位置和通气方式将观测过程分为四个阶段：第一阶段(S1)，管端位置正确的双肺通气；第二阶段(S2)，管端位置正确的左侧单肺通气；第三阶段(S3)，管端插入左下支气管(置管过深)的左侧单肺通气；第四阶段(S。)，管端处在左支气管开口(置管偏浅)的左侧单肺通气。每阶段均机械通气15min。结果 回归方程预计插管深度与FOB检查符合者占71．9％。S2时Ppeak值比S1时增加50．8％，肺顺应性(Cdyn)值减少36．2％；S3时Ppeak值比S1时增加87．4％，Cdyn值减少56．8％。PV环曲线斜率向右明显移位，环体显著延长。结论 用无隆突钩DLT行肺隔离，在无FOB定位的条件时，联合应用听诊法、回归方程预计插管深度、动态监测气道峰压和P-V环的变化综合评估，可提高DLT管端的正确到位率。单肺通气的气道峰压超过双肺通气时的1．65倍，且气道峰压超过25cm H2O．应高度怀疑DLT管端发生过深移位。     

Localization of ulnar neuropathy at the elbow using new stimulator for the inching test.

OBJECTIVE: To evaluate the usefulness of the TenElectrodes, a new stimulator for inching test, in the diagnosis and localization of ulnar neuropathy at the elbow (UNE). METHODS: Sixty-two ulnar nerves in 40 control subjects and 24 ulnar nerves in 23 patients with typical symptoms and signs of UNE were studied. The inching test of ulnar motor nerve using TenElectrodes was done along 8 cm across the elbow in the extended position. RESULTS: In the inching test of the control group, the mean segmental latency difference was 0.19+/-0.08 ms. Maximal latency difference over a 1 cm segment did not exceed 0.40 ms in any of the controls but exceeded 0.5 ms or more in all clinical UNE patients. In all UNE patients, the lesion sites were identified by the inching test using TenElectrodes: the retroepicondylar groove (54.2%), the humeroulnar arcade (29.2%), and dual compression (16.6%). CONCLUSIONS: TenElectrodes is a useful stimulator for the inching test in the diagnosis of UNE. The precise localization of compression was possible in all patients with UNE and the most common site was the retroepicondylar groove.     

端粒酶活性检测在乳腺癌诊断中的意义

[目的 ]探讨细针穿刺乳腺肿瘤组织的端粒酶活性检测在乳腺癌诊断中的意义 .[方法 ]用聚合酶链反应 酶联免疫吸附测定法检测 79例术前乳腺肿瘤细针穿刺活检标本和大体标本的端粒酶活性 ,并与病理诊断进行比较 .[结果 ]乳腺癌 6 5例中穿刺组织端粒酶呈阳性的为 5 7例 ,阳性率为 88% ;大体组织端粒酶呈阳性的为 5 4例 ,阳性率为 83% .淋巴结转移者端粒酶活性高于无淋巴结转移者 .乳腺良性疾病 14例中端粒酶呈阳性的为 2例 ,阳性率为 14 % .[结论 ]术前乳腺肿瘤穿刺组织的端粒酶活性检测有利于乳腺肿瘤的早期诊断及鉴别诊断 .     

开放复位可塑形钛板内固定治疗跟骨骨折33例

目的 评价开放复位可塑形钛板内固定治疗跟骨骨折的疗效。方法 对33例(37足)以后关节突移位为主的跟骨骨折,行跟骨外侧入路、开放性复位可塑形钛板螺钉内固定,必要时行植骨术(18例)。结果 平均随访11.5个月,参照Mary—land food score评分,对患足是否疼痛、步态、距下关节及踝关节活动度、是否支架辅助、术后X线摄片等加以评估,19足疗效为优,17足为良,1足可。其中钛板断裂1例,手术切口皮缘坏死1例,换药后自愈。结论 跟骨外侧入路开放复位可塑形钛板螺钉内固定,必要时植骨术是治疗跟骨骨折的有效方法。     

多层螺旋CT尿路造影在尿路梗阻性疾病中的临床应用

目的探讨多层螺旋CT尿路造影在泌尿系梗阻性疾病诊断中的应用价值。方法对48例泌尿系统梗阻性疾病者,分别进行多层螺旋CT平扫及多时相期CT增强扫描。对增强后各期图像进行相关处理,以不同的三维重建方式获得CTA、CTU影像。所有病例均经临床及手术证实。结果48例中肾脏及输尿管先天畸形者15例;输尿管阴性结石致肾盂输尿管积水者4例;泌尿系炎症者5例;肾及输尿管、膀胱结核6例;外源性压迫导致肾盂及输尿管积水者8例;泌尿系肿瘤者10例。结论多层螺旋CT泌尿系造影对尿路梗阻性疾病的诊断具有很高的应用价值。     

大鼠肾移植模型技术的改进

目的 为开展器官移植的实验研究，建立了大鼠异体肾移植模型。方法使用Wistar大鼠分别作为供者和受者，采用原位低温灌洗，肾动脉带一小段主动脉，肾静脉带一小段下腔静脉、输尿管末端带一直径约为0．5cm的膀胱瓣的供者手术方式；受者主动脉与供者主动脉、受者下腔静脉与供者下腔静脉进行端侧吻合，在受者膀胱上剪去一膀胱瓣与供者相同大小的圆瓣，然后进行一层膀胱吻合。结果 第一阶段为实验探索阶段，经过半年近150次的实验摸索，克服了移植物灌洗、血管吻合、膀胱吻合等技术难关，终于建立了比较稳定的大鼠同种异体肾移植模型。第二阶段为模型成熟阶段，冷热缺血时间、血管吻合的速度以及手术时间都比第一阶段有所缩短。手术成功率为85％左右，动物死亡的原因主要为血管吻合口出血、灌洗不良、休克、血栓形成以及膀胱漏尿致弥漫性腹膜炎等。结论 此模型容易掌握，可以在条件比较简单的实验室开展，除常规显微外科器械外不需要特殊的器械或设备。     

沟通艺术在护理管理中的运用

现代管理理念已由单纯管理型向服务型转变。为了能更好地服务于临床护理人员，实现护理的科学管理，管理者必须学会运用有效的沟通技巧与护理人员进行信息及情感交流。[第一段]