Midterm Outcomes of the Dissected Aorta Repair Through Stent Implantation Trial

1. Download : Download high-res image (134KB)
2. Download : Download full-size image

     

UHPLC-MS/MS测定人血浆中美托洛尔的含量

目的 建立测定人血浆中美托洛尔含量的UHPLC-MS/MS分析方法。方法 采用Agilent RRHD PLUS C₁₈色谱柱（2.1 mm×50 mm,1.8 μm）,0.2%甲酸水溶液-乙腈（68∶32）为流动相。质谱采用电喷雾离子源（ESI）,多反应监测（MRM）,检测离子为正离子,分别选择m/z 268/116、237/194作为美托洛尔和内标（卡马西平）的检测离子对。结果 血浆中美托洛尔在1.012~759.0 ng·mL^-1内线性关系良好（r=0.999 2）。高、中、低浓度美托洛尔的基质效应分别为105.9%,106.1%,106.9%;平均回收率分别为83.0%,99.3%,95.2%。批内精密度RSD≤3.22%,批间精密度RSD≤4.14%。结论 该方法简便、灵敏、快速、准确,适用于血浆中美托洛尔的含量测定。     

Small area estimation of under-5 mortality in Bangladesh,Cameroon, Chad,Mozambique, Uganda,and Zambia using spatially misaligned data

Background

The under-5 mortality rate (U5MR) is an important metric of child health and survival. Country-level estimates of U5MR are readily available, but efforts to estimate U5MR subnationally have been limited, in part, due to spatial misalignment of available data sources (e.g., use of different administrative levels, or as a result of historical boundary changes).

Methods

We analyzed all available complete and summary birth history data in surveys and censuses in six countries (Bangladesh, Cameroon, Chad, Mozambique, Uganda, and Zambia) at the finest geographic level available in each data source. We then developed small area estimation models capable of incorporating spatially misaligned data. These small area estimation models were applied to the birth history data in order to estimate trends in U5MR from 1980 to 2015 at the second administrative level in Cameroon, Chad, Mozambique, Uganda, and Zambia and at the third administrative level in Bangladesh.

Results

We found substantial variation in U5MR in all six countries: there was more than a two-fold difference in U5MR between the area with the highest rate and the area with the lowest rate in every country. All areas in all countries experienced declines in U5MR between 1980 and 2015, but the degree varied both within and between countries. In Cameroon, Chad, Mozambique, and Zambia we found areas with U5MRs in 2015 that were higher than in other parts of the same country in 1980. Comparing subnational U5MR to country-level targets for the Millennium Development Goals (MDG), we find that 12.8% of areas in Bangladesh did not meet the country-level target, although the country as whole did. A minority of areas in Chad, Mozambique, Uganda, and Zambia met the country-level MDG targets while these countries as a whole did not.

Conclusions

Subnational estimates of U5MR reveal significant within-country variation. These estimates could be used for identifying high-need areas and positive deviants, tracking trends in geographic inequalities, and evaluating progress towards international development targets such as the Sustainable Development Goals.

     

Identification of cultivable microorganisms from primary endodontic infections with exposed and unexposed pulp space

This study was aimed at comparing the cultivable microorganisms in canals with periapical radiolucencies with exposed and unexposed pulp space. Microbiological samples were taken and analyzed from 45 canals with exposed pulp space, and 43 canals with unexposed pulp space. The canal contents were analyzed by aerobic/anaerobic culture, and conventional identification techniques. There were 211 isolates of bacteria belonging to 28 genera and 55 species recovered from exposed canals. In the unexposed group, 185 isolates of bacteria were recovered, of which 54 species of 28 genera were identified. Among the four most common genera, Prevotella was significantly more common in the exposed group (51/211 in the exposed group versus 30/185 in the unexposed group) (p = 0.049), while there were no differences in prevalence of Actinomyces, Peptostreptococcus, and Campylobacter between two groups of canals. In addition, Fusobacterium nucleatum and Propionibacterium acne were significantly more common in the unexposed canals (p = 0.047 and p = 0.0051, respectively). Similarity in bacterial species in these two groups suggests that pulp space exposure may not be a significant factor in determining the type of bacteria present in infected canals.     

