Repair of peripheral nerve defects in the upper extremity

Repair of peripheral nerve defects in the upper extremity using end-to-end coaptation is accomplished by one of four techniques: in situ mobilization, rerouting and transposition, joint positioning, and bone shortening. A key concern is the amount of tension generated when nerves are elongated to overcome a gap defect. The evidence indicates that elongation should be limited to 8% to 10% of the original length to avoid neural ischemia. It should be noted, however, that when repairs are delayed, the vascularity of nerves is increased. As a result, compared with acute injuries, chronic injuries will tolerate the same degree of elongation with less neural ischemia despite increased stiffness. The mesoneural attachments along each end of the nerve may be safely stripped to a distance of 8 to 12 cm when mobilizing the nerve. Larger nerves tolerate greater lengths of mobilization than smaller nerves. The maximum amount of mobilization that does not produce ischemia can be expressed as a ratio of the diameter of the nerve to the length mobilized and its value is 1:45. The amount of nerve mobilization required for a secondary repair may be reduced by the initial application of tension to unrepaired nerves, thereby reducing the amount of retraction. As the interval to repair increases, nerve retraction results in up to a six-fold increase in the gap defect that must be overcome. Finally recommendations exist for the repair of peripheral nerve segmental defects in the acute setting.     

Percutaneous pins versus volar plates for unstable distal radius fractures: a biomechanic study using a cadaver model

PURPOSE: A biomechanic study using a cadaver model of a dorsally unstable distal radius fracture was used to compare the stability of percutaneous pinning and volar fixed-angle plating. Among the many surgical options for treating distal radius fractures are percutaneous pinning and internal plate fixation. Although percutaneous pin fixation requires less soft-tissue trauma and has low complication rates, plate fixation allows for early active movement with good clinical results. The biomechanic stability of these 2 methods was studied by using a cadaver model of a dorsally unstable intra-articular distal radius fracture. METHODS: This study was performed on 7 fresh-frozen cadaver arms, in each of which an unstable intra-articular fracture with dorsal comminution was created. The fracture was first fixed with 0.062-mm K-wires inserted in standard crossed fashion and was tested in a pneumatic loading device that indirectly loaded the wrists through the 5 motor tendons 3 times at each level of force in flexion and extension. Testing was then repeated after removal of the pins and fixation with a fixed-angle DVR distal volar radius plate system (Hand Innovations, Inc., Miami, FL). Testing was performed in flexion up to 68 N and in extension up to 100 N, and the distance across the fracture site was measured. RESULTS: Volar plating was significantly more stable than pinning, with an average movement across the fracture site of 2.51 mm for pin fixation and 1.07 mm for plate fixation. The pins also showed a substantial degree of slipping after repeated stressing, but the plates remained stable. CONCLUSIONS: These results show the superior biomechanic stability of internal fixation using plates for dorsally comminuted intra-articular distal radius fractures in this cadaver model. Further clinical correlations are needed.     

Overcoming peripheral nerve gap defects using an intact nerve bridge in a rabbit model

This study investigated the intact nerve bridge technique for overcoming peripheral nerve gap defects in a rabbit model. To create the intact nerve bridge, a 1-cm segment of the peroneal nerve is resected leaving a gap defect. The proximal and distal peroneal nerve stumps are sutured 1 cm apart, in an end-to-side fashion, to the intact tibial nerve epineurium. Four experimental groups were used (n = 10): primary repair of resected segment; intact nerve bridge; nerve autograft; and gap in situ control. Evaluation after 12 weeks included measurement of isometric muscle contraction force, axonal counting, wet muscle weights, and histologic examination. The results of this study support two main conclusions, in a rabbit model: (a) regenerating axons can use the epineurium of an intact nerve to bridge a gap defect; (b) there is no significant difference in the functional recovery between standard nerve autografts and the intact nerve bridge technique.     

Use of spleen organ cultures to monitor hemopoietic progenitor cell regeneration following irradiation and marrow transplantation

After lethal irradiation of C57BL mice followed by the injection of 10(7) marrow cells, total cellularity and progenitor cell levels exceeded pretreatment levels within 12 days in the spleen, but regeneration remained incomplete in the marrow. The exceptional regenerative capacity of progenitor populations in the spleen was observed in organ cultures of spleen slices prepared 24 hr after irradiation and transplantation, excluding continuous repopulation from the marrow as a significant factor in splenic regeneration.