Aluminum matrix composites (AMC) are of great interest and importance as high-performance materials with enhanced mechanical properties. Al2O3 is a commonly used reinforcement in AMCs fabricated by means of various technological methods, including casting and sintering. Selective laser melting (SLM) is a suitable modern method of the fabrication of net-shape fully dense parts from AMC with alumina. The main results, achievements, and difficulties of SLM applied to AMCs with alumina are discussed in this review and compared with conventional methods. It was shown that the initial powder preparation, namely the particle size distribution, sphericity, and thorough mixing, affected the final microstructure and properties of SLMed materials drastically. The distribution of reinforcing particles tends to consolidate the near-melting pool-edges process because of pushing by the liquid–solid interface during the solidification process that is a common problem of various fabrication methods. The achievement of an homogeneous distribution was shown to be possible through both the thorough mixing of the initial powders and the precise optimization of SLM parameters. The strength of the AMCs fabricated by the SLM method was relatively low compared with materials produced by conventional methods, while for superior relative densities of more than 99%, hardness and tribological properties were obtained, making SLM a promising method for the Al-based matrix composites with Al2O3. 相似文献
The Earth’s mean surface temperature is already approximately 1.1°C higher than pre-industrial levels. Exceeding a mean 1.5°C rise by 2050 will make global adaptation to the consequences of climate change less possible. To protect public health, anaesthesia providers need to reduce the contribution their practice makes to global warming. We convened a Working Group of 45 anaesthesia providers with a recognised interest in sustainability, and used a three-stage modified Delphi consensus process to agree on principles of environmentally sustainable anaesthesia that are achievable worldwide. The Working Group agreed on the following three important underlying statements: patient safety should not be compromised by sustainable anaesthetic practices; high-, middle- and low-income countries should support each other appropriately in delivering sustainable healthcare (including anaesthesia); and healthcare systems should be mandated to reduce their contribution to global warming. We set out seven fundamental principles to guide anaesthesia providers in the move to environmentally sustainable practice, including: choice of medications and equipment; minimising waste and overuse of resources; and addressing environmental sustainability in anaesthetists’ education, research, quality improvement and local healthcare leadership activities. These changes are achievable with minimal material resource and financial investment, and should undergo re-evaluation and updates as better evidence is published. This paper discusses each principle individually, and directs readers towards further important references. 相似文献
结果:FLACS组术中CDE和EPT明显低于CPCS组(t=8.50、5.16; P<0.01、=0.001)。两组术后抗青光眼药物较术前均明显减少(t=9.12、7.76; P=0.011、0.016),但两组间无差异(t=1.79,P=0.082)。两组术后BCVA均较术前改善,眼压均较术前降低(P<0.05)。FLACS组在术后早期(1d,1wk)BCVA的改善较CPCS组更显著(t=9.74、8.49; P=0.008、0.012),但在术后1、3mo的BCVA改善程度并无不同(t=0.62、0.44; P=1.415、2.021)。CPCS组在术后随访不同时期的角膜内皮细胞损伤较FLACS组更明显(P<0.05)。术后随访的不同时期FLACS组和CPCS组在控制眼压方面无差异(F组间=0.64,P组间=0.421)。FLACS组的手术并发症发生率27%(7/26)较CPCS组89%(24/27)低(χ2=20.95,P<0.01),其中角膜水肿(8% vs 41%)、前囊撕裂(0 vs 11%)在FLACS组中明显低于CPCS组,后囊破裂(0 vs 7%)、玻璃体脱出(0 vs 4%)及人工晶状体偏位(0 vs 7%)也均发生在CPCS组。但两组的治疗总成功率相近(P=28.718)。
There is a controversy in regards to the efficacy of photobiomodulation (PBM) in the management of tinnitus. The aim was to systematically review randomized controlled trials (RCTs) that assessed the efficacy of PBM (low-level laser therapy) in the management of tinnitus. The focused question was “Is PBM effective in the management of tinnitus?”. Indexed databases were searched up to and including June 2020 using different combinations of the following key words: (a) laser; (b) diode; (c) low-level laser therapy; (d) photobiomodulation; (e) tinnitus; (f) medium-level laser; (g) photo-biomodulation; and (h) low-power laser; and RCTs performed on humans were included. Letters to the editor; case reports/series; commentaries; experimental studies and historic reviews were excluded. The risk of bias was assessed using the modified cochrane collaboration tool. The format of the current systematic review was personalized to summarize the appropriate information. Ten RCTs (2 single-blinded and 8 double-blinded) were included. One study reported 30% and 100% resolution of tinnitus using diode and Neodymium-doped Yttrium Aluminum Garnet lasers; respectively. One study reported that PBM was effective in relieving tinnitus for up to 3 months. Eight studies reported that PBM was ineffective in the management of chronic tinnitus. The risk of bias was high; medium and low in 4; 5 and 1 studies; respectively. The effectiveness of PBM in the management of tinnitus remains debatable. Further power-adjusted and well-designed RCTs with long-term follow-up are needed. 相似文献