Correlation between micro-computed tomography and histomorphometry for assessment of new bone formation in a calvarial experimental model

Conventional histologic or histomorphometric evaluation provides clear evidence of the bone healing process. However, the sample preparation process is tedious and destructive, and the three-dimensional (3D) anisotropic information of the bone trabeculae is compromised. Micro-computed tomography (microCT) has been introduced as an alternative to these traditional evaluation methods. microCT is noninvasive and provides a faster approach to evaluate and quantify cancellous bone. Most previous studies that used microCT have focused on studying trabecular structures of cancellous bone. In this study, we used microCT to analyze the micro-architecture of the regenerated membranous bone using a rabbit cranial defect model. Two 1 cm diameter circular bony defects were created in 12 New Zealand white rabbits. Specimens were harvested at 6 weeks and 12 weeks after surgery and were scanned using a MicroCT machine (Skyscan 1072, Aartselaar, Belgium). The specimens were then sectioned and stained with Goldner's trichrome. Bone volume density (BV/TV), bone surface density (BS/BV), and trabecular thickness (TbTh) were determined from histomorphometric and two-dimensional (2D) and 3D microCT analysis. Pearson's correlation coefficient (gamma), paired t-tests, and intraclass correlation coefficients from measurements between the 2D and 3D microCT and histomorphometry were calculated. There were very strong positive correlations of BV/TV between histomorphometric and 2D or 3D microCT measurements. Correlation between histomorphometric and 2D microCT measurements for BS/BV was moderate, whereas correlation between histomorphometric and 3D microCT measurements was weak. Weak correlations in TbTh among the three methods were found. In conclusion, the present study suggests that, in evaluating micro-architectures in regenerated bones, the correlation between measuring methods vary according to the features measured.     

Use of a reflectance spectrophotometer in evaluating shade change resulting from tooth-whitening products

Historically, shade change assessment associated with vital bleaching treatment regimens has been visually evaluated through the use of shade guide tabs. Innovations in the industry of dentistry have brought forth new technologies capable of measuring such changes via the capture and analysis of reflected wavelengths of light. CLINICAL SIGNIFICANCE: This article introduces the use of a 45/0 reflectance spectrophotometer and identifies the advantages and limitations associated with such a technology in the assessment of shade change owing to vital bleaching.     

Comparison of the retentive characteristics of cobalt-chromium and commercially pure titanium clasps using a novel method

This study aimed to compare the retentive forces of cast cobalt-chromium (Co-Cr) and commercially pure titanium (cpTi) clasps. A clasp assembly comprising a pair of symmetrical clasps was made to fit the opposite halves of a hardened stainless-steel sphere. This twin clasp was designed to counterbalance the tipping forces when the clasp assembly was drawn from the sphere. A total of 120 clasp assemblies were fabricated in cast Co-Cr and cpTi and placed at undercut depths of 0.25 mm, 0.50 mm, and 0.75 mm (n = 20 for each). For Co-Cr clasps, the retentive forces at these undercuts depths were 2.34 +/- 0.23 N, 4.65 +/- 0.35 N, and 7.56 +/- 0.50 N, respectively. The corresponding retentive forces for cpTi clasps were 1.24 +/- 0.13 N, 2.34 +/- 0.23 N, and 3.70 +/- 0.27 N. The retentive force of cpTi clasps was approximately half that of Co-Cr clasps for the same undercut depth.     

Effect of compounds of Galla chinensis on remineralisation of initial enamel carious lesions in vitro

OBJECTIVE: To evaluate the effect of compounds of Galla chinensis on the remineralisation of initial enamel carious lesions in vitro. METHODS: Sixty bovine enamel blocks with early lesions were prepared and randomly divided into six treatment groups. The lesions were subjected to a pH-cycling regime for 12 days. Each daily cycle included 4x1min applications with one of six treatments; 1000ppm F aq. (as NaF, positive control); deionized water (negative control); or 4000ppm aqueous solutions of four G. chinensis extracts (GCEs); GCE, GCE-B, GCE-B1, or GCE-B2. Surface enamel microhardness was measured on the enamel blocks before and after demineralisation, and after pH-cycling, and percentage surface microhardness recovery (%SMHR) was calculated. The enamel specimens were then sectioned (thickness ca. 80microm) and examined by polarized light microscopy. RESULTS: All samples rehardened significantly compared to baseline. Fluoride had a significantly greater effect than all other treatments. In the GCEs groups, %SMHR was significantly greater than DDW for the GCE, GCE-B and GCE-B1 groups. There was no significant difference between the GCE-B2 group and DDW. Polarized light microscopy showed that the thickness of the surface layer increased obviously in all specimens including NaF group, GCE group, GCE-B group and GCE-B1 group. Negative birefringent band appeared in the lesions body and the depth of the lesions was obviously reduced. CONCLUSION: The present study has demonstrated the potential of three GCEs (GCE, GCE-B and GCE-B1) to effect net rehardening of artificial carious lesions under dynamic pH-cyclic conditions.