Noise characterization of “effective quiet” areas on a U.S. Navy aircraft carrier

The purpose of this investigation was to characterize noise levels in spaces designated as “effective quiet” areas on a U.S. Navy aircraft carrier. Noise dosimetry samples were collected in 15 designated spaces, representing 15 noise measurements, while at-sea during airwing carrier qualifications. Equivalent sound level (L_eq) measurements were collected during flight operations (L_{eq (flt ops)}), non-flight operations (L_{eq (non-flt ops)}), and over 24-hr periods (L_{eq (24-hr)}). These data were compared to the 70 dBA American Conference of Governmental Industrial Hygienists (ACGIH^®) Threshold Limit Value (TLV^®) for “effective quiet” areas intended for temporary threshold shift recovery when personnel live and work in a potentially noise hazardous environment for periods greater than 24?hr. The monitored areas were selected based on personnel occupancy/use during off-duty time periods. Areas were classified by either (1) leisure areas that included mess (eating areas), gyms, lounges, an internet cafe, and the fantail social area or (2) berthing (sleeping) areas. The L_eq measurements in decibels “A” weighted (dBA) were compared to determine significant differences between L_{eq (flt ops)}, L_{eq (non-flt ops)}, and L_{eq (24-hr)} and were compared between leisure area and berthing area. Measured noise levels according to time period ranged as follows: (1) L_{eq (24-hr)}: 70.8–105.4 dBA; (2) L_{eq (flt ops)}: 70–101.2 dBA; and (3) L_{eq (non-flt ops)}: 39.4–104.6 dBA. All area measurements over the 24-hr period and during flight operations and 46.7% of the areas during the non-flight operation time period exceeded the “effective quiet” 70 dBA ACGIH TLV. Mean L_eqs were 15 dBA higher during flight operations compared to non-flight operations in “effective quiet” areas (p?=?0.001). The L_eqs in leisure areas were significantly higher than berthing areas by approximately 21 dBA during non-flight operation periods (p?=?0.001). Results suggest noise levels in “effective quiet” areas frequented by aircraft carrier personnel during off-duty hours when at-sea may inhibit auditory recovery from occupational noise exposures that occur on-duty.     

Integrating in vitro testing and physiologically-based pharmacokinetic (PBPK) modelling for chemical liver toxicity assessment—A case study of troglitazone

In vitro to in vivo extrapolation (IVIVE) for next-generation risk assessment (NGRA) of chemicals requires computational modeling and faces unique challenges. Using mitochondria-related toxicity data of troglitazone (TGZ), a prototype drug known for liver toxicity, from HepaRG, HepG2, HC-04, and primary human hepatocytes, we explored inherent uncertainties in IVIVE, including cell models, cellular response endpoints, and dose metrics. A human population physiologically-based pharmacokinetic (PBPK) model for TGZ was developed to predict in vivo doses from in vitro point-of-departure (POD) concentrations. Compared to the 200–800 mg/d dose range of TGZ where liver injury was observed clinically, the predicted POD doses for the mean and top one percentile of the PBPK population were 28–372 and 15–178 mg/d respectively based on C_max dosimetry, and 185–2552 and 83–1010 mg/d respectively based on AUC. In conclusion, although with many uncertainties, integrating in vitro assays and PBPK modeling is promising in informing liver toxicity-inducing TGZ doses.     

Interactions of small polypeptides with dimyristoylphosphatidylcholine monolayers: effect of size and hydrophobicity

The effects of size and hydrophobicity of small (molecular weights below 2,000) polypeptides on their predominantly hydrophobic interactions with a neutral phospholipid monolayer were studied. The changes in surface pressure were determined when various concentrations of Gly, Gly-Gly-Gly, -Ala, -Ala- -Ala- -Ala, -Ala-Gly-Gly-Gly-Gly, -Phe- -Leu- -Glu- -Glu- -Leu, adrenocorticotropic hormone fragments 1–10 (ACTH-(1–10)), porcine β-lipotropin, -endorphin and human fibrinopeptide A were injected under dimyristoylphosphatidylcholine (DMPC) monolayers at an initial surface pressure of 10 dyne/cm. In all cases, when peptides with the same number of residues are compared, the concentration needed to increase the surface pressure of the film by 1 dyne/cm was inversely related to its hydrophobicity. A reasonably good correlation was found to exist between the calculated free energy of transfer of a polypeptide from ethanol to water (a measure of its hydrophobicity) and its ability to increase the surface pressure of the DMPC film (a measure of the extent of its interaction with the neutral lipid monolayer).     

The growth of the second underpotentially deposited silver layer on Pt(100)

The electrodeposition of Ag on Pt(100)-(1 × 1) in perchlorate electrolyte was studied by means of time-resolved in situ scanning tunnelling microscopy (STM) and cyclic voltammetry. One monolayer of Ag is deposited underpotentially (upd) ca. 500 mV positive of the Ag⁺/Ag equilibrium potential. Several millivolts positive of the equilibrium potential, a second well defined upd layer forms. Its growth was observed to proceed via island formation and coalescence. This process occurs in two separate stages that manifest themselves in voltammetric peaks as well as in the STM images.     

