基于响应面法优选美洲大蠊口腔原位温敏凝胶的制备研究

目的制备美洲大蠊Periplaneta americana口腔原位温敏凝胶。方法采用自由基聚合法首次以N-异丙基丙烯酰胺(NNIPAM)和甲基丙烯酸羟丙酯(HPMA)合成聚(N-异丙基丙烯酰胺-甲基丙烯酸羟丙酯)[P(NNIPAM-HPMA)]作为温敏材料;通过冷溶法制备美洲大蠊口腔原位温敏凝胶,采用Box-Behnken设计响应面法,以溶蚀时间、胶凝时间为评价指标,在固定美洲大蠊提取物用量基础上,对羟丙基甲基纤维素(HPMC)、聚乙烯吡咯烷酮(PVP K30)、P(NNIPAM-HPMA)的用量进行优选。结果通过原位聚合法合成了P(NNIPAM-HPMA)温敏材料;并用响应面法优选了可用于口腔的美洲大蠊原位温敏凝胶的处方,优选的处方为美洲大蠊提取物10%、HPMC 3.0%、PVP K30 9.5%、P(NNIPAM-HPMA) 10.0%,其溶蚀时间为2 h,胶凝时间8～9 s。结论优选得到美洲大蠊口腔原位温敏凝胶,为美洲大蠊提取物的口腔原位局部的临床应用奠定了科学依据。     

星点设计-效应面法优化丁香苦苷聚乳酸-羟基乙酸纳米粒的制备工艺

目的优化丁香苦苷聚乳酸(Syr)-羟基乙酸共聚物[poly(lactic-co-glycolic acid),PLGA]纳米粒(Syr-NPs)的处方。方法采用纳米沉淀法制备Syr-NPs,以包封率、载药量、平均粒径以及总评"归一值"为评价指标,采用星点设计-效应面法考察PLGA质量浓度(A)、丁香苦苷质量浓度(B)、水相与有机相比例(C)3因素考察对包封率、载药量、平均粒径以及总评归一值的影响,以星点设计-效应面法选取最佳处方条件进行预测分析。结果最优处方工艺为PLGA质量浓度为9.63 mg/mL,Syr质量浓度为12.88 mg/mL,有机相与水相的比例为1∶9.46,制得的Syr-NPs的包封率、载药量、平均粒径分别为(27.86±0.87)%、(7.02±0.15)%、(110.0±1.20)nm。结论该方法稳定可行,可用于优化包载Syr的PLGA纳米粒处方与制备工艺。     

Five challenges for manual therapies trials with placebo controls: A proposal

Randomised placebo-controlled trials (RCT) are implemented to determine whether a particular therapy is superior to placebo and can thus be considered effective. However, adopting the standard RCT design in contexts other than pharmacological trials, such as manual therapy, may result in systematic biases. These biases may occur due to: the impossibility of traditional “double-blinding” in manual therapy trials; insufficient pre-training of operators delivering the treatment and/or sham therapy; biased recruitment of study participants; the problematic use of subjective and/or objective outcomes; and finally, the presence of phenomena mimicking placebo effects. From the perspective of placebo studies, the purpose of this paper is to discuss and make appropriate recommendations to address these five issues in manual therapy research.     

Relationship between biological variation and delta check rules performance

ObjectivesThe performance of delta check rules has been considered to be dependent on the biological variation characteristics of the analyte of interest. The assumed relationships have not been formally studied. The mathematical relationship between biological variation and delta check rules is explored in this study.Design and methodsFrom the mathematical model for absolute difference delta check, the threshold for specificity and sensitivity are observed to be normalized differently. For specificity, the threshold is normalized by the within-subject biological variation (expressed as a coefficient of variation, ${\mathit{CV}}_i$), whereas for sensitivity the threshold is normalized by the between-subject biological variation (expressed as a coefficient of variation, ${\mathit{CV}}_g$). This highlights the different roles the two biological variations play in affecting the absolute difference distribution for correct and switched patient samples. Analogous to absolute difference delta checks, for relative difference delta checks, the expressions for specificity and sensitivity are scaled by ${\mathit{CV}}_i$ and ${\mathit{CV}}_g,$ respectively. However, the expressions are independent of ${\mu }_g$(the average of the population).ResultsA comparison between the mathematical model and empirical/ historical laboratory data obtained from patients was conducted for both absolute and relative difference delta checks. In general it was found that the specificity obtained from the historical laboratory data was less than the model predicted values, while on the other hand, good correspondence was obtained between the experimental sensitivity and predicted sensitivity.ConclusionsThe difference in within-subject biological variation in different patients may contribute to the observed discrepancy in predicted and empirical delta check performance.     

应用响应面法优化rakicidin B的提取工艺

目的 建立小单孢菌FIM02523菌液中rakicidin B组分安全有效的提取方法。方法 在单因素试验以及稳定性研究的基础上，选取三因素三水平，采用Box-Behnken响应面法优化设计确定rakicidin B组分最佳提取条件。结果与结论 对rakicidin B提取率的主要影响因素依次为提取次数、料液比和提取溶剂的体积百分比浓度。优化修正后的提取条件为：常温下(4~40℃)、pH值6~7.5、提取溶剂为90%乙醇溶液、料液比1:3(V/V)、提取时间0.5h和提取次数2次，rakicidin B总提取率达到98.58%。     

Adsorptive removal of lead from aqueous solutions by amine–functionalized magMCM-41 as a low–cost nanocomposite prepared from rice husk: Modeling and optimization by response surface methodology

Amorphous silica that was extracted from rice husk was used to synthesize the magMCM-41 mesoporous silica. This was then functionalized by the APTMS group in order to produce NH₂-magMCM-41 as a novel and low–cost adsorbent. The XRD, VSM, N₂ adsorption–desorption, FT–IR, TGA, SEM and TEM analyses were utilized to characterize the produced materials. In order to optimize the adsorption of the Pb(II) ions, the RSM (response surface methodology) was applied by using the synthesized adsorbent in aqueous solutions. A rotatable CCD (central composite design) was adopted to carry out the experiments and RSM was used to analyze them. Three independent factors namely, initial solution pH (3–7), adsorbent dosage (0.1–2 g L^?1), and initial Pb(II) concentration (15–150 mg L^?1) were used to investigate the removal procedure. According to the obtained results, the initial solution pH of 5.22, adsorbent dosage of 0.1 g L^?1, and initial Pb(II) concentration of 150 mg L^?1 were considered as the optimum conditions with 64.32% removal of Pb(II) and an adsorption capacity of 540.64 mg g^?1. The maximum removal efficiency of Pb(II) ions was found to be 96.76%. The Sips isotherm model represents a better correlation with equilibrium data. It was reported by the kinetic study that data taken from the experiments fitted better to the pseudo–second–order model compared to the pseudo–first–order and intraparticle diffusion models. Finally, according to the thermodynamic study, the removal process strongly depends on temperature, which indicates an exothermic behavior and spontaneous nature of the adsorption.