Thickness effects of a carbon-supported platinum catalyst layer on the electrochemical reduction of oxygen in sulfuric acid solution

The influence of the thickness of a carbon-supported platinum catalyst layer on the oxygen reduction reaction (orr) has been studied in sulfuric acid solution by means of a thin-film rotating disk electrode. Pronounced changes in the Pt utilization, electrode activity and the orr kinetics have been observed upon varying the catalyst layer thickness. The thicker film electrode exhibits a higher Pt utilization efficiency and higher activity, and promotes the orr kinetics at potentials relevant to fuel cell operations. The participation of Pt surfaces not in contact with the electrolyte solution in electrochemical reactions via the spillover of adsorbed hydrogen and oxygen species, is proposed to be responsible for the changes. The thicker catalyst layer is likely to modify the Pt particle–particle distance by providing shared Pt sites between adjacent carbon supports, to improve the surface density of active catalyst particles per single carbon support by sharing adjacent catalyst sites, and to increase the ratio of the particle surfaces free of blocking anions to the catalyst|electrolyte interface surfaces. The carbon-supported platinum catalyst layer becomes active at 0.90 V vs RHE only when the catalyst layer is thicker than 1 μm. To provide reasonable activity, the minimum catalyst layer thickness should be around 2–4 μm. These results should be considered in the design of the cathode catalyst layer of polymer electrolyte membrane fuel cells.     

胶片剂量测量和验证方法的研究

目的设计和实现基于通用激光扫描仪的胶片剂量测量和验证系统。方法采用胶片饱和冲洗、非线性光学校正、多分辨率阈值滤波、离散傅里叶逆变换图像复原等方法,消除了普通扫描仪用于胶片剂量学定量处理中的各种伪影、噪声和畸变;采用过响应系数校正方法消除测量胶片对低能散射光子的过响应,改善了胶片剂量测量的准确性;采用γ结合NAT指标的方法对放疗计划进行二维定量验证,给出可视化图形表达和具有定量数据的验证结果。结果和三维水箱系统、VeriSoft胶片测量系统相比较,研制系统对放疗剂量的测量结果在±2%内符合一致,对IMRT放疗计划的定量验证结果在±3%内符合一致。结论该系统能够实现对放疗剂量的高精度测量和对适形调强放疗计划剂量的可靠验证。     

个体患者适形调强放疗计划模体内剂量实测验证技术的建立

目的建立个体患者适形调强放疗（IMRT）计划的模体内剂量实测验证技术。方法选择1例鼻咽癌患者，设计IMRT计划。将患者计划转移到模体上设计杂交计划。执行杂交计划时，用针点电离室测量感兴趣点的剂量，并与该点的计算剂量比较。用胶片剂量测量系统测量杂交计划中感兴趣平面的剂量，胶片与计划剂量矩阵登记后，依次进行计划，胶片分析、计划，胶片剖面分析和计划／胶片等剂量线分析。采用复合判断标准评价验证结果。结果针点电离室测量得到杂交计划单次照射的总剂量为121．5cGy，比计算值低约4％。计划，胶片分析得到高剂量、高梯度区域的距离差别均在4mm以内；计划／胶片剖面分析显示，计划与胶片在通过靶区的剖面具有较好的一致性；计划，胶片等剂量线分析显示，计划与胶片对应值的等剂量线重合良好。按照复合判断标准，该计划验证通过。结论初步建立了个体患者IMRT计划的模体内剂量实测验证技术，建立并优化了剂量登记技术、剂量归一方法和评价方法。     

Clinical considerations in the use of missing tissue compensators for head and neck cases

The irregular shape or contour of the patient’s surface in the treatment field can alter the dose distribution resulting in non-uniformity of dose in the treatment volume. Missing tissue compensators have been most commonly used to improve this non-uniformity, especially in head & neck, breast, lung and supraclavicular regions. Two or three dimensional compensators have been typically designed to make the dose uniform at a specific depth. This compensation shifts the dose distribution within the treatment volume so that some structures may be under or over compensated. This study will examine how various sites in head and neck cases are affected by compensators. We have also analyzed the uncertainty in compensated dose due to the daily variations in patient repositioning. Computer isodose plans using Cobalt-60 gamma rays and 6 and 18 MV x-rays were generated using coronal contours. Results show that the dose uniformity is improved for the treatment sites, especially for the thinner sites, like the larynx and the anterior cervical neck nodes. Finally, patient movement or positioning errors of ±1.0 cm will cause a change in dose distribution.     

A system for interactive film analysis.

An interactive, minicomputer system has been constructed for analyzing dynamic phenomena recorded on movie film in a developmental biology laboratory. The minicomputer interfaces a stop-motion, variable speed projector, a digitizing pen, and real-time graphics display equipment. An analyst uses the pen to digitize features in a film, e.g. by following a cell. A computer-generated animation portraying all data entered is superimposed on the film image and synchronized with it. Noteworthy system features include: image overlays on a large screen, data entry with the projector running, large data capacity, computer control of the projector, and convenient data entry tools.